高压不稳定环境中的燃料液滴蒸发

对燃料液滴在高压不稳定环境中的蒸发进行了研究，着重讨论了气相介质压力振荡对液滴蒸发特性的影响，计算了Ｃ１２Ｈ２６液滴在Ｎ２介质中蒸发时的蒸发速率、滴温和无因次滴径随时间的变化。结果表明：（１）蒸发速率、滴温发生相同频率的振荡，相位滞后分别为π和π／２；（２）压力振荡使蒸发速率平均值增大，液滴生存时间减少；（３）在不定常加热阶段压力振荡影响很小。     

The characteristics of sharp (small-scale) boundaries of solar wind plasma and magnetic field structures

We investigate properties of large (>20%) and sharp (<10 min) solar wind ion flux changes using INTERBALL-1 and WIND plasma and magnetic field measurements from 1996 to 1999. These ion flux changes are the boundaries of small-scale and middle-scale solar wind structures. We describe the behavior of the solar wind velocity, temperature and interplanetary magnetic field (IMF) during these sudden flux changes. Many of the largest ion flux changes occur during periods when the solar wind velocity is nearly constant, so these are mainly plasma density changes. The IMF magnitude and direction changes at these events can be either large or small. For about 55% of the ion flux changes, the sum of the thermal and magnetic pressure are in balance across the boundary. In many of the other cases, the thermal pressure change is significantly more than the magnetic pressure change. We also attempted to classify the types of discontinuities observed.     

Principal components in the PG-X-ray QSO sample

We have performed a spectral principal component analysis for a complete sample of 22 low redshift QSOs with spectra from Ly to H, and found three significant principal components, which account for 78% of the spectrum-to-spectrum variance. We present strong arguments that the first principal component represents the Baldwin effect, relating equivalent widths to the luminosity (i.e. accretion rate). The second component represents continuum variations, probably dominated by intrinsic reddening. The third principal component is directly related to broad emission-line width and X-ray spectral index, and therefore probably driven by Eddington accretion ratio, L/L_Edd. The third set of relationships tie directly to the optical Principal Component 1 found by Boroson and Green [Boroson, T., Green, R.F., Astrophys. J. Suppl. 80, 109, 1992 (BG92)], and are the primary cause of scatter in the Baldwin relationships.     

基于微型涡喷发动机热喷流的无源流体推力矢量喷管的控制规律

流体推力矢量喷管型面固定、活动部件少、结构重量轻，能够为高机动飞行器提供有效的飞行控制手段，但无源流体推力矢量喷管热喷流的偏转控制规律尚未完全掌握。为了推进无源流体推力矢量技术的实用化，本文设计研制了适用于微型涡喷发动机的耐高温喷管模型，对该喷管在微型涡喷发动机热喷流状态下的控制规律进行研究。利用非接触光学显示和测量手段——红外热成像拍摄和粒子图像测速（PIV）技术对主射流流动特性进行研究，获得流动矢量角随二次流控制阀门闭合度变化的控制规律；利用六分量盒式天平测力实验研究无源流体推力矢量喷管的力学特性，获得推力矢量角随二次流控制阀门闭合度变化的控制规律。研究结果表明：该构型喷管在微型涡喷发动机热喷流下主射流连续可控偏转，最大流动矢量角为-12.3°/12.3°，最大推力矢量角为-12.9°/12.8°，控制规律接近线性，不存在主射流偏转突跳问题。     

绳索断裂对二维二次太阳翼展开过程影响分析

为识别二维二次太阳翼关键环节和预示其在轨展开故障模式，开展不同位置绳索断裂失效对太阳翼展开的影响程度分析。采用考虑绳索断裂的绳索联动轮力学模型，建立了适应于不同联动轮半径的联动轮受力模型，提出角度触发约束消除方法，解决了太阳翼第2次展开过程连续仿真问题，建立了太阳翼第2次展开动力学方程，分析了不同位置绳索断裂失效对太阳翼各板展开角度、展开构型和其他绳索张力的影响。分析表明，越靠近星体的绳索联动机构失效对太阳翼展开过程的影响越大，其中连接架上绳索联动机构失效可直接导致二维二次太阳翼在轨展开失败。     

Effects of Mach numbers on Magnus induced surface pressure

Experimental and numerical methods were used to investigate the Magnus phenomena over a spinning projectile. The pressure force acting on the surface of a spinning projectile was measured for various cases by employing a relatively novel experimental technique. A set of miniature pressure sensors along with a data acquisition board, battery and storage memory were placed inside a spinning model and the surface pressure were obtained through a remotely controlled system. Circumferential pressures of the model for both rotational and static conditions were obtained at two different free stream Mach numbers of 0.4 and 0.8 and at different angles of attack. The results showed the ability of this new test method to measure the very small Magnus force via surface pressures over the projectile. The results provide a deep insight into the flow structure and illustrate changes in the cross-flow separation locations as a result of rotation. Similar results were obtained by the numerical simulations and were compared with the experimental data.     

