雷暴云准静电场和夜间低电离层的电离

用点电荷模型计算雷暴云突然放电后形成的准静电后形成的准静电场随高度的分布，以E/N（E的电场大小，N为大气密度）为输入参量，在一定条件下，对Boltzmann方程数值求解，计算电离层电子数密度的扰动。计算结果表明，在约70-90km之间，在约放电后的10ms内，准静电场大于中性大气的击穿电场，将引起大气的雪崩电离，从而引起夜间低电离层电子密度的显著增加，但这种电子密度的增加是暂的，在很短的时期内就恢复到平静时的水平，恢复时间随高度的变化而不同。     

舰载飞机自动着舰系统的研究

介绍了舰载飞机的自动着舰系统（包括了飞机的飞行控制系统，推力控制系统及航空母舰的导引系统），并指出只有精确地控制飞机的不滑轨迹，才能使飞机在航空母舰上安全降落，本文着得讨论俯仰指令型的纵向自动着舰系统的原理、结构及设计，并指出导引指令中对舰体运动的补偿。     

The characteristics of sharp (small-scale) boundaries of solar wind plasma and magnetic field structures

We investigate properties of large (>20%) and sharp (<10 min) solar wind ion flux changes using INTERBALL-1 and WIND plasma and magnetic field measurements from 1996 to 1999. These ion flux changes are the boundaries of small-scale and middle-scale solar wind structures. We describe the behavior of the solar wind velocity, temperature and interplanetary magnetic field (IMF) during these sudden flux changes. Many of the largest ion flux changes occur during periods when the solar wind velocity is nearly constant, so these are mainly plasma density changes. The IMF magnitude and direction changes at these events can be either large or small. For about 55% of the ion flux changes, the sum of the thermal and magnetic pressure are in balance across the boundary. In many of the other cases, the thermal pressure change is significantly more than the magnetic pressure change. We also attempted to classify the types of discontinuities observed.     

编队飞行卫星群构型保持及初始化

导出了基于相对轨道要素的编队飞行卫星群轨道相对运动控制的轨道机动方程；提出了编队飞行卫星群轨道相对运动控制的轨道机动控制策略，利用不同方向的脉冲控制相对运动的轨道参数，包括轨道平面内机动和轨道平面外机动控制。根据相对轨道要素的变轨机动控制，进行编队飞行卫星群构型的初始化。这样的构型初始化可以视作一次特殊的变轨机动控制，很容易实现编队飞行构型的初始化机动。     

一般硬化材料弹塑性旋转盘的变分解法

首先在小弹塑性范围内用应变的奇次四项式相当精确地拟合一般硬化材料的拉伸曲线;再在体积不变条件下用弹性位移场的已知模态和一待定幅值构成弹塑性位移场;最后用势能原理确定该幅值而得到封闭解。     

半浮区液桥自由面振荡特征

使用一套双路同步显微放大录像及图像处理系统,研究了夹角为90°的两个竖直剖面沿轴向不同高度液桥自由表面的位移振荡,得到轴向不同高度上的环向相位差,观测到在振荡周期内液桥表面轮廓线在不同时刻均不相交的特点。实验结果表明,液桥自由面振荡除具有径向扰动及轴向振荡变化外,还存在环向波动变化。根据实验结果,讨论了环向波动基本变化规律以及本实验在测量精度和测量误差方面存在的问题。     

研究用现场数据估计系统可靠性参数置信区间

研究用元部件现场信息估计系统可靠性参数,如系统可靠度、可靠寿命等区间估计问题。文中提出了一种新的估计方法——替换百分点法,并运用Monte Carlo数字仿真对估计的置信度和精度进行了分析,研究结果表明此方法具有工程应用价值。     

Acceleration of interplanetary pick-up ions and anomalous cosmic rays

It may not be doubted anymore that anomalous cosmic rays (ACRs) are produced in the heliosphere from interplanetary pick-up ions through their acceleration at the solar wind termination shock. However, there is no general agreement in the community of heliospheric researchers concerning the mechanism of injection of the pick-up ions into the shock acceleration. We discuss here three possible ways for pick-up ions to be involved into the acceleration process at the termination shock: (1) preacceleration of pick-up ions in the whole region from the Sun up to the termination shock by solar wind turbulences and interplanetary shock waves, (2) local preacceleration of pick-up ions in a vicinity of the termination shock by shock surfing, and (3) formation of high-velocity tails in pick-up ion spectra consisting of secondary pick-up ions which are produced in the supersonic solar wind due to ionization of energetic neutral atoms entering from the inner heliosheath.     

多机并联火箭羽流流场及其底部热环境分析

For the problem that the plume flow field structure of a multi engine parallel rocket is complicated and the bottom thermal environment is extremely harsh, which may cause the failure of the engine structural components, the plume flow field and thermal environment at different altitudes are studied through numerical simulation. The result is compared with the measured results in flight which shows that when the rocket is flying at a low altitude, the plume of the engines do not interfere with each other. As the flight altitude increases, the plumes gradually expand and begin to interfere with each other, and finally there is an obvious backflow at the bottom of the rocket. The maximum heat flux at the moment of take off is basically the same as the measured value in flight. Before the backflow occurs, the heat flux mainly consists of radiant heat, the convective heat flow increases as the flight altitude grows, but it is also much smaller than the peak heat flow at takeoff. The result has certain guiding significance for the optimal design of engine structure thermal protection.     

飞机变形自动化测量方法研究

为解决以往飞机变形测量模式中人工干预较多,受测量环境影响较大,测量时间长等问题,基于Geo COM技术和RS232,在计算机与全站仪之间进行数据交换,设计了一套自动化测量系统。在测量过程中由标志点的机体理论坐标反算其在当前测站中的极坐标,从而在测量过程中驱动全站仪指向待测点,减少人工瞄准时间,并由计算机实时解算结果数据。经实际飞行试验验证表明,测量时间缩短为原来时间一半,大大提高了工作效率。