On a plastic instability criterion for ultra-large radial-axial ring rolling process with four guide rolls

A dynamic mechanical model is proposed to describe the complexing actions of all the rolls on the ring during the ultra-large radial-axial ring rolling(RARR) process with four guide rolls. Based on the model, the calculation models for bending moment and normal stress at any section of the ring are deduced by force method. If the maximum section bending normal stress exceeds the yield stress of the ring materials, the ring will be distorted thus leading to the instability of the RARR process. Ac...     

Numerical simulations of a continuously injected relativistic electron beam relaxation into a plasma with large-scale density gradients

In this paper the influence of large-scale decreasing and increasing gradients of the density of magnetized plasma on the relaxation process of a continuously injected relativistic electron beam with an energy of 660 keV ($v_b=0.9c$) and a pitch-angle distribution is studied using particle-in-cell numerical simulations. It is found that for the selected parameters in the case of a smoothly decreasing gradient and in a homogeneous plasma the formation of spatially limited plasma oscillations of large amplitude occurs. In such cases, modulation instability develops and a long-wave longitudinal modulation of the ion density is formed. In addition, the large amplitude of plasma waves accelerates plasma electrons to energies on the order of the beam energy. In the case of increasing and sharply decreasing gradients, a significant decrease in the amplitude of plasma oscillations and the formation of a turbulent ion density spectrum are observed. The possibility of acceleration of beam electrons to energies more than 2 times higher than the initial energy of the beam particles is also demonstrated. This process takes place not only during beam propagation in growing plasma density, but also in homogeneous plasma due to interaction of beam particles with plasma oscillations of large amplitude.     

冰晶粒子运动过程中的相变特性

针对冰晶在温暖环境下运动时固液汽耦合的相变现象，基于欧拉法建立了冰晶粒子的运动相变模型和计算方法。计算了冰晶粒子在强迫对流环境下的融化相变过程，与实验结果对比验证了运动相变模型和计算方法的准确性。针对NACA0012翼型计算了冰晶绕流运动时的热力学特性，得到了冰晶粒子到达撞击表面时的融化状态与收集系数。研究了冰晶粒径大小、初始球形度、气流相对湿度和温度对运动相变的影响。结果表明：冰晶粒子运动相变模型可以有效地评估冰晶结冰风险，冰晶粒子的融化速率主要取决于粒子直径、球形度、气流温度、湿度等因素，环境温度为288 K时冰晶粒子的融化时间为27.5 s，而相同条件下环境温度为302 K时的融化时间仅有5.2 s。     

Adjoint-based robust optimization design of laminar flow wing under flight condition uncertainties

It is an inherent uncertainty problem that the application of laminar flow technology to the wing of large passenger aircraft is affected by flight conditions. In order to seek a more robust natural laminar flow control effect, it is necessary to develop an effective optimization design method. Meanwhile, attention must be given to the impact of crossflow(CF) instability brought on by the sweep angle. This paper constructs a robust optimization design framework based on discrete adjoint methods ...     

内并联型进气道模态转换过程中流道间干扰特性研究

针对组合动力进气道模态转换过程中存在的流道间干扰现象,采用数值模拟方法对一典型内并联型进气道模态转换过程中高/低速流道间的干扰特性展开了深入研究。结果表明：在模态转换过程中,当低速流道结尾激波位于低速流道内部时,高速流道节流至一定程度都将对低速流道形成干扰。该干扰现象出现后,高/低速流道的流动耦合,两流道的流量分配也随之发生变化,甚至导致了进气道流场的失稳。仅当β/α=0.25时,高/低速流道间的干扰造成了进气道流场的失稳且失稳后的振荡流场会先后出现两个不同的发展时期：前一时期的振荡流场的振幅较大但频率较低,约为335Hz；后一时期的振荡流场的振幅较小但频率较高,约为880Hz。