机载电子设备搭接技术研究

针对机载电子设备装机时的搭接环节,对机箱主要搭接技术进行了研究。根据设备搭接目的和性能要求,给出了相应的设备-托架、托架-安装支架之间的搭接方法,模块-机柜、机柜-安装支架之间的搭接方法,以及设备的备份搭接方法,并指出了各种搭接方式的特点、优点和不足,为设备的研制和机上安装提供搭接技术支持。     

棘爪扁簧断裂故障分析及制造工艺的改进

通过设计计算、对比分析、工艺复装、工艺试验等方法对棘爪扁簧使用中断裂故障进行了分析,并针对性地从设计、工艺两方面进行了改进,经鉴定与试车验证,措施有效,为航空发动机同类零件的研究提供了经验。     

某发动机调节器自动检测异常故障分析

针对某型发动机自动调节器自动检测异常的故障现象,对产生发动机自动调节器自动检测异常的原因进行了深入地研究分析,并提出了针对性的预防措施。     

DME Interference mitigation for L-DACS1 based on system identification and sparse representation

L-band digital aeronautical communication system 1 (L-DACS1) is a promising candi-date data-link for future air-ground communication, but it is severely interfered by the pulse pairs (PPs) generated by distance measure equipment. A novel PP mitigation approach is proposed in this paper. Firstly, a deformed PP detection (DPPD) method that combines a filter bank, correlation detection, and rescanning is proposed to detect the deformed PPs (DPPs) which are caused by mul-tiple filters in the receiver. Secondly, a finite impulse response (FIR) model is used to approximate the overall characteristic of filters, and then the waveform of DPP can be acquired by the original waveform of PP and the FIR model. Finally, sparse representation is used to estimate the position and amplitude of each DPP, and then reconstruct each DPP. The reconstructed DPPs will be sub-tracted from the contaminated signal to mitigate interference. Numerical experiments show that the bit error rate performance of our approach is about 5 dB better than that of recent works and is closer to interference-free environment.     

某型飞机通信电台干扰油量系统故障分析

针对某型飞机通信电台干扰油量系统故障，分析了油量测量系统的原理和电磁干扰机理，研究了故障发生的原因，制定了抑制干扰的措施，解决了一直困扰修理的油量指示系统跳变问题，提高了飞机修理质量。     

Optimization and verification of free flight separation similarity law in high-speed wind tunnel

Based on the similarity of separation time, a similarity law optimization method for high-speed weapon delivery test is derived. The typical separation state under wind load is simulated by the numerical method. The real separation data of aircraft, separation data of previous test methods, separation data of ideal wind tunnel test of previous methods, and simulation data of the proposed optimization method are obtained. A comparison of the data shows that the method proposed can improve the performance of tracking. Similarity law optimization starts with the development of motion equations and dynamic equations in the windless state to address the problems of mismatching between vertical and horizontal displacement, and to address the problems of separation trajectory distortion caused by insufficient gravity acceleration of the scaling model of existing light model. The ejection velocity of the model is taken as a factor/vector, and is adjusted reasonably to compensate the linear displacement insufficiency caused by the insufficient vertical acceleration of the light model method, so as to ensure the matching of the vertical and horizontal displacement of the projectile, and to improve the consistency between the test results of high-speed projection and the actual separation trajectory. The optimized similarity law is applicable to many existing free-throwing modes of high-speed wind tunnels. The optimized similarity law is not affected by the ejection velocity and hanging mode of the projectile. The optimized similarity law is suitable not only for the launching of the buried ammunition compartment and external stores, but also for the test design of projectile launching and gravity separation.     

数字射频存储器在雷达干扰中的应用

论述了数字射频存储器(DRFM)技术在雷达对抗中的作用和重要性,介绍了DRFM的原理。给出了应用DRFM进行雷达干扰的几种干扰方式。     

复杂电磁环境中智能决策对抗技术的应用

当前雷达技术的发展突飞猛进,复杂的电磁环境已经是战场必须面对的现实情况,提出了一种可适应战场复杂电磁环境的智能干扰技术,主要从分选、干扰策略和干扰效能评估等方面讨论了整个智能对抗干扰的原理,对战场指挥决策有一定参考价值。     

倾转四旋翼飞行器垂直飞行状态气动特性

综合采用基于滑移网格技术的计算流体力学(CFD)方法与悬停状态气动干扰试验方法,对倾转四旋翼(QTR)飞行器垂直飞行状态的流场进行模拟与试验,研究飞行器垂直飞行状态气动特性以及部分参数对气动特性的影响.结果表明:倾转四旋翼飞行器在垂直飞行状态,前后旋翼之间干扰不明显,但旋翼与机翼的干扰明显;旋翼旋向对旋翼与机翼的干扰不...     

桨叶实度及轴间距对摆线桨气动特性影响研究

悬停状态下,设计参数和摆线桨间距离对摆线桨的气动特性有较大影响。首先通过算例验证滑移网格计算方法应用于摆线桨悬停状态下气动力计算的准确性,然后研究摆线桨在不同半径、弦长和桨叶数时的气动参数特性,最后计算分析不同距离时,摆线桨间的气动干扰特性。结果表明:随着半径增大,桨叶气动力和单位面积上载荷均增大;弦长越大,气动力越大,桨叶单位面积上载荷反而越小;4叶片摆线桨产生的气动力比3叶片和6叶片大,而3叶片的桨叶载荷最大;合力偏转角分别随转速和实度的增大而减小;随着摆线桨间距离的增加,气动力损失系数和合力偏转角均减小。