Latitudinal variation of the topside electron temperature at different levels of solar activity

A database of electron temperature (T_e) measurements comprising of most of the available satellite measurements in the topside ionosphere is used for studying the solar activity variations of the electron temperature T_e at different latitudes, altitudes, local times and seasons. The T_e data are grouped into three levels of solar activity (low, medium, high) at four altitude ranges, for day and night, and for equinox and solstices. We find that in general T_e changes with solar activity are small and comparable in magnitude with seasonal changes but much smaller than the changes with altitude, latitude, and from day to night. In all cases, except at low altitude during daytime, T_e increases with increasing solar activity. But this increase is not linear as assumed in most empirical T_e models but requires at least a parabolic approximation. At 550 km during daytime negative as well as positive correlation is found with solar activity. Our global data base allows to quantify the latitude range and seasonal conditions for which these correlations occur. A negative correlation with solar activity is found in the invdip latitude range from 20 to 55 degrees during equinox and from 20 degrees onward during winter. In the low latitude (20 to −20 degrees invdip) F-region there is almost no change with solar activity during solstice and a positive correlation during equinox. A positive correlation is also observed during summer from 30 degrees onward.     

The geomagnetic solar flare effect identified by SIIG as an indicator of a solar flare observed by GOES satellites

This paper studies the efficiency of geomagnetic solar flare effects (gsfe) in X solar flare detection; so during the period 1999–2007 a comparison between solar flare (sf) observed by satellites of the Geostationary Operational Environmental Satellite (GOES) programme and gsfe published by the Service International des Indices Geomagnetiques (SIIG) is made.     

热试验中红外热像仪低温测量能力分析及试验验证

文章分析了红外热像仪在航天器热试验中对低温目标的测温能力不足问题,采用红外干扰消减以及分段辐射定标/分段线性函数拟合的方式,初步解决了红外热像仪在真空低温环境下对低温目标的测量受限的问题。文章的研究结果有助于改进红外热像仪在真空低温环境下的非接触温度测量工作。     

某型飞机座舱温度调节系统检测仪的研制

为满足某型飞机座舱温度调节系统原位检测的需要,结合外场实际．研制了该型飞机的座舱温度调节系统检测仪。经用户使用证明．该检测仪能够满足飞机的检测需要。     

液体火箭发动机涡轮泵用机械密封温度场及热载变形研究

基于ANSYS数值计算软件,建立了液体火箭发动机涡轮泵用机械密封的二维稳态传热模型,依靠经验公式确定了模型的对流换热系数。计算了密封环的温度场和热载变形,分析了密封端面比压、回流流量以及不同材质对密封温度场的影响规律。结果表明:密封端面最高温度发生在靠近密封环内径处,且密封端面比压越大密封环温度梯度越大;密封环热载变形呈收敛间隙,最大变形发生在动环端面的外径处,其值约为2.2μm;密封环端面最高温度随回流流量增加而减小,当回流流量从0.1~0.6 kg/s变化时,密封环端面最高温度可降低18%(从100℃降至82℃);当回流流量增大到0.3 kg/s时,继续提高对密封环端面温升的控制不再显著;采用高导热系数的摩擦副材料能够显著降低端面温升和温度梯度,提高密封工作可靠性。     

间隙平均电流检测在高频窄脉冲电解加工中的应用

提出了间隙平均电流检测法,通过电流平均值及其方差这两个参数对间隙进行检测,并给出了具体电路框图。     

舱段结构热振耦合环境下仿真分析

针对武器装备对环境适应性要求不断提高的现状,以某舱段结构为研究对象,基于高加速应力筛选试验(HASS)条件,研究了结构在温变-振动耦合环境下的失效机理。首先,结合HASS试验剖面,确定了载荷条件,建立有限元模型;其次,采用ANSYS Workbench软件分析得到结构温度场分布及应力响应,确定了结构危险位置,并对其疲劳寿命进行计算分析,为舱段结构的失效分析及HASS试验剖面的合理制定提供依据和指导。     

微波辐射特性研究概览

微波辐射特性的研究为被动微波遥感和制导等提供基础的理论、方法、实验数据和结果。系统地阐述了微波辐射特性研究的两种方法 ,重点讨论了亮度温度的各种反演方法 ,最后指出了微波辐射特性研究的其它一些值得注意的问题     

浅谈温度变化对光学镜面的影响

环境温度变化将导致光学镜内的温度分布发生变化,文章分析了光学镜内不同的温度分布对其面形造成的危害,以及对光学系统成像质量的影响,对空间光学系统光学镜温度场设计具有一定参考价值.     

多目标多光谱高温仪的研制

根据固体火箭发动机羽焰特征研制了多目标多光谱高温仪。文中介绍了多光谱测温技术及测温仪系统构成。该系统可同时测量羽焰6个目标点的温度,每个目标点均有8个工作波长,可实现对发动机试验时羽焰流场轴向和环向多目标的温度动态测量。