改进升力线理论和风洞试验结合的气动弹性修正方法

本文介绍了一种基于亚音速稳态定常流改进升力线理论与风洞试验相结合的大展弦比亚音速飞机的弹性翼面气动力分布载荷修正方法,设计目的是为了考虑具有大展弦比、弹性翼面结构的飞机翼面结构弹性变形对气动载荷分布的影响。     

宽高比及表面粗糙度对矩形微尺度通道流动特性的影响

实验研究了不同宽高比矩形金属微尺度通道的流动特性,并与硅通道对比来探究表面粗糙度的影响。金属微尺度通道宽为0.4mm,通道宽高比分别为0.50、0.67、和1.00,相对表面粗糙度范围为0.1609%~0.2145%。硅通道宽度及高度都为0.4mm,相对表面粗糙度为0.00325%。实验工质为空气,实验的雷诺数范围是250~3000。实验结果表明:在粗糙微尺度通道会发生转捩提前,并且转捩雷诺数随着宽高比增大而减小。在层流区,微尺度矩形通道摩擦因数随着雷诺数增大而减小,在转捩区出现明显增大后再减小。表面粗糙度很小时,未发现转捩提前现象。      

考虑气动力非线性的柔性飞机阵风响应分析

针对大展弦比柔性飞机阵风响应问题,考虑在大攻角(AOA)情况下气动力非线性的影响,通过将修正的Theodorsen方法与片条理论相结合,得到非线性的时域非定常气动力;在此基础上,建立阵风干扰下的大展弦比柔性飞机非线性气动弹性模型,完整地发展了一种新颖的可考虑气动力非线性的大展弦比柔性飞机阵风响应分析方法.结合算例模型开展方法验证和数值仿真,对比翼尖和质心(CG)处阵风附加过载在线性和非线性情况下的变化.算例结果表明,考虑大攻角情况下的气动力非线性后,大展弦比飞机的阵风响应较线性情况有明显变化,翼尖处的阵风附加过载最多可减少41.7%,气动力非线性的影响不可忽视.      

大展弦比飞翼作战飞机横航向飞行品质特性

基于MIL-STD-1797A飞行品质规范,开展了针对大展弦比飞翼作战飞机滚转轴和偏航轴飞行品质特性的研究.随着控制系统对系统动态特性调节作用的日益增强,由飞机构型所引起的动态响应特性差异已变得越来越小,飞翼飞机的闭环滚转模态、螺旋模态、滚转-螺旋耦合振荡、荷兰滚模态、驾驶员座位处的侧向加速度等均可达到较好的飞行品质,但稳态配平特性主要受构型的影响,不能完全满足飞行品质的要求;分析了大展弦比飞翼作战飞机在快速滚转、侧风起降和非对称推力情形下的对滚转轴和偏航轴操纵效能的要求,由于气动构型和操纵面配置等差异,大展弦比飞翼作战飞机在完成某些飞行任务时对操纵效能的需求与常规构型的飞机存在着较大差异.     

静叶角度调节对组合压气机性能优化机理

采用流线曲率法求解组合压气机的准三维流场,在叶片排前后缘及中间设置计算站,使用样条函数拟合流线;根据组合压气机结构特点,发展了适合其特性计算的损失、落后角模型及计算程序;将特性计算程序与导、静叶角度优化调节方案相结合,确定出不同设计转速下,导、静叶最佳调节角度组合.在90%设计转速,近最高效率点处,利用全三维的数值模拟手段分析了组合压气机导、静叶最佳角度调节前后流场结构变化.研究结果表明:导、静叶角度调节削弱了压气机叶片排中的激波强度,减少了损失,同时能抑制气流的分离,明显改善组合压气机的流场结构.      

Effect of scavenge port angles on flow distribution and performance of swirl-loop scavenging in 2-stroke aircraft diesel engine

Swirl-Loop Scavenging (SLS) improves the performance of 2-stroke aircraft diesel engine because the involved swirl may not only benefit the scavenging process, but also facilitate the fuel atomization and combustion. The arrangement of scavenge port angles greatly influences in-cylinder flow distribution and swirl intensity, as well as the performance of the SLS engine. However, the mechanism of the effect and visualization experiment are rarely mentioned in the literature. To further investigate the SLS, Particle Image Velocimetry (PIV) experiment and Computational Fluid Dynamics (CFD) simulation are adopted to obtain its swirl distribution characteristics, and the effect of port angles on scavenging performance is discussed based on engine fired cycle simulation. The results illustrate that Reynolds Stress Turbulence model is accurate enough for in-cylinder flow simulation. Tangential and axial velocity distribution of the flow, as well as the scavenging performance, are mainly determined by geometric scavenge port angles α_geom and β_geom. For reinforcement of scavenging on cross-sections and meridian planes, α_geom value of 27° and β_geom value of 60° are preferred, under which the scavenging efficiency reaches as high as 73.7%. Excessive swirl intensity has a negative effect on SLS performance, which should be controlled to a proper extent.     

Time delay compensation in lateral-directional flight control systems at high angles of attack

The previous studies of time delay compensation in flight control systems are all based on the conventional aerodynamic derivative model and conducted in longitudinal motions at low angles of attack. In this investigation, the effects of time delay on the lateral-directional stability augmentation system in high-α regime are discussed based on the $\dot{\beta }$ model, which is proposed in our previous work and proved as a more accurate aerodynamic model to reveal the lateral-directional unsteady aerodynamic characteristics at high angles of attack. Both the $\dot{\beta }$ model and the quasi-steady model are used for simulating the effects of time delay on the flying qualities in high-α maneuvers. The comparison between the simulation results shows that the flying qualities are much more sensitive to the mismatch of feedback gains than the state errors caused by time delay. Then a typical adaptive controller based on the conventional dynamic derivative model and a gain-prediction compensator based on $\dot{\beta }$ model are designed to address the time delay in different maneuvers. The simulation results show that the gain-prediction compensator is much simpler and more efficient at high angles of attack. Finally, the gain-prediction compensator is combined with a linearized $\dot{\beta }$ model reference adaptive controller to compensate the adverse effects of very large time delay, which exhibits excellent performance when addressing the extreme conditions at high angles of attack.     

前机身对飞机大迎角气动特性的影响

通过对一些相关文献的分析，得出了前机身外形是要求具有过失速机动能力的飞机气动设计的关键这一结论，并建议在气动布局工作中加强对前机身特性研究。     

全面视角下“法律面前人人平等原则”的探讨

本文以全面视角审视了法律面前人人平等是什么，并就我们为什么需要法律面前人人平等原则，以及如何实现法律面前人人平等等问题进行了探讨。     

斜爆轰波的波角和法向速度-曲率关系初探

为研究斜劈诱导斜爆轰波的波阵面弯曲效应，以期为斜爆轰的不稳定性及其演化规律提供新的见解，基于加权本质无振荡（WENO）格式空间离散和附加Runge-Kutta方法时间离散的求解器，针对不同的化学反应参数（释热量、放热速率和化学反应区参考长度）条件，开展斜爆轰波的数值计算研究。结果表明斜爆轰波沿波阵面的波角变化可分为3个区域：区域I，波角平滑减小；区域II，波角跃升后衰减；区域III，波角有规律振荡。波阵面法向速度-曲率关系在区域I呈现准垂直直线变化趋势，并伴随着爆轰波强度的不断衰减；在区域III则呈现出"D"形曲线，即由极曲线段、光滑水平变化段和拟线性变化段组成，为类胞格结构的周期性演变；区域II可认为是以上两个区域特征的耦合。不同的化学反应参数对斜爆轰波波阵面的弯曲效应影响存在较大差别。