高温高速气流总焓接触测试法对比分析

发动机尾焰、燃烧加热、电弧加热器等高温高速气流总焓测量存在较大误差,采用结构优化的质量吸入水冷焓探针,标定后的驻点热流和驻点压力探针(Fay-Riddell公式法)对高温高速气流总焓进行了对比测试。结果表明:焓值为2.5~5 MJ/kg时,焓探针的测试误差约为3.38%,采用Fay-Riddell公式法获得焓值的误差约为3%。焓探针与Fay-Riddell公式法平均偏差约为4.65%。在地面模拟试验时采用两种测焓方法确定测试精度,对减小高温高速气流测焓误差,提高试验模拟精度具有积极的作用。     

Corrosion mechanism investigation of TiN/Ti coating and TC4 alloy for aircraft compressor application

It is imperative to develop multifunctional erosion and corrosion resistant coatings for compressor blades of aircraft engines in harsh environment. PVD (Physical Vapor Deposition) technology has the advances in processing erosion-resistant coatings; however, the performance of PVD coatings to combat corrosion depends on various coating defects. Determining and comparing the corrosion performances of PVD TiN/Ti coating and uncoated TC4 alloy was the main objective of present work. The 960 h salt spray corrosion and 116 h hot corrosion tests were conducted to simulate the grounding and working environments of the aircraft compressors. The corrosion mechanisms due to the coating defects such as pinhole, columnar boundary and large grain were analyzed based on the OM, Confocal microscope, electrochemical measurements, SEM, XRD and EDS results. Owing to the disordered state associated with the columnar boundary and the coating defect, nitrogen could be easily replaced by oxygen in the hot corrosion process, these structures were channels for fast diffusion of oxygen. Moreover, the Gibbs energy changes of Ti oxidation and TiN oxidation were thermodynamically calculated according to the working condition of aircraft compressors, and considerable research effort was focused on mapping out the phase diagram of Ti, TiN and high pressure gases. The findings of this research can provide insights into developing multifunctional coatings for future aircraft engines.     

Optimization and verification of free flight separation similarity law in high-speed wind tunnel

Based on the similarity of separation time, a similarity law optimization method for high-speed weapon delivery test is derived. The typical separation state under wind load is simulated by the numerical method. The real separation data of aircraft, separation data of previous test methods, separation data of ideal wind tunnel test of previous methods, and simulation data of the proposed optimization method are obtained. A comparison of the data shows that the method proposed can improve the performance of tracking. Similarity law optimization starts with the development of motion equations and dynamic equations in the windless state to address the problems of mismatching between vertical and horizontal displacement, and to address the problems of separation trajectory distortion caused by insufficient gravity acceleration of the scaling model of existing light model. The ejection velocity of the model is taken as a factor/vector, and is adjusted reasonably to compensate the linear displacement insufficiency caused by the insufficient vertical acceleration of the light model method, so as to ensure the matching of the vertical and horizontal displacement of the projectile, and to improve the consistency between the test results of high-speed projection and the actual separation trajectory. The optimized similarity law is applicable to many existing free-throwing modes of high-speed wind tunnels. The optimized similarity law is not affected by the ejection velocity and hanging mode of the projectile. The optimized similarity law is suitable not only for the launching of the buried ammunition compartment and external stores, but also for the test design of projectile launching and gravity separation.     

用于光波纳米推力器的颗粒供应技术和光聚积技术研究

为提高光波纳米推力器在轨应用的可行性,针对与其匹配的颗粒供应技术和光聚积技术进行研究。提出整个推进系统的设计思路,通过建立理论计算和数值计算模型,分析颗粒供应技术和光聚积技术的各项核心结构参数的设计方法。计算结果表明:颗粒供应装置的正负电极内径之比(W/D)会影响正负电荷产生的总量之比,在W/D=300/322附近时,正负电荷比例接近1:1。静电诱导电压为9 V,当中和通道长度大于37.5mm时,正负颗粒可以视为完全中和。光聚积设计思路可令聚积球对光能的利用率在32.8%左右。两种相关技术的装置与推力器在结构上能够对接、在性能上可以匹配,从理论上表明了两种支撑技术的可行性。     

