星载单频GPS数据的电离层延迟改正方法分析

利用C/A码单点定位对LEO(Low Earth Orbit)卫星上的电离层延迟改正方法——"电离层比例因子法"进行了分析研究.计算的CHAMP卫星的轨道结果表明:采用电子密度峰值高度(hmF2,F2 region maximum electron density height)平均值和瞬时值计算的电离层比例因子α变化范围分别为0.3~0.4和0.2~0.65之间,两者最大差异可达0.3,相比较而言,hmF2瞬时值的结果更加合理,并且相应的大地高H方向的系统偏差要降低0.05~0.3m左右;与双频无电离层组合的普通单点定位结果相比表明该方法能较好地消除电离层一阶项所引入的H方向上的系统偏差;该方法适用的LEO卫星轨道高度范围大致在200~ 600km之间,当轨道高度超过700km时,该方法并不适用.     

新型电子束焊机阴极加热电源自动调节系统

开发了一种新型电子束焊机阴极加热电源自动调节系统,包括新型主电路拓扑和对应控制策略,该系统能够使阴极处在最佳加热电流状态,从而提高电子束流稳定性.并且在检测到电子枪未加高压时,阴极加热电流自动关闭,在加有高压但束流给定为零时,阴极加热电流自动减少,能大幅增加阴极的使用寿命.经试验证明该系统相比传统阴极加热电源操作简洁、快速和准确,对焊缝成形质量好.     

Analysis of the ionosphere/plasmasphere electron content variability during strong geomagnetic storm

The ionosphere/plasmasphere electron content (PEC) variations during strong geomagnetic storms in November 2004 were estimated by combining of mid-latitude Kharkov incoherent scatter radar observations and GPS TEC data derived from global TEC maps. The comparison between two independent measurements was performed by analysis of the height-temporal distribution for specific location corresponding to the mid-latitudes of Europe. The percentage contribution of PEC to GPS TEC indicated the clear dependence from the time with maximal values (more than 70%) during night-time. During day-time the lesser values (30–45%) were observed for quiet geomagnetic conditions and rather high values of the PEC contribution to GPS TEC (up to 90%) were observed during strong negative storm. These changes can be explained by the competing effects of electric fields and winds, which tend to raise the layer to the region with lower loss rate and movement of the ionospheric plasma to the plasmasphere.     

Nanofillers modification of Epocast 50-A1/946 epoxy for bonded joints

Epocast 50-A1/946 epoxy was primarily developed for joining and repairing of composite aircraft structural components. The objective of the present work is to modify the Epocast epoxy resin by different nanofillers infusion. The used nanofillers include multi-walled carbon nanotubes（MWCNTs）, SiC and Al2O3 nanoparticles. The nanofillers with different weight percentages are ultrasonically dispersed in the epoxy resin. The sonication time and amplitude for MWCNTs are reduced compared to Al2O3 and SiC nanoparticles to avoid the damage of MWCNTs during sonication processes. The fabricated neat epoxy and twelve nanocomposite panels were characterized via standard tension and in-plane shear tests. The experimental results show that the nanocomposites materials with 0.5wt% MWCNTs, 1.5wt% SiC and 1.5wt% Al2O3 nanoparticles have the highest improvement in the tensile properties compared to the other nanofiller loading percentages.The improvements in the shear properties of these nanocomposite materials were respectively equal to 5.5%, 4.9%, and 6.3% for shear strengths, and 10.3%, 16.0%, and 8.1% for shear moduli. The optimum nanofiller loading percentages will be used in the following papers concerning their effect on the bonded joints/repairs of carbon fiber reinforced composites.     

模型烧蚀对尾迹电子特性影响的计算和实验研究

 基于气动物理研究的需要,针对高焓风洞的来流特点,采用计算和实验相结合的方法研究聚丙烯烧蚀对尾迹电子密度的影响。结果表明：计算结果可以有效模拟实验状态,电子密度的模拟精度有很大提高,误差在一个量级内;聚丙烯烧蚀可以降低尾迹的电子密度,但幅度不大,在2倍左右,其与选择模型材料的催化特性降低幅度相当;对电弧风洞的成功改进和非稀薄流静电探针诊断技术的应用,是尾迹电子密度测试的前提保障。     

永磁约束电子束轨迹实验研究

通过设计并运用一种直流电子束轨迹简易测量方法,开展了永磁约束电子束轨迹实验研究,得到了永磁铁环对60~80 ke V电子束约束作用的实验数据。结果表明:该测量方法方便有效,结果较为准确;永磁铁对电子束聚焦作用明显,并呈现出一定的规律性。对永磁铁约束电子束研究工作奠定了基础。     

Study of maximum electron density NmF2 at Karachi and Islamabad during solar minimum (1996) and solar maximum (2000) and its comparison with IRI

The monthly hourly medians of maximum electron density, N_mF₂, at two Pakistani ionospheric stations, Karachi and Islamabad, have been determined for solar minimum (1996) and solar maximum (2000) and compared with IRI predictions using the URSI coefficients. At night and pre-noon period the N_mF₂ values at both stations are almost equal during the 2 years. However, at post-noon the values at Karachi are considerably larger than those at Islamabad due to the equatorial or geomagnetic anomaly. Karachi (geomag. coord. 16.44°N, 139.08°E) lies near the region of the equatorial anomaly (+20 and −20 geomagnetic latitude), so most of the N_mF₂ values at Karachi are larger than those at Islamabad (geomag. coord. 24.46°N, 145.67°E). The maximum monthly values of N_mF₂ show a semi-annual variation at Karachi and Islamabad both during 1996 and 2000 as predicted by IRI.     

The geomagnetic solar flare effect identified by SIIG as an indicator of a solar flare observed by GOES satellites

This paper studies the efficiency of geomagnetic solar flare effects (gsfe) in X solar flare detection; so during the period 1999–2007 a comparison between solar flare (sf) observed by satellites of the Geostationary Operational Environmental Satellite (GOES) programme and gsfe published by the Service International des Indices Geomagnetiques (SIIG) is made.     

梯度热障涂层的设计

 采用电子束物理气相沉积方法 (EB PVD)制备了梯度热障涂层,其结构设计为NiCoCrAlY粘结层 /Al₂O₃ YSZ过渡层 /YSZ陶瓷层。YSZ陶瓷层的结构为柱状晶结构,Al₂O₃ YSZ梯度过渡层为梯度微孔结构。采用有限元方法对梯度热障涂层进行热应力分析,优化了Al₂O₃ YSZ梯度过渡层的组成。计算结果表明,梯度涂层的内应力显著降低,而且界面及其附近应力和应变变化较平缓。过渡层厚度的增加有利于降低涂层内应力和缓和涂层界面处的应力集中。     

EB-PVD制备箔材的厚度均匀性研究

从真空蒸镀中使用的小平面蒸发源理论出发,针对电子束物理气相沉积中为改善箔材厚度分布所须旋转大基板进行蒸镀的情况,建立了该过程的数学模型;并利用该模型对不同的坩埚位置所沉积的箔材厚度进行了定性分析,从而实现了对坩埚与基板相对位置的优化,使基板上沉积的箔材厚度分布可以达到最均匀的状态.最后通过K值的提出使理论和实际箔材厚度的结果趋于一致,即证明所建立的数学模型是合理的.