微小推力下小卫星的轨道递推与推力标定

针对采用微小推力进行轨道机动的小卫星,考虑复杂摄动力的基础设计了一种高精度轨道外推和推力在轨标定算法.首先,建立了考虑地球复杂摄动力和微小推力的小卫星轨道动力学模型;然后基于动力学模型,利用变步长龙格库塔算法,设计了对微小推力小卫星进行高精度轨道外推的方法.随后通过无迹卡尔曼滤波器(UKF),设计在轨标定算法,对存在误...     

CCD信号采样位置选取方法的研究

针对CCD输出信号中的复位噪声,文章介绍了处理复位噪声较为常用的方法--相关双采样技术,并对相关双采样技术中采样位置选取的方法进行分析和研究,最后进行了实验验证.结果表明:用文中方法选取的采样位置进行相关双采样,可以较好的减小CCD输出信号中复位噪声的影响,提高信噪比.     

A nonlinear background removal method for seismo-ionospheric anomaly analysis under a complex solar activity scenario: A case study of the M9.0 Tohoku earthquake

A precise determination of ionospheric total electron content (TEC) anomaly variations that are likely associated with large earthquakes as observed by global positioning system (GPS) requires the elimination of the ionospheric effect from irregular solar electromagnetic radiation. In particular, revealing the seismo-ionospheric anomalies when earthquakes occurred during periods of high solar activity is of utmost importance. To overcome this constraint, a multiresolution time series processing technique based on wavelet transform applicable to global ionosphere map (GIM) TEC data was used to remove the nonlinear effect from solar radiation for the earthquake that struck Tohoku, Japan, on 11 March, 2011. As a result, it was found that the extracted TEC have a good correlation with the measured solar extreme ultraviolet flux in 26–34 nm (EUV_26–34) and the 10.7 cm solar radio flux (F_10.7). After removing the influence of solar radiation origin in GIM TEC, the analysis results show that the TEC around the forthcoming epicenter and its conjugate were significantly enhanced in the afternoon period of 8 March 2011, 3 days before the earthquake. The spatial distributions of the TEC anomalous and extreme enhancements indicate that the earthquake preparation process had brought with a TEC anomaly area of size approximately 1650 and 5700 km in the latitudinal and longitudinal directions, respectively.     

自动化计量学大会展出的坐标测量机

介绍自动化计量学大会展出的坐标测量机及其结构，性能和使用范围。     

基于DCT-CS的脉冲星周期超快速估计方法

受快速傅里叶变换（fast Fourier transform，FFT）的影响，基于FFT和压缩感知（compressive sensing, CS）的脉冲星周期快速估计算法的计算量大。为进一步减小计算量并提高计算精度，利用离散余弦变换（discrete cosine transform，DCT)取代FFT，提出了一种基于DCT-CS的脉冲星周期超快速估计算法。在该方法中，利用DCT提取脉冲星信号的低频部分构建低频DCT矩阵；构建畸变轮廓字典并获取累积轮廓；提出了利用最大值超分辨率稀疏恢复估计脉冲星周期的方法。仿真结果表明，DCT-CS的脉冲星周期估计精度达到了3.82×10-12 s，计算时间达到了9.31 ms。与FFT-CS相比，周期估计精度提高了约16%，计算时间缩短了约37.5%，实现了实时高精度的脉冲星周期估计。     

卫星控制中心系统平台的高可用设计与实现

卫星控制中心是卫星地面测控管理系统的重要组成部分。随着信息技术的飞速发展和测控关键业务量的增长,高可用性、高可靠性及易维护日益成为卫星控制中心系统的设计目标。为满足卫星测控任务的需求,本文描述了卫星控制中心的网络系统、数据处理系统和数据库集群系统的高可用设计,并给出具体项目的成功实现。     

Response of the EIA ionosphere to the 7-8 May 2005 geomagnetic storm

In this paper, response of low latitude ionosphere to a moderate geomagnetic storm of 7–8 May 2005 (SSC: 1920 UT on 7 May with Sym-H minimum, ∼−112 nT around 1600 UT on 8 May) has been investigated using the GPS measurements from a near EIA crest region, Rajkot (Geog. 22.29°N, 70.74°E, Geomag.14°), India. We found a decrease in total electron content (TEC) in 12 h after the onset of the storm, an increase during and after 6 h of Sym-H deep minimum with a decrease below its usual-day level on the second day during the recovery phase of the storm. On 8 May, an increase of TEC is observed after sunset and during post-midnight hours (maximum up to 170%) with the formation of ionospheric plasma bubbles followed by a nearly simultaneous onset of scintillations at L-band frequencies following the time of rapid decrease in Sym-H index (−30 nT/h around 1300 UT).     

Assessing the feasibility of involving gaseous products resulting from physicochemical oxidation of human liquid and solid wastes in the cycling of a bio-technical life support system

The study addresses the possible ways of involving gaseous products produced by “wet” incineration of human wastes mixed with H₂O₂ in an alternating electric field in the cycling of the physical model of a bio-technical life support system (BTLSS). The resulting gas mixture contains CO₂ and O₂, which are easily involved in the cycling in the closed ecosystem, and NH₃, which is unacceptable in the atmosphere of the BTLSS. NH₃ fixation has been proposed, which is followed by nitrification and involvement of the resulting products in the mass exchange of the closed system. Experiments have been performed to show that plants can be grown in the atmosphere resulting from the closing of the gas loop that includes a physicochemical installation and a growth chamber with plants representing the phototrophic compartment of the BTLSS. The results of the study suggest the conclusion that the proposed method of organic waste oxidation can be a useful tool in creating a physical model of a closed-loop integrated BTLSS.     

虚拟现实技术在航空智能制造中的应用思考与展望

人机结合、虚实融合的新一代智能界面是智能制造的一个显著特征.虚拟现实技术作为一种高级人机交互技术,将在智能制造系统中发挥人与智能设备之间传递、交换信息媒介及对话接口的作用.随着智能制造系统的发展和虚拟现实技术的不断成熟和进步,虚拟现实必将逐步深入工业应用,在两化深度融合过程中充分发挥“智能之窗”的作用.     

Training effectiveness evaluation of helicopter emergency relief based on virtual simulation

Helicopters are playing an increasingly important part in emergency relief, such as earthquake rescue, firefighting and medical transport. With the development of virtual simulation technology, virtual simulation-based training is widely used in the training of the helicopter crew especially for the dangerous and costly missions mentioned above. A complete training effectiveness evaluation method is proposed to evaluate the trainees’ training effect based on virtual simulation in this paper. A key to this method is regarding the complicated process as a discrete event-activity flow system and establishing the evaluation indicator system. Then expert group and Analytical Network Process (ANP) are applied to determine the weight of indicators. When the training data are processed, there is a novel attempt to apply Fuzzy Comprehensive Evaluation (FCE) model to calculate the two categories of indicators. Eventually, an experiment and the analysis were carried out to validate the evaluation method.