闭式脉动热管启动性能的实验研究

实验研究了以乙醇为工质的闭式脉动热管在不同工况下的启动性能,分析了充液率、倾斜角、热负荷对脉动热管启动性能的影响。研究发现脉动热管具有两类启动方式:温度飞升式启动和温度渐进式启动。脉动热管启动性能最优的最佳充液率范围在41%～52%之间。相同热负荷下,随着倾斜角在0°～90°范围内逐渐增大,热管启动性能将得到改善。随着热负荷的增大,启动时间缩短但最高启动温度随之升高。     

Evaluation and analysis on positioning performance of BDS/QZSS satellite navigation systems in Asian-Pacific region

By using the observation data and products of precise obit and clock offset from Multi-GNSS Experiment (MGEX) of the International GNSS Service (IGS) and GNSS Research Centre, Curtin University in this paper, the positioning performance of BDS/QZSS satellite navigation system has been analyzed and evaluated in aspects of the quantity of visible satellites, DOP value, multipath effect, signal-to-noise ratio, static PPP and kinematic PPP. The analysis results show that compared to BDS single system when the cutoff angle are 30°and 40°, the DOP value of BDS/QZSS combined system has decreased above 20%, and the quantity of visible satellites increased about 16–30% respectively, because of the improved spatial geometric configuration. The magnitude of satellite multipath effect of BDS system shows the trend of MEO?>?IGSO?>?GEO, which is consistent with that of QZSS satellite system, as the constellation structure of the two systems is similar. The variation tendencies of signal-to-noise ratio with respect to elevation angle of the two systems are almost the same at all frequencies, showing that at the same elevation angle the signal-to-noise ratio of MEO satellites is higher than that of IGSO satellites, as the higher obit is the lower transmitting power is obtained. For having a specially designed obit, the variation of signal-to-noise ratio of BDS system is more stable. However, the magnitude of signal-to-noise ratio of QZSS system appears the trend of frequency 3?>?frequency 2?>?frequency 1. The static PPP performance of the BDS/QZSS combination system has been improved more significantly than the BDS single system in E, N and U directions. When the cutoff angle are at 7°, 15° and 30°, the PPP accuracy is increased about 25–34% in U direction, 10–13% and 23–34% in E and N directions respectively. When the elevation angle is large (40°), compared to BDS single system at lower elevation angles (7° and 15°) the PPP accuracy of the BDS/QZSS combination system is improved above 30% in U direction. In kinematic PPP performance, compared to BDS single system, the accuracy, availability and reliability of the BDS/QZSS combination system has been improved too, especially at large elevation angles (30° and 40°), the kinematic PPP accuracy in E and U directions has been improved about 10–50%, and above 50% in U direction. It can be concluded that the combination with QZSS system can improve the positioning accuracy, reliability and stability of BDS system. In the future, with the improvement of the satellite construction of Japan’s QZSS system and the global networking of China’s BDS satellites, the QZSS satellites will contribute greatly to improve the positioning accuracy, reliability, availability and stability of GNSS systems in areas such as cities, mountains, densely-packed buildings and severely covered areas in Asian-Pacific region.     

航材管理中的成本控制与保障率组合研究

从系统角度考察航材成本与保障率的关系，研究影响保障率的动因，并将各种因素同成本对应起来，旨在实现以最合适的成本保证公司运营效率最大化的目标，以及从需求出发制定确实有效的成本改进方法。     

一次燃气混合比对引射火箭二次燃烧火焰稳定的影响

在综合分析引射火箭燃烧组织模式的基础上,针对固定结构的引射火箭发动机.借助双燃烧室冲压发动机的原理,开展了SMC+DAB混合燃烧组织模式的数值分析和发动机直连实验研究,详细分析了富燃一次燃气对二次燃烧火焰稳定的作用及其对发动机性能的影响.鲒果表明,SMC+DAB混合燃烧模式具有一定的优点,合适的一次燃气混合比可起到稳定二次燃烧火焰和提高发动机性能的作用,偏高和偏低的一次燃气混合比都不利于发动机性能的提高.在文中给定的实验条件和参数条件下.一次燃气混合比应为0.7左右.     

燃油气液比对飞机吸力供油的影响研究

吸力供油是民用飞机燃油系统的基本功能,燃油气液状态是影响吸力供油能力的关键性因素。以某型飞机为例,通过严格的试验方法,对吸力供油能力进行了验证,并以试验数据为基础,对燃油气液比进行计算,分析了其产生的影响。研究结果可用于指导飞机燃油系统设计和发动机性能评定。     

学生成绩的Logistic回归模型研究

研究了Logistic回归模型,进行分组数据,计算对数发生比,为了修正异方差性,在做常规最小二乘估计之前,转换数据,建立某校学生结业考试成绩与第一学期考试成绩及学生性别关系的Logistic回归模型,结果表明, 结业考试成绩不但与第一学期考试成绩有关而且与学生性别的关系也不容忽视,为研究三者之间的关系,选择适当的方法提高学生成绩提供理论根据.     

风扇出口导向叶片低噪声设计Ⅱ:数值验证

作为风扇出口导向叶片（Outlet Guide Vanes，OGV）低噪声设计系列文章的第2篇，本文对气动/声学一体化设计获得的2个OGV低噪声方案的降噪效果进行了数值验证。为了对低噪声优化方案的降噪效果进行详细评估，首先，采用非线性谐波法对优化前后的风扇/增压级开展了数值仿真，对OGV不同截面和叶片表面脉动压力进行了对比分析，发现低噪声优化设计方案有效降低了转/静干涉引起的脉动压力；然后，通过掠形和倾斜的合理组合，改变了叶片表面的相位分布，沿径向的相位变化增加了OGV对尾迹响应相互抵消的机会，从而有利于噪声的降低；最后，采用Wilson的波分解方法开展了对各方案的模态分析，对降噪效果进行了量化评估。结果显示，优化后的低噪声方案除起飞状态1BPF外，降噪量均超过了5 dB。     

基于脉冲电源的MOSFET驱动电路研究及应用

分析了在电火花等精密加工中MOSFET驱动器的隔离技术及特点,提出了可靠驱动MOSFET的设计思路,并在实际中得到应用。     

描述弹塑性材料损伤演变行为的3种计算方法的研究与应用

借助于双向组合坐标系,就弹塑性材料的损伤演变速率和寿命提出了3种计算方法.它包括:单参数法、比值法、乘积法,同时本文给出了许多新的计算方程,还提供了一个同各个常用材料参数有着函数关系的综合性材料常数的新概念.这些常用参数有:疲劳强度系数σ'f、疲劳强度指数b'1、疲劳延性系数ε'f、疲劳延性指数c'1、平均应力、平均应变和临界加载时间等等.用汽车的一个零件做了实例计算,并对计算结果进行了一些比较.预计这些计算方法对避免过多的疲劳试验,对节省疲劳试验的时间、人力和资金,对方便工程应用在某种程度上将有着实际意义.     

一种改进的Dolph—Chebyshev方法在阵列天线方向图综合中的应用

通过对传统Chebyshev多项式增加修正因子得到一种修正的Chebyshev多项式，并以此为基础提出了一种新的阵列天线方向图综合方法。与传统Chebyshev综合法相比，该方法可以在保持副瓣电平不变的情况下对主瓣进行任意展宽，待求参数少，综合过程简单，有很强的实用性。