大型转动机械碰摩故障分析的声发射检测系统

汽轮发电机、空气压缩机等采用油膜支撑的大型转动机械,由于安装或运行中的原因,在转子旋转过程中,可能和器壁发生轻微的摩擦和碰击,简称碰摩.声发射技术在碰摩发生特别是故障早期诊断上有优越性.本系统的特点是没有沿用传统的计数、幅度、能量和持续时间等声发射特性参数,而是在声发射包络信号的频率分析中进行特征提取.声发射发生的过程分析和现场试验都表明这种方法对碰摩检测很敏感,在碰摩发生的起始阶段,包络谱中与转速同步的周期性分量显著增加.根据这种新的设计思想自行研制了BUAA碰摩声发射检测仪并对此作了介绍.     

微波泄漏对光抽运铯束频标准确度影响的分析

微波泄漏是影响光抽运铯原子钟准确度的主要因素之一. 傅里叶变换分析法是分析其影响的主要手段,但该方法只能用来分析有效原子速度分布很窄的情况.通过分析和计算,推导出频移随漏场的位置、相位和幅度变化的关系式.计算和分析的结果表明,漏场引起频移大小和漂移区的长度、输入微波功率值和漏场的相位、强度和位置等有关.所得的结果和用傅里叶变换方法分析所得的结果是一致的,分析的方法不受原子有效速度限制.     

多传感器信息融合技术

多传感器信息融合是Ｃ＾３Ｉ系统和电子综合战系统中的关键技术，本文从信息融合分类出发，讨论了单传感器的信息融合决策理论和技术以及多传感器信息融合原理，提出了多传感器信息融合专家系统，着重讨论贝叶斯法用于二元检测的分布式多传感器信息融合的检测方式。     

Hexapod多自由度微激励系统的振动时域波形控制

摘要： Hexapod多自由度微激励系统常用于航天器有效载荷在轨微振动环境的模拟，但采用现有控制方法无法精确稳定跟踪低频正弦加速度，这是由于系统耦合度高、非线性在低频段较强，被控对象相位滞后过大造成的.针对此问题，基于传统离线迭代控制方法，提出一种复合超前校正、多倍频陷波滤波器的改进离线迭代控制方法.其中，离线迭代进行补偿控制，超前校正进一步补偿系统相位，多倍频陷波滤波器去除非线性干扰.跟踪低频定频正弦加速度的实验结果表明，对比传统离线迭代控制方法，改进方法收敛快、控制精度高；对比现有自适应正弦振动控制方法，改进方法将符合精度要求的加速度控制频带下限由14.5 Hz扩宽至8 Hz.实验结果验证了所提方法的有效性.     

一次民机飞行中甚高频通信不稳定的排故

针对某型号民用飞机甚高频通信系统在飞行中出现断续故障的情况，对系统的架构进行描述，分析了故障产生的机理，提出了排故思路，记述了排故过程，并总结了甚高频通信系统的设计要点和工艺要点。     

On the station keeping of a solar sail in the elliptic Sun–Earth system

In this work we focus on the dynamics of a solar sail in the Sun–Earth Elliptic Restricted Three-Body Problem with solar radiation pressure. The considered situation is the motion of a sail close to the L₁ point, but displacing the equilibrium point with the sail so that it is possible to have continuous communication with the Earth. In previous works we derived a station keeping strategy for this situation but using the Circular RTBP as a model.     

Abnormal changes of dynamic derivatives at low reduced frequencies

A number of studies have found that abnormal changes of dynamic derivatives occurred at very low reduced frequencies, but its inducement mechanism is not very clear. This paper has researched the abnormal changes and analyzed the influence on some parameters by solving the unsteady flow around forced oscillation airfoils based on Navier-Stokes equations. Results indicate that when the reduced frequency approaches to zero, the dynamic derivatives obtained by the numerical method will diverge. We have also proven it in theory that this phenomenon is not physical but completely caused by numerical singularity. Furthermore, the abnormal phenomenon can be effectively mitigated by using the time spectral method to solve the aerodynamic forces and the integral method to obtain the dynamic derivatives. When the reduced frequency is in the range of 0.001–0.01, the dynamic derivative maintains nearly unchanged for the whole speed region. This study can provide a reference for the reasonable choice of the reduced frequency in calculations and experiments of dynamic derivatives.     

