7一种双S形进气道流场特性殛控制的试验研究

In order to provide the line of-sight blockage of the engine face for an advanced Uninhabited Combat Air Vehicle(UCAV), a highly curved serpentine inlet is proposed and experimentally studied. Based on the static pressure distribut ion measurement along the wall, the flow separation is found at the top wall of the second S duct for the baseline inlet design, which yields a high flow distortion at the exit plane. To improve the flow uniformity, a single array of vortex generators (VGs) is employed within the inlet. In this experimental study, the effects of mass flow ratio, free stream Mach number, angle of attack and yaw on the performance of a serpentine inlet instrumented with VGs are obtained. Results indicate: (1) Compared with the baseline serpentine design without flow control the application of the VGs promotes the mixing of core flow and the low momentum flow in the boundary layer and thus prevents the flow separation. Under the design condition, the exit flow distortion (

) decreases from 11. 7% to 2.3% by using the VGs. (2) With the descent of the free stream Mach number the total pressure loss decreases. How ever, the circular total pressure distortion increases. When the angle of attack rises from - 4° to 8°, the total pressure recovery and the circular total pressure distortion both go down. In addition, with the increase of yaw the total pressure recovery is fairly constant, while the circular total pressure distortion ascends gradually. (3) When Ma₀=0.6-0.8, α= −4°-8° and β= 0°-6°, the total pressure recovery varies between 0.936 and 0.961, the circular total pressure distortion coefficient varies between 1.4% and 5.4% and the synthesis distortion coefficient has a ranges from 3.8% to 7.0%. The experimental results confirm the excellent performance of the newly designed serpentine inlet incorporating VGs.     

基于等离子体激励的圆柱绕流控制实验研究

为验证低雷诺数条件下,采用大气压等离子体流动控制技术进行圆柱绕流控制的有效性,设计了圆柱绕流实验系统,并开展了圆柱绕流实验研究.实验研究表明,在雷诺数为1.35×104和1.90×104的条件下,等离子体激励器产生的流动扰动,能够有效控制圆柱体绕流的流动分离,并显著改善分离流场,增涡、减涡效果明显.实验结果表明,大气压等离子体流动控制技术是钝体绕流流动特性控制的一种有效手段.     

圆柱绕流尾迹对壁湍流相干结构影响的实验研究

对边界层外区的圆柱尾迹流动结构对边界层近壁区相干结构的影响进行了实验研究.实验在低湍流度风洞中进行,将圆柱放置于yc≈1.1δ(δ为边界层厚度)处,利用热线风速仪分别测量了沿流向不同位置边界层内的瞬时脉动速度信号,并分别比较了位于x/d=1、2、3、4、5、10、15、20、30,y+=10~1000范围内的壁湍流相干结构条件相位平均波形及其统计特性.发现圆柱绕流尾迹对平板边界层内相干结构有明显的影响,圆柱绕流尾迹虽然使壁湍流相干结构从喷射向扫掠转变阶段的强度减弱,但壁湍流相干结构的发生概率增加,总体上促进湍流产生,使湍流边界层增厚,壁面摩擦切应力和壁面摩擦速度均增加,从而肯定了湍流边界层外层流动中产生的扰动与近壁区相干结构猝发的生成和发展有直接联系,壁湍流相干结构猝发是外区流动中产生的扰动与湍流边界层内区共同作用产生的这一结论.     

圆形隧道衬砌与围岩应力的解析法研究

隧道衬砌与围岩的应力分析是隧道设计中一个重要内容。本文基于厦门市东通道海底隧道对圆形隧道衬砌与围岩应力的封闭解析解法进行研究,首先利用MATLAB编制衬砌与围岩应力程序并选用一个已有精确解的实例进行校验,然后对圆形隧道四种工况进行计算并给出相关的衬砌和围岩的分布曲线,最后对计算结果进行了相关分析。     

Design and numerical investigation of swirl recovery vanes for the Fokker 29 propeller