舰载直升机理论风限图飞行模拟获取方法

获取舰载直升机实用风限图,仅依靠实装飞行试验或建模仿真都是非常困难的。通过起降飞行模拟试验获取理论风限图,结合少量的海上实装飞行验证试验是一种综合较优的方法。起降飞行模拟试验需要真实飞行员和高等级飞行模拟器参与,飞行模拟器中的母舰气流场数据、母舰运动可由建模仿真或试验测试得到,且必须考虑母舰气流场的非定场特性;只有当飞行员视景或视觉反馈受限时(如能见度降低时),飞行模拟器基座的六自由度运动才是必需的;用DIPES或Bedford方法量化飞行员主观操纵负担,结合记录的客观操纵数据,评判起降难度;典型的飞行模拟试验程序包含了不同风况下的进近和甲板着舰,通常每隔15°和5kn一个风况。通过起降飞行模拟试验得到的理论风限图,可以更加有效和安全地指导海上实装飞行验证试验,最终获得实用风限图。     

基于分数阶微积分理论的最优导引律设计

随着技术的发展及战场环境的日益复杂化,拦截机动目标的需求越来越大。然而传统制导律在拦截机动目标时存在制导精度差、末端过载突变的问题,故提出了一种基于分数阶微积分理论的最优导引律。首先,介绍了分数阶微积分的定义、性质及其数字实现方法;然后,分析了弹目相对运动关系,通过分数阶变阶次建模和最优控制理论推导出了分数阶导引律;最后,仿真结果表明：与传统比例导引法相比,所设计的分数阶最优导引律能够保持比例导引法良好的追踪性能且拦截时间能够缩短2s,末端过载值趋近于0。该方法解决了传统比例导引法在末端由视线角速率发散而导致的末端过载突变问题。     

试论高职院校对企业文化资源的利用

如何充分利用企业资源,有效开展工学结合、产学合作是各高职院校共同面临的课题和任务。就企业文化资源在高职院校办学和教育教学改革过程中的独特性及高职院校如何利用企业文化资源来培养技术技能型人才问题,作一些初步的分析和论述,希望引起教育研究者的思考和各类办学主体的重视。     

雷达信号时差频差测量定位工程实现技术研究

针对星载时差频差无源定位系统对地海面雷达信号定位工程实现需要考虑的实际问题,对雷达信号时差频差测量关键技术进行研究.首先研究了雷达信号时差频差测量方法,然后研究了双星时差频差模糊条件并提出解模糊方法,最后,研究了长时间积累对到达频差的影响,给出随时间变化频差补偿方法.     

电机控制系统PID参数的遗传算法优化

近年来,遗传算法的研究十分引人注目,作为一种新型的、模拟生物进化过程的随机化搜索和优化方法。其算法简单通用,鲁棒性强,在组合优化、机器学习、自适应控制和规划设计等领域的应用中已展现了其特色和魅力。该方法是一种不需要任何初始信息并可以寻求全局最优解的、高效的优化组合方法。文章就是利用遗传算法对某一电机控制系统的PID参数进行优化,以提高控制系统的性能指标。     

基于DSP的自适应桁架振动控制器设计

重量轻、功耗低、处理能力强的控制器对自适应桁架的空间应用具有重要意义。本文以自适应桁架空间应用为背景,进行了控制器的小型化设计。以DSP芯片TMS320VC33为核心,实现了自适应桁架振动控制器硬件,并开发了相应的控制程序。采用4阶线性二次型高斯(LQG)离散控制模型,在自适应桁架实验平台上进行了振动抑制实验。实验表明,以DSP为核心的小型化控制器能够实现对自适应桁架振动的有效抑制,达到了与dSPACE控制器相同的控制效果。