Adaptive suppression of passive intermodulation in digital satellite transceivers

For the performance issues of satellite transceivers suffering passive intermodulation interference,a novel and effective digital suppression algorithm is presented in this paper.In con trast to analog approaches,digital passive intermodulation (PIM) suppression approaches can be easily reconfigured and therefore are highly attractive for future satellite communication systems.A simplified model of nonlinear distortion from passive microwave devices is established in consid eration of the memory effect.The multiple high-order PIM products falling into the receiving band can be described as a bilinear predictor function.A suppression algorithm based on a bilinear poly nomial decorrelated adaptive filter is proposed for baseband digital signal processing.In consideration of the time-varying characteristics of passive intermodulation,this algorithm can achieve the rapidness of online interference estimation and low complexity with less consumption of resources.Numerical simulation results show that the algorithm can effectively compensate the passive intermodulation interference,and achieve a high signal-to-interference ratio gain.     

Evaluation and improvement of coastal GNSS reflectometry sea level variations from existing GNSS stations in Taiwan

Global sea level rise due to an increasingly warmer climate has begun to induce hazards, adversely affecting the lives and properties of people residing in low-lying coastal regions and islands. Therefore, it is important to monitor and understand variations in coastal sea level covering offshore regions. Signal-to-noise ratio (SNR) data of Global Navigation Satellite System (GNSS) have been successfully used to robustly derive sea level heights (SLHs). In Taiwan, there are a number of continuously operating GNSS stations, not originally installed for sea level monitoring. They were established in harbors or near coastal regions for monitoring land motion. This study utilizes existing SNR data from three GNSS stations (Kaohsiung, Suao, and TaiCOAST) in Taiwan to compute SLHs with two methods, namely, Lomb–Scargle Periodogram (LSP)-only, and LSP aided with tidal harmonic analysis developed in this study. The results of both methods are compared with co-located or nearby tide gauge records. Due to the poor quality of SNR data, the worst accuracy of SLHs derived from traditional LSP-only method exceeds 1?m at the TaiCOAST station. With our procedure, the standard deviations (STDs) of difference between GNSS-derived SLHs and tide gauge records in Kaohsiung and Suao stations decreased to 10?cm and the results show excellent agreement with tide gauge derived relative sea level records, with STD of differences of 7?cm and correlation coefficient of 0.96. In addition, the absolute GNSS-R sea level trend in Kaohsiung during 2006–2011 agrees well with that derived from satellite altimetry. We conclude that the coastal GNSS stations in Taiwan have the potential of monitoring absolute coastal sea level change accurately when our proposed methodology is used.     

强不确定系统“全系数之和等于1”的实现方法

摘要： 研究强不确定系统“全系数之和等于1”的实现方法，强不确定系统指的是系统的静态增益及其界不完全确知且范围较大.“全系数之和等于1”是吴宏鑫院士20世纪80年代发现的，该原理表明，对于未知连续系统，其离散化系统的系数的和在一定条件下是1.该原理的发现对于解决闭环辨识和自适应控制的瓶颈问题具有关键作用.“全系数之和等于1”是在一定条件下成立的.为了实现系统的“全系数之和等于1”，需要对系统进行一定的变换，以满足所需条件.其中，采用静态增益的标称值的倒数进行输入变换的方法在实际中得到了广泛应用.但是，当系统的不确定性较大时，该变换将带来较大偏差.针对该问题开展了深入研究，明确给出了系统静态增益的不确定性与标称值的比值的关系对于实现“全系数之和等于1”的影响.当不确定性与标称值的比值较小时，可以近似实现“全系数之和等于1”；当比值较大时，进一步给出了通过选取合适的采样周期，近似实现“全系数之和等于1”的方法.本文的研究对于特征模型理论在实际中的应用提供了一定的基础.