Swirl recovery vanes（SRVs） are a set of stationary vanes located downstream from a propeller, which may recover some of the residual swirl from the propeller, hoping for an improvement in both thrust and efficiency. The SRV concept design for a scaled version representing the Fokker 29 propeller is performed in this paper, which may give rise to a promotion in propulsive performance of this traditional propeller. Firstly the numerical strategy is validated from two aspects of global quantities and the local flow field of the propeller compared with experimental data, and then the exit flow together with the development of propeller wake is analyzed in detail.Three kinds of SRV are designed with multiple circular airfoils. The numerical results show that the swirl behind the propeller is recovered significantly with Model V3, which is characterized by the highest solidity along spanwise, for various working conditions, and the combination of rotor and vane produced 5.76% extra thrust at the design point. However, a lower efficiency is observed asking for a better vane design and the choice of a working point. The vane position is studied which shows that there is an optimum range for higher thrust and efficiency.     

基于引文索引的航空发动机咨询通告分析方法

引入了引文索引方法对整部航空规章中所有咨询通告进行整体上的分析,提出了一种基于引文索引的航空发动机咨询通告分析方法.首先,确定某部航空规章的咨询通告为研究对象,根据咨询通告间的相互引用关系画出引文网络图;然后,在引文网络图的基础上结合评价指标的定性分析和定量分析对咨询通告进行全面的研究分析;最后,应用此方法对美国某部航空规章的咨询通告进行实例分析,同时也说明了基于引文索引的航空发动机咨询通告分析方法的可行性.     

小型无人机发展现状及其相关问题分析

就小型无人机(UAV)的发展现状及其相关问题进行了初步讨论。介绍了几种典型的小型无人机、微型飞机及一些机载设备。指出了小型无人机在空气动力、飞行力学方面存在的问题。对小型无人机的研究起到了借鉴作用。     

周期性变形圆柱绕流特征的数值分析

应用有限体积法求解不可压缩二维N-S方程，对在均匀来流中圆柱-椭圆柱周期性变形运动进行了数值模拟。对于两种典型状态，即雷诺数为40和100，本文描述了圆柱变形运动所引发的非定常流动随时间变化的过程，揭示了变形过程中柱体附近流场的变化主要取决于由壁面压力梯度和壁面的切向运动加速度所产生的壁面涡量流，分析了不同变形频率和不同变形量对升力和阻力、旋涡形成及其运动的影响，并发现了频率锁定现象。     

小型无人直升机稳定杆建模与姿态系统设计

x对某小型无人直升机的稳定杆单独进行了建模,并着重分析了稳定杆在整个飞行控制系统中所起的作用以及它对姿态系统的影响。针对稳定杆所引起的姿态系统动态响应的峰值和弱阻尼,采取在控制策略中加入陷波器的方法进行补偿。仿真结果表明：陷波器消除了稳定杆所引起的峰值,提高了姿态系统的动态阻尼,姿态系统的性能得到了明显的优化,最后实现了姿态系统的自行稳定和按设定值变化,为小型无人直升机的姿态系统设计提供了工程设计方法。     

基于2×2 MIMO的星地双圆极化通信系统验证

卫星通信因通信距离远、覆盖面积大、机动灵活等优势,广泛应用在抗震救灾、广播电视与移动通信中。然而,卫星通信因长距离通信和环境对信号的阻塞等问题,导致通信质量下降。为提高卫星通信质量,可以增加地面站发射功率或者采用分集技术。由于电磁波具备极化特性,左旋圆极化电磁波与右旋圆极化电磁波相互正交,利用其正交特性可实现长距离通信中传输路径相互独立,可以应用于星地MIMO通信中。主要研究双圆极化分集2×2 MIMO相关内容,对开阔环境和城市环境的信道参数进行研究,建立了窄带卫星双圆极化卫星2×2 MIMO信道模型,设计了一套具备在地面模拟双圆极化卫星和个人移动终端收发系统,并在该系统上验证双圆极化分集2×2 MIMO,相比于SISO获得的信噪比改善。