均匀各向同性大气湍流对声爆传播特性的影响

基于离散Fourier模态有限和生成的随机大气湍流场，采用修正波形参数方法，开展了均匀各向同性大气湍流对典型超声速客机声爆传播特性的影响分析。计算采用的超声速客机模型为自行生成的简化超声速公务机模型。首先，应用航空工业空气动力研究院自主研制的CFD软件ARI_Overset在三维空间求解Navier-Stokes方程，得到作为声爆远场传播初始值的近场空间压力分布；其次，基于Von Karman能量谱，采用离散Fourier模态有限和形式生成随机均匀各向同性大气湍流场；最后，采用修正波形参数方法模拟了声爆信号在随机速度湍流场中的传播过程。数值结果表明：各向同性大气湍流对于地面声爆特征有重要影响。与无湍流状态相比，均匀各向同性大气湍流使得地面声爆特征增强的概率约为55%，使得地面声爆特征减弱的概率约为45%，故总体而言大气湍流效应更倾向于增强地面声爆特征；均匀各向同性大气湍流对于声爆传播路径影响相对较小，但是这一变化仍会导致地面信号接收点的不确定性。     

热力学排气系统中节流效应及其冷量利用分析

为更好地理解热力学排气系统(TVS)的运行机理，优化其运行参数，针对节流装置，建立了热力学模型，讨论了节流过程中状态参数的变化规律，对比了单相气体、单相液体节流的性能特性，进一步揭示了焦汤节流效应的原理，分析了不同节流背压下节流前低温工质(液氢和液氧)压力和温度对节流性能的影响，并结合TVS实际应用，阐述了节流最大制冷量的利用效果，提出了优化的TVS工作区间。研究表明：在节流过程不发生相变情况下单相气体节流制冷效应要比单相液体节流制冷效应更加显著；而在节流过程发生相变情况下液体节流至两相后，由于空化吸热导致流体温度降低，对于液氢，0.5MPa的压降可产生接近3 K的温降。对于液体节流，节流前压力对节流过程影响可忽略，〖JP2〗而节流前温度和节流背压对节流过程起主导作用；对于液氢在在轨运行工况下，考虑到节流制冷量的充分利用，同时保证换热过程体积含气率不高于90%，推荐TVS系统中节流背压范围为75～143 kPa。     

热处理对FeCo-2V-0.5Cr软磁合金力学与磁学性能的影响

针对FeCo-2V-0.5Cr软磁合金,研究了真空热处理时间对其微观组织结构、力学与磁学性能的影响规律,发现在800℃下热处理时间为2h左右时,合金的抗拉强度和延伸率达到最佳,同时仍保持良好的软磁性能,抗拉强度、延伸率以及矫顽力分别为867.8MPa、10.4%以及2.0Oe。进一步对该合金进行附加磁场下的真空热处理,重点研究了合金的交流损耗与矫顽力随附加磁场方式包括磁场撤除温度与磁场下保温时间的变化规律,发现适当的磁场热处理对合金相关力学性能影响不大,但由于合金中产生了单轴各向异性而使合金矫顽力进一步降至1.6Oe。     

Aerodynamics of smart flap under ground effect

Aerodynamic characteristics of two-dimensional smart flap under the ground effect have been assessed by a numerical simulation. In this process, a pressure-based implicit procedure to solve Navier–Stokes equations on a nonorthogonal mesh with collocated finite volume formulation is used. The boundedness criteria for this procedure are determined from the Normalized Variable Diagram (NVD) scheme. The procedure incorporates the k–ε eddy–viscosity turbulence model. Cantilever beam with uniformly varying load with roller support at the free end is considered for the configuration of the smart flap. The method is first validated against experimental data. Then, the algorithm is applied for turbulent aerodynamic flows around airfoil with smart and conventional flaps for different attack angle, flap angle and ground clearance where the results of two flaps are compared. The comparisons show that the quality of the solution is considerable.