尾缘吹气稳定器初始雾化场实验及对燃烧计算的改进

利用激光测雾仪(PDA)对尾缘吹气式火焰稳定器尾缘出口的初始雾化场进行了实验研究, 在静止空气中测量了尾缘出口下游不同截面上的各点处的液滴直径、速度等参数, 分析了雾化场结构, 初步探讨了初始雾化场的特征.同时, 根据初始雾化场的实验结果给出燃烧数值模拟的初始雾化条件, 并把计算结果与燃烧实验数据和经验数值计算结果进行对比, 分析了实验初始雾化场数据对燃烧数值计算的改进效果.结果表明, 初始雾化场实验数据对燃烧室出口温度分布及燃烧效率的计算, 都有一定程度的改进, 其中对燃烧效率计算的改进效果更为明显.      

凹腔驻涡模型燃烧室内涡的演化发展

使用大涡模拟对凹腔内双驻涡冷态流场进行了分析研究.结果发现, 在主流、前后壁面射流的情况下, 凹腔在某些特定几何条件下会产生准周期生成和破碎的驻涡, 同时研究了凹腔内准周期驻涡的生成发展的过程, 得到了影响凹腔内涡演化的新结果.      

尾缘吹气稳定器与前方溅板式喷油匹配试验

使用了一种作为主流供油的侧喷挡板喷油杆,研究了主流供油与尾缘吹气稳定器局部供油的燃油匹配规律,揭示了尾缘吹气稳定器的性能特点.同时,为了验证侧喷挡板这种新的燃油匹配方式是否具有优越性,使用两种不同型式的火焰稳定器作为主稳定器,将其与一种逆喷挡板匹配方式的燃烧性能进行了对比分析.结果表明,在试验参数范围内,使用吹气稳定器作为主稳定器,侧喷挡板的燃烧性能好于逆喷挡板.      

Combustion modeling in a model combustor

The flow-field of a propane-air diffusion flame combustor with interior and exterior conjugate heat transfers was numerically studied.Results obtained from four combustion models,combined with the re-normalization group(RNG) k-ε turbulence model,discrete ordinates radiation model and enhanced wall treatment are presented and discussed.The results are compared with a comprehensive database obtained from a series of experimental measurements.The flow patterns and the recirculation zone length in the combustion chamber are accurately predicted,and the mean axial velocities are in fairly good agreement with the experimental data,particularly at downstream sections for all four combustion models.The mean temperature profiles are captured fairly well by the eddy dissipation(EDS),probability density function(PDF),and laminar flamelet combustion models.However,the EDS-finite-rate combustion model fails to provide an acceptable temperature field.In general,the flamelet model illustrates little superiority over the PDF model,and to some extent the PDF model shows better performance than the EDS model.      

冲击-发散冷却火焰筒浮动瓦片三维壁温计算分析

论述了采用冲击-发散冷却技术的火焰筒浮动瓦片的传热计算分析方法, 以及传热数学模型和边界条件处理.并采用ANSYS程序的热分析模块对浮动瓦片的三维壁温场进行了计算.计算结果与试验结果进行了对比分析, 两者有较好的吻合性, 计算值与试验值的相对误差不大于6%.      

不同半径圆柱诱导CH4/空气预混燃烧的计算研究

本文研究不同半径圆柱诱导CH4/空气预混燃烧流场。采用保自由流5阶WENO格式求解贴体坐标变换后的多组分Euler方程,用基元反应模型描述CH4/空气燃烧。不同于标准WENO格式通量构造方法,该WENO格式数值通量由方程的解进行WENO插值得到,在曲线坐标系下具有保自由流性质。首先给出了保自由流WENO格式精度和保自由流的数值验证,然后计算圆柱诱导CH4/空气预混气燃烧流场,并考察不同半径圆柱的影响,给出燃烧流场压力与温度等值线和云图、压力和温度沿过驻点线分布。结果表明:在考核计算结果网格无关性基础上,该WENO格式可准确地捕捉激波和火焰阵面形状、激波和火焰面驻点距离,得到的计算结果和文献结果相符。增大圆柱半径,激波和火焰面被推向来流方向,激波和火焰面之间距离也减小。和TVD格式相比,5阶WENO格式采用四分之一的网格数可得到近似相同的计算结果。     

