前机身对飞机大迎角气动特性的影响

通过对一些相关文献的分析，得出了前机身外形是要求具有过失速机动能力的飞机气动设计的关键这一结论，并建议在气动布局工作中加强对前机身特性研究。     

光纤光栅温度传感器研究进展

归纳了以光纤光栅为基础的温度传感器的研究现状,总结了这些温度传感器的基本原理,再现了它们的主要结构,展示了原文提到的实验过程和数据分析结果,并对这些传感器的优点和不足进行了分析,提出了部分改进方案。通过研究发现：光纤光栅温度传感器具有优良的特性,能够在恶劣环境下测量极高的温度,具有广阔的应用前景。     

Azimuth selection for sea level measurements using geodetic GPS receivers

Based on analysis of Global Positioning System (GPS) multipath signals recorded by a geodetic GPS receiver, GPS Reflectometry (GPS-R) has demonstrated unique advantages in relation to sea level monitoring. Founded on multipath reflectometry theory, sea level changes can be measured by GPS-R through spectral analysis of recorded signal-to-noise ratio data. However, prior to estimating multipath parameters, it is necessary to define azimuth and elevation angle mask to ensure the reflecting zones are on water. Here, a method is presented to address azimuth selection, a topic currently under active development in the field of GPS-R. Data from three test sites: the Kachemak Bay GPS site PBAY in Alaska (USA), Friday Harbor GPS site SC02 in the San Juan Islands (USA), and Brest Harbor GPS site BRST in Brest (France) are analyzed. These sites are located in different multipath environments, from a rural coastal area to a busy harbor, and they experience different tidal ranges. Estimates by the GPS tide gauges at azimuths selected by the presented method are compared with measurements from physical tide gauges and acceptable correspondence found for all three sites.     

A novel environmental control system based on membrane dehumidification

This paper conducts a simulation study of a novel aircraft environmental control system based on membrane dehumidification(MD-ECS),and compares the system with the up-to-date four-wheel high pressure de-water system(4WHPDW-ECS).Mathematical models for the two systems are established,and a system simulation using a numerical technique is performed to analyze and compare the cooling performance of the two systems.Simulation results show that the cooling capacity of MD-ECS is much higher than that of 4WHPDW-ECS under the same working conditions,indicating that the novel system is theoretically feasible and promising.The effects of the sweep ratio of the membrane dehumidifier on the dehumidification and cooling performance of the system is also investigated.     

钛合金蜂窝三层结构的扩散焊接研究

介绍了俄罗斯钛合金蜂窝三层结构扩散焊接的研究成果.详细介绍了铝合金、焊接规范选择、接头应力变形状态的分析、模拟计算等,有助于国内钛合金的焊接研究.     

小展弦比飞翼亚、跨、超声速支撑干扰研究

通过数值模拟方法研究了小展弦比飞翼标模在0.6、0.9、1.5三个典型马赫数下的支撑干扰特性,分别考虑了近场尾部外形局部畸变和尾支杆干扰及远场风洞中部支架干扰,并基于表面压力系数差异为准则尝试对近场干扰量进行分解。研究得到如下结论:马赫数0.6时,远场支撑阻力系数和俯仰力矩系数的干扰量约占总支撑干扰量的30%,升力系数约占20%;马赫数0.9、迎角2°时,阻力系数远场支撑干扰量占总支撑干扰量的40%,迎角18°时,远场支撑干扰使得涡破裂位置提前;马赫数1.5时,远场支撑干扰可以忽略;基于表面压力系数差异将支撑干扰量分解的方法在亚声速支撑干扰前传明显时不适用,在马赫数0.9、迎角2°时求得近场支撑干扰使得马赫数减小约0.02,迎角减小约0.1°,马赫数1.5时用此法求得马赫数和迎角的干扰量均约等于0。     

基于变速积分的高速电机磁悬浮控制系统设计

针对磁悬浮高速电机的磁轴承-转子系统,设计了基于MCU+FPGA的数字控制系统。为实现转子系统的高转速下稳定控制,在建立了磁轴承-转子闭环控制系统模型的基础上,针对常规PID控制系统的超调振荡问题和PD控制系统的转子位移静差问题,利用变速积分的思想设计了改进的PID控制器。实验表明,在消除了系统静差的同时明显减小了系统的超调量和调节时间,说明设计的控制系统具有很好的动态特性和稳态精度。     

一种负极性直流高压线性电源设计

本文提出了一种基于光耦反馈调整的负极性高压线性电源解决方案，使用NPN型三极管作为功率调整管的前提下，实现了负1200V直流电压输出。本文对提出的电源方案建立了小信号传递函数模型，在传递函数模型的基础上论证了所提出的电源系统具有稳定性高、噪声低等优点。     

不锈钢、钛合金导管高频钎焊工艺方法的改进

高频钎焊焊接方法在国内外进行研究的院校和公司相对较少，是一项较新的钎焊方法。国外在此项焊接工艺的研究和应用走在世界的前列。国内一直处于不断摸索和改进的过程中，焊接过程始终存在一些问题。通过本课题技术研究和相关的试验，详细地介绍了高频钎焊设备、工艺方法和高频钎焊工艺参数确定等方面的应用。     

高压液氧供应系统管路设计

高压液氧供应系统是我国压力最高的挤压式液体火箭发动机试验台的关键分系统。在系统设计过程中，通过合理布置管路，设计专用固定支架，采用自然补偿和堆积绝热技术，解决了高压低温推进剂系统管路设计中的难题。该系统顺利通过气密性检查和调试，经多次热试车考核，系统稳定可靠，满足设计要求。