Study of aerodynamic and inertial forces of a experimental and numerical methods

The force-generation mechanism of a dovelike flapping-wing micro air vehicle was studied by numerical simulation and experiment. To obtain the real deformation pattern of the flapping wing, the digital image correlation technology was used to measure the dynamic deformation of the wing. The dynamic deformation data were subsequently interpolated and embedded into the CFD solver to account for the aeroelastic effects. The dynamic deformation data were further used to calculate the inertial forces...     

A novel adaptive lateral reentry guidance algorithm with complex distributed no-fly zones constraints

Aimed at complex distributed no-fly zones avoidance problems, a novel adaptive lateral reentry guidance algorithm is proposed. Firstly, by introducing the improved attractive and repulsive potential fields, an improved artificial potential field method is developed. Combined with the proposed judgment criterion for whether a no-fly zone has been avoided, the proposed improved artificial potential field method effectively solves the reference heading angle determination problem under the constrai...     

Autonomous mission reconstruction during the ascending flight of launch vehicles under typical propulsion system failures

In recent years, Chinese Long March(LM) launchers have experienced several launch failures, most of which occurred in their propulsion systems, and this paper studies Autonomous Mission Reconstruction(AMRC) technology to alleviate losses due to these failures. The status of the techniques related to AMRC, including trajectory and mission planning, guidance methods,and fault tolerant technologies, are reviewed, and their features are compared, which reflect the challenges faced by AMRC technology...     

“田园一号”微推进系统设计与性能测试

针对“田园一号”微纳星编队飞行任务的技术需求，开展了微推进系统的总体设计。常规冷气推进由于其比冲低、贮存压力高、结构复杂，难以满足微纳卫星需求。选择R134a作为推进工质，通过将推进剂液化，减小系统体积。基于3D打印技术，设计贮箱、稳压罐、管路一体的推进系统。采用MEMS加工工艺，设计并研制出电加热喷口，从而提高系统比冲。分析了不同喷口尺寸、供气压力以及温度下所产生的推力和比冲大小，确定出喷口设计。表征测试所研制的电加热喷口，结果表明喷口加工误差控制在2%以内。真空条件下，采用扭摆测量系统测试推力器推进性能，测试结果表明，当稳压罐内气体压力在0.1～0.2 MPa变化时，推力大小为5～10 mN。当喷气温度从25℃升至95℃时，推进系统比冲可提升10%以上。