基于红外视频的火灾探测算法

视频火灾探测技术成为火灾探测的主要研究方向之一,该技术的难点是保证对火灾准确快速地探测。针对目前视频火灾探测识别率较低、报警时间较长的问题,为了提高火灾识别率,增强算法实时性,本文提出一种红外视频的火灾火焰探测方法,采用带有截止可见光透红外滤波片的摄像头采集现场红外影像,结合火焰的静态和动态特征,对火灾进行准确快速探测,同时,综合运用火焰圆形度和尖角个数变化判据对稳定火焰和非稳定火焰进行区别,实现对火灾的分级报警。实验结果表明,改进算法对火焰识别的准确性高,抗干扰能力较强,并且具有显著的快速性,其处理速度达到20ms/帧,并且系统平均报警时间小于200ms。     

Performance comparison of aero-ramp and transverse injector based on gas-pilot flame

A direct performance comparison between the four-hole aero-ramp injector and single transverse injector in a dual-mode scramjet combustor was conducted. The mixing characteristics of two injectors were calculated by solving the three-dimensional (3-D) compressible Reynolds-averaged Navier-Stokes equations (RANS), with the help of the shear-stress-transport (SST) k-ω turbulence model. The numerical results show that the far field mixing efficiency of the aero-ramp injector is higher than that of the single transverse injector. High enthalpy vitiated air was heated to a total temperature of 1200K by hydrogen-oxygen combustion, entering the isolator entrance at a Mach number of 2.0. Non-reacting experimental conditions involved sonic injection of nitrogen to safely simulate ethylene injected into the combustor at a jet-to-free stream momentum flux ratio of 2.6. Schlieren photographs were obtained to analyze the shock structure around the injectors. Reacting test conditions involved sonic injection of ethylene at the jet-to-free stream momentum flux ratios ranging from 0.5 to 2.7. High speed camera was used to capture the flame structures in the near-field combustion. The experimental results show that the aero-ramp injector produce sustained combustion over a wider range of fuel-air ratios than the single transverse injector. At the identical jet-to-free stream momentum flux ratio, the aero-ramp has a larger isolator margin than the single transverse injector, demonstrating a better ability for avoiding overflows. However, the air specific impulse and total temperature recovery of two injectors, which are calculated by the one-dimensional (1-D) performance analysis code, are almost identical.      

静力试验位移测量异常原因分析及推算方法研究

分析了发动机机架静力试验过程中某重要位移测点出现位移测量异常的原因,提出了几点改进措施,包括打磨接触面、采用粘贴面积较大的测量块等;另外,考虑到此次静力试验其余测点位移正常、试验过程结构和加载稳定,通过结构整体刚度分析,提出一种利用正常测点来推算异常测点位移的方法,采用两次未出现测量异常的抽检静试数据对此推算方法进行验证,分析推算值与测量值之间的误差,结果表明,这种理论推算方法的推算误差小于5％。     

热射流点火对爆震管内火焰加速及爆震波触发影响的数值研究

为研究热射流点火对爆震管内火焰加速及爆震波触发的影响,运用34步26组分丙烷基元反应进行了二维数值模拟,获得了5种不同的热射流发生器几何结构下的爆震管内火焰传播规律及缓燃向爆震转捩(deflagration to detonation transition,DDT)的时间与距离.结果表明:爆震管中湍流在火焰加速阶段起着重要作用,在爆震波触发阶段激波与火焰相互作用占有主导地位.根据DDT过程的定义,得到DDT时间在1.4~2.0ms之间,同时发现热射流发生器长度为150mm,热射流发生器孔径在8mm时DDT时间最短,热射流发生器长度及孔径对DDT距离的影响不大.