直升机着舰起落架动态响应

舰载直升机着舰过程复杂。与地面降落相比,舰面的不稳定气流使得直升机姿态难以保持,下降的速度更大,且由于直升机通常都是单轮着舰,导致起落架载荷很大。为了研究直升机在不同条件下着舰时起落架的动态响应,建立了机体/起落架/舰船耦合模型,将着舰过程中直升机的运动和舰船的运动联系起来,通过仿真计算得出起落架的动态响应。仿真计算结果表明:直升机着舰质量越大,起落架压缩量和载荷越大;直升机低头着舰会导致前起落架载荷显著增大;直升机着舰下沉速度过大会导致着舰载荷急剧增大,可能会对结构造成破坏。     

Convex optimisation approach to constrained fuel optimal control of spacecraft in close relative motion

This paper describes an interesting and powerful approach to the constrained fuel-optimal control of spacecraft in close relative motion. The proposed approach is well suited for problems under linear dynamic equations, therefore perfectly fitting to the case of spacecraft flying in close relative motion. If the solution of the optimisation is approximated as a polynomial with respect to the time variable, then the problem can be approached with a technique developed in the control engineering community, known as “Sum Of Squares” (SOS), and the constraints can be reduced to bounds on the polynomials. Such a technique allows rewriting polynomial bounding problems in the form of convex optimisation problems, at the cost of a certain amount of conservatism. The principles of the techniques are explained and some application related to spacecraft flying in close relative motion are shown.     

Analysis of the DORIS contributions to ITRF2008

In its function as an ITRS Combination Centre, DGFI is in charge with the computation of an ITRF2008 solution. The computation methodology of DGFI is based on the combination of datum-free normal equations (weekly or session data sets, respectively) of station positions and Earth orientation parameters (EOP) from the geodetic space techniques DORIS, GPS, SLR and VLBI. In this paper we focus on the DORIS part within the ITRF2008 computations. We present results obtained from the analysis of the DORIS time series for station positions, network translation and scale parameters, as well as for the terrestrial pole coordinates. The submissions to ITRF2008 benefit from improved analysis strategies of the seven contributing IDS analysis centres and from a combination of the weekly solutions of station positions and polar motion. The results show an improvement by a factor of two compared to past DORIS data submitted to ITRF2005, which has been evaluated by investigating the repeatabilities of position time series. The DORIS position time series were analysed w.r.t. discontinuities and other non-linear effects such as seasonal variations. About 40 discontinuities have been identified which have been compared with the results of an earlier study. Within the inter-technique combination we focus on the DORIS contribution to the integration of the different space geodetic observations and on a comparison of the geodetic local ties with the space geodetic solutions. Results are given for the 41 co-location sites between DORIS and GPS.     

Unsteady oscillation of a deformable airfoil section in incompressible flow

The unsteady aerodynamic loads (pressure increment and generalized forces) acting on a deformable thin airfoil section are determined for its arbitrary motion in the incompressible flow with transverse gusts. In this case, the exact Küssner solution in series is used for harmonic oscillation of an airfoil, in which the Theodorsen function is approximated by a sum of fractional functions with poles. In the time domain, these functions are replaced by the unknown functions that satisfy the one-type ordinary first order differential equations. The equations obtained are combined with the differential equations of the airfoil motion in the generalized coordinates and are used for analyzing the aeroelastic system stability and calculating its dynamic response to gust loads.     

Effects of blade aspect ratio and taper ratio on hovering performance of cycloidal rotor with large blade pitching amplitude

In recent years, a lot of research work has been carried out on the cycloidal rotors. However, it lacks thorough understanding about the effects of the blade platform shape on the hover efficiency of the cycloidal rotor, and the knowledge of how to design the platform shape of the blades. This paper presents a numerical simulation model based on Unsteady ReynoldsAveraged Navier–Stokes equations(URANSs), which is further validated by the experimental results. The effects of blade aspect ratio and taper ratio are analyzed, which shows that the cycloidal rotors with the same chord length have quite similar performance even though the blade aspect ratio varies from a very small value to a large one. By comparing the cycloidal rotors with different taper ratios, it is found that the rotors with large blade taper ratio outperform those with small taper ratio. This is due to the fact that the blade with larger taper ratio has longer chord and hence better efficiency. The analysis results show that the unsteady aerodynamic effects due to blade pitching motion play a more important role in the efficiency than the blade platform shape. Therefore we should pay more attention to the blade airfoil and pitching motion than the blade platform shape.The main contributions of this paper include: the analysis of the effects of aspect ratio and taper ratio on the hover efficiency of cycloidal rotor based on both the experimental and numerical simulation results; the finding of the main influencing factors on the hover efficiency; the qualitative guidance on how to design the blade platform shape for cycloidal rotors.     

气体性质对气动增压器性能的影响

气动增压器的动作频率是一个重要的性能参数。当气动增压器结构确定后,频率直接决定推进剂流量等参数。同时,气动增压器的动作频率体现在推进剂出口管路压力的波动上,对出口压力的稳定性有很大影响。研究气动增压器的动作频率,有助于合理选择频率参数,以及气动增压器结构参数和性能参数的匹配。为了研究增压气体性质对气动增压器工作性能的影响,建立了数学模型,利用AMESim软件对气液活塞的工作过程进行了仿真。仿真结果与试验数据对比,一致性较好。     

Spatial Metaphors of Web Use

When the web became popular, people had to develop ways to talk and think about it. In the mid-1990s, we analyzed spatial language in “web talk.” We found that people described pages as places, and search as motion, both passive and active motion. Here we investigate web talk nearly two decades later. Our analysis reveals that some spatial language has stayed the same, and some has changed. Of special interest is how far fewer motion verbs are used nowadays. We argue that people naturally produce spatial metaphors when talking about new technological domains, and that over time, the most useful elements persist.     

大迎角耦合运动非定常空气动力特性

采用某飞机大迎角大振幅运动风洞实验结果，分析了大迎角非定常空气动力的一些特性。结果表明，飞机机动飞行时多自由度运动的气动特性比单自由度运动复杂，耦合运动时的气动特性和两个单自由度运动的气动特性的叠加结果相比有一定差别。此外，旋转天平实验结果同本实验的结果相比差别较大。     

三轴仿真转台设计方法研究

针对航空、航天领域的半实物仿真关键设备-三轴仿真转台,重点从结构形式、电机选择、控制方式和控制算法等方面对其设计方法进行研究并提出相应的设计建议,对三轴仿真转台系统设计者具有一定的参考价值。     

非定常风洞洞壁干扰研究

在1m口径圆形截面低速风洞中用一组大小不同外形相似的前缘后掠角为70°的三角翼模型,测量了模型作俯仰运动时的上表面的动态压力分布,研究了洞壁对模型表面动态压力分布的影响.在3m×2.5m矩形截面低速风洞中,用另一组外形相似的前缘后掠角为70°的三角翼模型进行非定常测力试验,并测定了洞壁上有限测压点的动态压力,研究了模型大小对非定常壁压的影响和洞壁对模型非定常法向力系数的影响,并用混合法对大模型的非定常法向力进行了洞壁干扰修正,大模型的法向力系数修正结果与小模型的法向力系数基本一致.