A novel approach for predicting inlet pressure of aircraft hydraulic pumps under transient conditions

Cavitation caused by insufficient suction is a major factor that influences the life of aircraft pumps. Currently, pressurizing the tank can solve the cavitation problem under steady large-flow conditions. However, this method is not always effective under transient conditions (from zero flow to full flow in a very short time). Moreover, to apply and design other measures, such as a boost impeller, the suction dynamics during the transient period must be investigated. In this paper, a novel approach based on the pressure wave propagation theory is proposed for predicting the inlet pressure of an aircraft pump under transient conditions. First, a dynamic model of a typical aircraft pump is established in the form of differential equations. Then, the transient flow model of the inlet line is described using momentum and continuity equations, and the governing equations are discretized by the method of characteristics and the finite difference method. The simulated results are in good agreement with the results from verification tests. Further simulation analysis indicates that the wave velocity and transient time may influence the inlet and reservoir pressure as well as the size of the inlet line. Finally, solutions for upgrading the inlet pressure are discussed. These solutions provide guidelines for designing inlet installations.     

飞行中大气瞬时温度的获取

根据＊＊飞机上，ＣＷ－１００２和Ⅱ－５的试飞结果，对两种产品的性能做了对比分析；对飞行中大气温度的获取方法提出了的新意见。     

飞机碱性电瓶最佳充电方式研究及其实现

应用电瓶最佳受电原理，对常用飞机碱性电瓶的充电方式进行了分析和比较，提出了脉冲恒流二阶段充电法是电瓶的最佳充电方法之一的设想，其可行性已被试验证实。利用该充电方法，研制成了飞机碱性电瓶专用充电器．实验结果表明该充电方法能大大提高电瓶的充电效率，延长电瓶的使用寿命。     

A theoretical model of semi-elliptic surface crack growth

A theoretical model of semi-elliptic surface crack growth based on the low cycle strain damage accumulation near the crack tip along the cracking direction and the Newman–Raju formula is developed. The crack is regarded as a sharp notch with a small curvature radius and the process zone is assumed to be the size of cyclic plastic zone. The modified Hutchinson, Rice and Rosengren(HRR) formulations are used in the presented study. Assuming that the shape of surface crack front is controlled by two critical points: the deepest point and the surface point.The theoretical model is applied to semi-elliptic surface cracked Al 7075-T6 alloy plate under cyclic loading, and five different initial crack shapes are discussed in present study. Good agreement between experimental and theoretical results is obtained.     

微小推力下小卫星的轨道递推与推力标定

针对采用微小推力进行轨道机动的小卫星,考虑复杂摄动力的基础设计了一种高精度轨道外推和推力在轨标定算法.首先,建立了考虑地球复杂摄动力和微小推力的小卫星轨道动力学模型;然后基于动力学模型,利用变步长龙格库塔算法,设计了对微小推力小卫星进行高精度轨道外推的方法.随后通过无迹卡尔曼滤波器(UKF),设计在轨标定算法,对存在误...     

Evaluation of the IRI model for the European region

The aim of this paper is to investigate various aspects of the International Reference Ionosphere (IRI) performance in European area and to evaluate its accuracy and efficiency for: long term prediction of the critical frequencies foF2 and the maximum usable frequencies (MUF); using storm-time correction option (ST); the total electron content (TEC) and the maximum observable frequency (MOF) updating. Data of foF2, TEC, MOF are related to 2005. It is obtained that median values of foF2 can be predicted with the mean error σ(med)∼ 0.49 MHz. For median values of MUF absolute σ was 1.39 MHz and relative σ_r was 8.8%. For instanteneous values estimates are increased to 1.58σ(med) MHz for foF2 and could reach 3.84 MHz for MUF. Using correction ST-option and TEC values provided ∼30% improvement but TEC seems to be more preferable. However, from considered parameters of the IRI updating (ST-factor, TEC, MOF) the best results were demonstrated by MOF. Using the IRI2007 to calculate TEC gives 20–50% improvement of TEC correspondence to experimental values but this improvement is not enough to treat TEC without the IRI model adaptation.     

正电子素络合形成研究(Ⅱ)

本文讨论了不同测量条件对正电子素络合反应速度常数测定值的影响。实验结果表明,在稀溶液的条件下,使用我们特殊设计的盛装溶液的匣式容器能大大提高放射源的使用率并能完全避免放射性废水。     

A combined turbulent combustion model in studying a lean flameout process

A modification of the Zimont turbulent combustion model is presented; the modification makes it possible to describe processes in diffusion and homogeneous flame fronts as well as to take into account the influence of different factors that cause flame destabilization. The model is based on the equation for a reaction completeness extent (completeness of combustion). The model realization to simulate the premixed combustion is described and the modification of the turbulent combustion model is applied to simulate a process of flameout downstream of the flameholder.     

基于杂波对消-自聚焦的多通道SAR-GMTI

对超高频(UHF)波段多通道合成孔径雷达(SAR)动目标检测技术进行研究,解决了长相干积累时间导致动目标在方位向散焦严重的问题。采用分块自聚焦技术对多通道SAR地面移动目标指示(GMTI)系统自适应杂波抑制后的SAR图像进行处理,改善杂波抑制后的SAR图像中动目标的聚焦情况,增强动目标与周围剩余杂波的对比度,进而提高恒虚警率(CFAR)检测的性能。与传统杂波抑制后直接进行CFAR检测方法相比较,该方法降低了检测虚警概率。实测数据处理结果显示动目标的信杂比明显提高,动目标方位向聚焦成功,证明了该方法的有效性。     

RTS-20A便携式低温恒温槽

介绍了一种便携式低温恒温槽的工作原理及组成结构，并给出了试验数据。