爆震管同一截面处压力测量试验

为得到爆震管内同一截面上压力波的分布特性,在60mm×60mm×2000mm方爆震管内,用乙炔(C₂H₂)和空气混合物进行了单爆震研究.在距离封闭端1400,1600mm两个截面的不同位置处分别安装4个高频响压力传感器测得压力值.实验在光滑爆震管和安装扰流器的爆震管内分别进行,结果表明:①同一截面的压力波大小并不一样,安装扰流器的爆震管内得到充分发展的爆震波,且爆震波不是一个平面波;②壁面处压力波的压力大于爆震管道中间压力.      

Acceleration of DDT by non-thermal plasma in a single-trial detonation tube

This paper compares the flame acceleration in single-trial dual-detonation tubes triggered by a spark plug and non-thermal plasma igniter. The low-temperature plasma was generated by an in-house novel AC-driven dielectric barrier discharge igniter, which reduces the power supply requirements and was applied in the quiescent ignition of a single-trial detonation tube. Three different types of detonation mixtures were tested with flame propagation tracked by ion probes and pressure waves recorded by high-frequency pressure transducers. The flame propagation speeds were calculated and compared based on signals from the ion probes. The detonation combustion succeeded in the dual tubes, but the deflagration-to-detonation transition could be significantly accelerated by the plasma for all mixtures, as it was shortened by more than 50% compared to that of the spark plug. The present study provides a suitable technological approach for igniters of PDEs.     

Standing window of oblique detonation with pathological behaviour

Standing of an Oblique Detonation Wave (ODW) on a wedge within combustor is the prerequisite of thrust generation for ODW engine which is regarded as a novel and conceptual propulsion device with hypersonic flight Mach number. Usually a standing window of ODW is defined as the wedge angle ranged from the ODW detached angle from wedge (upper limit) to the angle that a Chapman-Jouguet (CJ) detonation occurs (lower limit). For pathological detonation cases, however, the CJ detonation cannot be achieved, and thus the lower limit of the standing window of ODW should be revisited. In present study, two types of reactions in hypersonic incoming flow that include the behavior of pathological detonation, that is, the single-step irreversible reaction with mole variation and the two-step irreversible reactions with exothermic process followed by endothermic process, have been used for studying standing behavior of ODW. The steady detonation polar analysis of ODW is carried out for both reaction systems. The results reveal that the reaction with more mole decrement and the reactions with stronger endothermic process show the pathological detonation feature and therefore modify the lower limit of standing window of ODW. Three equivalent parameters are proposed to quantitatively measure the standing window range of ODW from points of view of thermodynamics, Mach number of incoming flow and heat effect of reactions. It is found that the standing window of ODW is determined by the specific heat ratio, the overdrive degree of detonation and the endothermic level of the hypersonic incoming flow, regardless of whether the detonation is pathological or not.     

入射喷口宽度对环形射流激波聚焦起爆爆震的影响分析

为了研究射流入射喷口宽度对环形激波聚焦爆震起爆的影响,本文以氢气和空气混合物为例,对不同射流入射喷口宽度的环形激波聚焦爆震起爆过程进行了数值模拟,结果表明,当入射温度为一定值时,不同宽度的环形射流入射喷口对应着不同入射压力pin的临界值,当pin大于该临界值时,其形成的激波聚焦才能够形成高温、高压区域,从而起爆爆震波;随着入射喷口宽度的增加,射流的入射强度增大,其对应的临界入射压力随之减小。     

六管气动阀PDE协调工作研究

为了得到六管气动阀脉冲爆震发动机(PDE)的协调工作,在共用进气道条件下,主要采用离子探针技术进行了试验研究,同时对爆震波激波后燃烧波的传播速度进行了定量测量,并用压力传感器进行了试验验证.研究结果表明:在单管频率f＝30Hz(总频率f＝90Hz)时,六管PDE能够协调、稳定的工作;采用局部蒸发器改善燃油蒸发后,爆震管...     

喷管收敛-扩张角对爆震发动机性能影响分析

为了研究喷管收敛-扩张角对爆震发动机性能的影响,以氢气和氧气混合物为例,对不同喷管收敛-扩张角下的爆震发动机工作过程进行了数值模拟,结果表明,不同喷管收敛-扩张角对爆震发动机性能的影响并不相同。增大扩张角,喷管出口面积增大,推力投影面积增大,排气时间减少,喷管内压力下降较快。收敛角为5°或扩张角为5°时的爆震发动机性能较好。     

铝粉浓度对汽油-纳米铝粉悬浮液滴多相爆轰影响的一维数值计算

采用带化学反应的一维多相流模型,运用CE/SE数值计算方法和处理源项的四阶龙格-库塔方法对爆轰管内汽油/纳米铝粉悬浮液滴、空气混合物的多相爆轰过程进行了数值模拟,讨论了悬浮液滴中纳米铝粉浓度对爆轰参数及燃烧转爆轰过程的影响。数值结果表明,添加纳米铝粉后,稳定传播的爆轰波速度变大;随着纳米铝粉浓度的增加,爆轰波压力峰值与...     

Experimental investigations on the power extraction of a turbine driven by a pulse detonation combustor

In order to grasp the interaction mechanism between the pulse detonation combustor（PDC）and the turbine,the experimental work in this paper investigates the key factors on the power extraction of a turbocharger turbine driven by a PDC.A PDC consisting of an unvalved tube is integrated with a turbocharger turbine which has a nominal mass flow rate of 0.6 kg/s and50000 r/min.The PDC-turbine hybrid engine is operated on gasoline-air mixtures and runs for6＋min to achieve a thermal steady state,and then the engine performance is evaluated under different operating conditions.Results show that the momentum difference per unit area between the turbine inlet and outlet plays an important role in the power extraction,while the pressure peak of the detonation has little effect.The equivalence ratio of fuel and air mixture and the transition structure between PDC and turbine are also important to the power extraction of the turbine.The present work is promising as it suggests that the performance beneft of a PDC-turbine hybrid engine can be realized by increasing the momentum difference per unit area through the optimal design of transition section between the PDC and turbine.     

纵向尾流间隔计算方法研究

综合考虑了飞机的速度、翼展、机翼面积、发动机推力等参数,应用空气动力学中的环量计算理论、尾流消散原理等,将动量定理和涡阻力的计算原理应用到尾流间隔的计算,分别建立了纵向尾流间隔计算模型。采用实际数据计算验证模型的正确性。     

超声速斜爆震发动机起爆过程研究综述

对超声速斜爆震发动机的起爆方式进行了比较分析,对起爆发展和稳定特性的研究历程和发展现状进行了综述,对相关的研究方法和技术进行了概括,提出了利用先进光学测量技术,结合激光诱导荧光技术对超声速斜爆震发动机起爆过程进行实验研究的设想。