层板发汗冷却推力室板片流道的调节功能试验

为了在设计层板发汗冷却推力室时选择合适的一次调节通道，对不同曲率半径，不同几何尺寸的一次调节通道进行了流阻试验，得出了不同几何尺寸的一次调节通道的流动特性，试验结果与经典的层流理论计算结果之间存在较大的差异，试验表明，一次调节通道的临界雷诺数随曲率半径的减小而减小，摩阻系数随曲率半径的减小而增加，并得出了相应条件下的一次调节通道摩阻系数的修正关系式，在层流范围内阻较好地反映一次调节通道的流阻特性。     

带μP的数字压力表设计

本文分析了硅压阻式压力传感器输出特性与硅电阻元件温度之间的关系。据此,提出了用μP对此类传感器进行温度及非线性等误差补偿的有效方法,以保证采用此类传感器的数字压力表在-20～50℃温度范围内误差≤±0.10％FS,在15～25℃范围内误差≤±0.05％FS。 本文还介绍了带μP数字压力表的硬件和软件,从而较好地解决了在较大温度范围内高精度压力测量的课题。     

皮托管测速技术在低速水洞流场校测中的应用

将皮托管测速技术成功用于大型低速水洞流场校测。通过采取一系列技术措施,有效地提高了皮托管测量低水流速度的可靠性和精度。经测量精确度分析以及与LDA结果比较,表明在水流速度0．5m／s以上,所采用的皮托管系统测量精度能够满足流场校测的要求。测量结果表明北航1．2m×1．0m多用途低速水洞实验段流速不均匀度和稳定性均达到设计指标。该工作为今后同类大型水洞流场校测探索出一条简单可靠的技术途径。     

C/E 复合材料“以磨代钻冶制孔工艺

为了提高C/E复合材料构件制孔加工质量,以C/E复合材料为研究对象,提出"以磨代钻"制孔新工艺,并研制了电镀金刚石刀具.与传统硬质合金刀具钻孔工艺进行对比试验,结果表明:金刚石刀具钻削轴向力降低30%-50%、刀具耐用度提高3-5倍、缺陷显著减少,更适合C/E复合材料钻孔加工.     

RPC-MIP: the Mutual Impedance Probe of the Rosetta Plasma Consortium

The main objective of the Mutual Impedance Probe (MIP), part of the Rosetta Plasma Consortium (RPC), is to measure the electron density and temperature of Comet 67P/Churyumov-Gerasimenko’s coma, in particular inside the contact surface. Furthermore, MIP will determine the bulk velocity of the ionised outflowing atmosphere, define the spectral distribution of natural plasma waves, and monitor dust and gas activities around the nucleus. The MIP instrumentation consists of an electronics board for signal processing in the 7 kHz to 3.5 MHz range and a sensor unit of two receiving and two transmitting electrodes mounted on a 1-m long bar. In addition, the Langmuir probe of the RPC/LAP instrument that is at about 4 m from the MIP sensor can be used as a transmitter (in place of the MIP ones) and MIP as a receiver in order to have access to the density and temperature of plasmas at higher Debye lengths than those for which the MIP is originally designed.     

亚跨超风洞现代试验设计方法研究

开展了基于现代试验设计方法(MDOE)的亚跨超风洞试验研究,以八号标模尾翼为试验对象研究其气动特性,采用同时改变攻角-侧滑角的多变量方法,而不是传统的单变量(OFAT)方法进行试验。对自变量攻角和侧滑角进行试验设计(DOE),应用响应面法建模,用IV-最优方法对测量点分布进行设计。在FD-12亚跨超风洞完成了试验,并和传统的OFAT方法结果进行比较分析。结果表明:MDOE方法获得的数据和传统的OFAT方法的数据吻合很好;MDOE采集样点数减少了46%,吹风的时间比OFAT减少30%左右,提高了风洞试验效率,缩短了试验周期;MDOE试验方法可以给出设计空间内任意给定自变量对应的响应值及其置信区间。     

Robust control for constant thrust rendezvous under thrust failure

A robust constant thrust rendezvous approach under thrust failure is proposed based on the relative motion dynamic model. Firstly, the design problem is cast into a convex optimization problem by introducing a Lyapunov function subject to linear matrix inequalities. Secondly, the robust controllers satisfying the requirements can be designed by solving this optimization problem.Then, a new algorithm of constant thrust fitting is proposed through the impulse compensation and the fuel consumption under the theoretical continuous thrust and the actual constant thrust is calculated and compared by using the method proposed in this paper. Finally, the proposed method having the advantage of saving fuel is proved and the actual constant thrust switch control laws are obtained through the isochronous interpolation method, meanwhile, an illustrative example is provided to show the effectiveness of the proposed control design method.     

Ozone trends in the mid-latitude stratopause region based on microwave measurements at Lindau (51.66° N, 10.13° E), the ozone reference model,and model calculations

We compared 8 years of ozone measurements taken at Lindau (51.66° N, 10.13° E) at altitudes between 40 and 60 km using the microwave technique with the CIRA ozone reference model that was established 20 years ago (Keating et al., 1990). We observed a remarkable decrease in ozone density in the stratopause region (i.e., an altitude of 50 km), but the decrease in ozone density in the middle mesosphere (i.e., up to 60 km in altitude) is slight. Likewise, we observed only a moderate decrease in the atmospheric region below the stratopause. Other studies have found the strongest ozone decrease at 40 km and a more moderate decrease at 50 km, which is somewhat in contradiction to our results. This decrease in ozone density also strongly depends on the season. Similar results showed model calculations using the GCM COMMA-IAP when considering the increase in methane. In the lower mesosphere/stratopause region, the strongest impact on the concentration of odd oxygen (i.e., O₃ and O) was observed due to a catalytic cycle that destroys odd oxygen, including atomic oxygen and hydrogen radicals. The hydrogen radicals mainly result from an increase in water vapor with the growing anthropogenic release of methane. The finding suggesting that the stratopause region is apparently attacked more strongly by the water vapor increase has been interpreted in terms of the action of this catalytic cycle, which is most effective near the stratopause and amplified by a positive feedback between the ozone column density and the ozone dissociation rate, thereby chemically influencing the ozone density. However, the rising carbon dioxide concentration cools the middle atmosphere, thereby damping the ozone decline by hydrogen radicals.     

低速风洞中的洞壁干扰计算

本文按照文[1]的方法,通过壁压测量影响函数法计算洞壁干扰。文中对H/B=0.75、0.8333、1.00,以及矩形切角风洞进行了计算,并在H/B=0.8333的风洞中作了修正试验。计算与试验表明,本文的计算是可靠的,提供的曲线可供实际使用。     

地球卫星星光折射导航量测量及其性能对比

星光折射天文导航是一种重要的地球卫星自主导航方式,量测量是影响其导航精度的重要因素。在地球卫星星光折射导航中,折射视高度、星光折射角、折射星像素坐标（折射星矢量）是3种常用的量测量,结合星光折射导航的基本原理重点介绍了这3种量测量的获取方法和量测模型,通过仿真和可观性分析比较了相同条件下3种量测量的导航性能。仿真结果表明,由于折射星像素坐标可以同时反映星光折射的大小和方向可观性高,而星光折射角和折射视高度仅能反映星光折射的大小,无法反映其方向可观性低,因此折射星像素坐标的导航性能优于星光折射角和折射视高度。此外,本文也对星敏感器精度、卫星轨道高度、星敏感器安装夹角3种因素对3种方法导航性能的影响进行了分析。