基于热电偶反串的温升效率测量不确定度分析

针对轴流压气机气动性能试验中存在的低压比温升效率评估问题,构建了常规测温方法与反串测温方法测量的温升效率不确定度数学分析模型,并采用某单级压气机真实试验数据进行了两种测温方法不确定度的对比分析。结果表明：相比常规测温方法,反串测温方法不仅消除了热电偶冷端环境温度测量引入的不确定度,还大幅降低了进口温度测量引入的不确定度,使温升效率测量不确定度减小幅度在30%以上。     

Latitudinal variation of the topside electron temperature at different levels of solar activity

A database of electron temperature (T_e) measurements comprising of most of the available satellite measurements in the topside ionosphere is used for studying the solar activity variations of the electron temperature T_e at different latitudes, altitudes, local times and seasons. The T_e data are grouped into three levels of solar activity (low, medium, high) at four altitude ranges, for day and night, and for equinox and solstices. We find that in general T_e changes with solar activity are small and comparable in magnitude with seasonal changes but much smaller than the changes with altitude, latitude, and from day to night. In all cases, except at low altitude during daytime, T_e increases with increasing solar activity. But this increase is not linear as assumed in most empirical T_e models but requires at least a parabolic approximation. At 550 km during daytime negative as well as positive correlation is found with solar activity. Our global data base allows to quantify the latitude range and seasonal conditions for which these correlations occur. A negative correlation with solar activity is found in the invdip latitude range from 20 to 55 degrees during equinox and from 20 degrees onward during winter. In the low latitude (20 to −20 degrees invdip) F-region there is almost no change with solar activity during solstice and a positive correlation during equinox. A positive correlation is also observed during summer from 30 degrees onward.     

液体火箭发动机涡轮泵用机械密封温度场及热载变形研究

基于ANSYS数值计算软件,建立了液体火箭发动机涡轮泵用机械密封的二维稳态传热模型,依靠经验公式确定了模型的对流换热系数。计算了密封环的温度场和热载变形,分析了密封端面比压、回流流量以及不同材质对密封温度场的影响规律。结果表明:密封端面最高温度发生在靠近密封环内径处,且密封端面比压越大密封环温度梯度越大;密封环热载变形呈收敛间隙,最大变形发生在动环端面的外径处,其值约为2.2μm;密封环端面最高温度随回流流量增加而减小,当回流流量从0.1~0.6 kg/s变化时,密封环端面最高温度可降低18%(从100℃降至82℃);当回流流量增大到0.3 kg/s时,继续提高对密封环端面温升的控制不再显著;采用高导热系数的摩擦副材料能够显著降低端面温升和温度梯度,提高密封工作可靠性。     

带集中热源的散热器温度场的数值分析

随着大规模集成电路的发展,电子设备的封装体积越来越小,功率却越来越大,这就使电子设备的温度日益增高,而电子设备的可靠性又与温度密切相关,良好的散热是电子设备应用中重要的一环.本文以通用的矩形翅片式散热器来对比带集中热源和带平均热源的散热器的温度差异,提出以嵌入热管的方法来解决带集中热源散热器的散热难题,并运用IcEPEK软件对其可行性进行了验证.     

低压断路器灭弧室温度检测

设计了基于光纤光栅传感系统的低压断路器灭弧室温度检测装置,实验测量出灭弧室温度数据,进行了数据的有限元分析,绘制出灭弧室内温度场分布图.     

金属间化合物TiAl(W,Si)合金的蠕变行为和机制

 研究了 Ti-47Al-2 W-0.5 Si合金在 650～ 750℃区间的蠕变行为和变形机制。结果表明,合金 650℃蠕变寿命与施加应力之间符合线性的双对数关系,可用表达式 lg^t_f=10 lg^R+30来描述。蠕变寿命与最小蠕变速率之间满足 Monkman-Grant关系的修正式。合金的比蠕变强度与抗热腐蚀镍基高温合金 K438G相当。在700℃变载荷下蠕变时具有与恒载荷下蠕变相类似的特征。 800℃长期时效粗化合金组织,降低蠕变寿命。位错滑移和形变孪生是合金蠕变的主要变形机制。     

新型活动密封件的研究与应用

根据飞机液压系统橡胶密封圈使用中易出现老化,引起串油、串气等故障问题,结合某机型试验提出新材料密封圈改进方案,以满足系统的高温及动密封性使用要求。试验结果表明,新材料密封圈适合高温、动密封部位的使用,可以替代丁腈试5171橡胶密封圈,应用于液压系统,提高系统性能。     

温度传感器辐射修正校准的准确牲研究

为了确定温度传感器辐射修正校准的准确性，需要对温度传感器辐射修正校准结果进行对比及不确定度分析。本文介绍了在热校准风洞中进行温度传感器辐射修正校准的结果，并做了对比研究和不确定度分析。     

Semi-analytic Solution of Steady Temperature Fields During Thin Plate Welding

Usually, it is very difficult to find out an analytical solution to thermal conduction problems during high temperature welding. Therefore, as an important numerical approach, the method of lines （MOLs） is introduced to solve the temperature field characterized by high gradients. The basic idea of the method is to semi-discretize the governing equation of the problem into a system of ordinary differential equations （ODEs） defined on discrete lines by means of the finite difference method, by which the thermal boundary condition with high gradients are directly embodied in formulation. Thus the temperature field can be obtained by solving the ODEs. As a numerical example, the variation of an axisymmetrical temperature field along the plate thickness can be obtained.     

我国航空材料的腐蚀与防护现状与展望

评述了我国航空材料腐蚀与防护技术的现状,主要介绍了我国在自然环境试验、户内加速试验、腐蚀机理和测试、高温防护涂层以及表面处理和防护技术,展望了我国航空材料腐蚀与防护技术的发展趋势及应用前景.