Height of shock formation in the solar corona inferred from observations of type II radio bursts and coronal mass ejections

Employing coronagraphic and EUV observations close to the solar surface made by the Solar Terrestrial Relations Observatory (STEREO) mission, we determined the heliocentric distance of coronal mass ejections (CMEs) at the starting time of associated metric type II bursts. We used the wave diameter and leading edge methods and measured the CME heights for a set of 32 metric type II bursts from solar cycle 24. We minimized the projection effects by making the measurements from a view that is roughly orthogonal to the direction of the ejection. We also chose image frames close to the onset times of the type II bursts, so no extrapolation was necessary. We found that the CMEs were located in the heliocentric distance range from 1.20 to 1.93 solar radii (Rs), with mean and median values of 1.43 and 1.38 Rs, respectively. We conclusively find that the shock formation can occur at heights substantially below 1.5 Rs. In a few cases, the CME height at type II onset was close to 2 Rs. In these cases, the starting frequency of the type II bursts was very low, in the range 25–40 MHz, which confirms that the shock can also form at larger heights. The starting frequencies of metric type II bursts have a weak correlation with the measured CME/shock heights and are consistent with the rapid decline of density with height in the inner corona.     

基于自适应滑模的变质心再入飞行器控制律设计

建立了有纵向单滑块的变质心再入飞行器系统控制模型。对该有输入非线性的快时变多体系统,考虑系统存在参数不确定等因素的影响并将完整的活动质量体动力学环节置入姿态控制,基于滑模控制理论设计了俯仰姿态跟踪鲁棒控制系统。在参数不确定性条件下对飞行控制系统进行了仿真。结果表明：设计的控制律可实现对指令角度和指令位置有效、快速、稳定...     

来流条件对热流组分扩散项影响效应分析

使用数值模拟的方法研究了高超声速热化学非平衡流动中不同来流条件对热流组分扩散项的影响。以RAM-CII飞行试验外形为例,使用AUSM+-up格式耦合LU-SGS方法求解带化学反应源项的多组分NS方程。得到如下结论:在非平衡热环境数值模拟研究中,完全催化壁时组分扩散项热流所占比率表征了壁面催化效应的强弱;在同一高度下,随着马赫数升高热流组分扩散项比例越来越显著,而马赫数相同时,随着高度增高热流组分扩散项所占比例越来越小,主要原因在于当地化学反应进行程度不同。     

全流量补燃循环发动机系统参数模型与设计(Ⅱ)参数设计

在全流量补燃循环发动机系统动力平衡模型的基础上,研究了氢发汗冷却流量、燃烧室压力和燃烧室混合比对发动机系统参数的影响规律.研究结果表明:在发动机推力和喷管扩张比保持恒定时,①随着氢发汗冷却流量的增加,燃料泵扬程大幅度增大,氧化剂泵扬程小幅度减小;②当燃烧室压力在20MPa之前,泵的扬程增加与燃烧室压力的增加近似成线性;...     

CubeSail: A low cost CubeSat based solar sail demonstration mission

CubeSail is a nano-solar sail mission based on the 3U CubeSat standard, which is currently being designed and built at the Surrey Space Centre, University of Surrey. CubeSail will have a total mass of around 3 kg and will deploy a 5 × 5 m sail in low Earth orbit. The primary aim of the mission is to demonstrate the concept of solar sailing and end-of-life de-orbiting using the sail membrane as a drag-sail. The spacecraft will have a compact 3-axis stabilised attitude control system, which uses three magnetic torquers aligned with the spacecraft principle axis as well as a novel two-dimensional translation stage separating the spacecraft bus from the sail. CubeSail’s deployment mechanism consists of four novel booms and four-quadrant sail membranes. The proposed booms are made from tape-spring blades and will deploy the sail membrane from a 2U CubeSat standard structure. This paper presents a systems level overview of the CubeSat mission, focusing on the mission orbit and de-orbiting, in addition to the deployment, attitude control and the satellite bus.     

不同气体对涡流管能量分离效果的影响

通过实验的方法,分别对以空气、氮气、氩气和二氧化碳等气体为工质的涡流管的能量分离效应进行了研究,得出了涡流管的冷热效应、制冷量、单位制冷量和COP(性能系数,CoefficientofPerformance)随冷流率变化的特性曲线.研究表明:涡流管的冷热效应与工质的摩尔质量有着重要的关系,摩尔质量越大,其制冷和制热性能就越好;另外,在一定程度上还受气体本身的焦耳-汤姆逊系数的影响.对于制冷量和COP,除了跟工质的制冷效应和比热容有关外,跟摩尔质量也存在着相应的正比关系.      

无损检测技术在姿控发动机总装中的应用探析

阐述了目视检测、射线照相检测、泄漏检测等三种无损检测技术在姿控发动机上的应用情况。重点介绍了泄漏检测技术,针对发动机的结构特点、不同系统的性能要求及总装接头连接处各种密封形式在装配测试中分别采用了浸泡法、皂泡法及氦质谱简易包封积累法等不同的泄漏检测技术。经过对几种泄漏检测方法的对比分析,得出了针对不同的系统性能要求。需要采用不同的泄漏检测方法来满足设计要求的结论。     

前后翼型装药结构SRM气固两相流动特性

基于可压缩流动强守恒型Navier-Stokes方程,运用颗粒轨道模型(PTM)和shear stress transfer(SST)k-ω湍流模型,采用计算单元内颗粒源法(PSIC)进行气固两相耦合计算,建立了某型前后翼型装药结构固体火箭发动机(SRM)工作初期的三维两相内流场数值计算模型.对比分析了纯气相和气固两相...     

质心位置对超空泡射弹尾拍运动影响分析

基于均质平衡流理论,通过求解混合介质的RANS(Reynolds-Averaged Navier-Stokes equations)方程、SST(Shear Stress Transport)湍流方程和不同介质之间的质量输运方程,结合刚体运动方程和网格变形方法,研究了不同质心位置的超空泡射弹尾拍运动特性以及尾拍运动下超空泡形态特性,对比分析了不同质心位置的超空泡射弹尾拍运动的刚体运动和尾拍力的变化特征.结果表明,射弹尾拍运动对空泡形态的对称性有较大影响,发生碰撞处的空泡壁面朝着弹体转动的方向发展;射弹尾拍运动的转动角度、角速度、角加速度以及尾拍阻力和尾拍升力等都表现出周期性变化规律,且随着质心与射弹头部距离的增加,转动惯量增大,变化周期也增大.     

"海洋一号"卫星的检漏技术

文章介绍了"海洋一号"卫星检漏所采用的两种方法,特别指出采用加压真空检漏方法更能真实地测得卫星的实际漏率,并可提高工作效率.