Experimental investigation of characteristics of instability evolution in a centrifugal compressor

The stable range of operation for the centrifugal compressor significantly influences the dynamic, economic, and environment-friendly characteristics of power systems. A deep understanding of the characteristics of instability evolution is necessary to improve the compressor stability. A centrifugal compressor equipped with a vaneless diffuser is experimentally investigated using highresponse static-pressure measurements. The results obtained indicate that three typical rotationalspeed ranges ex...     

高精度数字温度计替代标准水银温度计的探讨

用基于工业铂电阻的高精度数字温度计替代标准水银温度计，是当今温度计量的一个研究热点。迄今为止这类产品只能作为工作器具使用，其主要原因是对高精度数字温度计的长期稳定性研究还不充分。介绍了一款高精度数字温度计长达8年的稳定性研究成果，并和标准水银温度计比较，说明用高精度数字温度计替代标准水银温度计是完全可行的观点，同时提出一些具体建议。     

不同孔径金属腹板稳定性及补强措施分析北大核心CSCD

针对金属腹板在不同开孔直径下的剪切稳定性,采用有限元弹性屈曲分析方法进行研究。并为补偿开孔后稳定性的损失,探讨了常用的加强环、法兰的加强方式在不同开孔尺寸下的加强效果。结果表明:金属腹板的稳定性随开孔直径的增加呈下降趋势,增加法兰翻边高度和厚度提高腹板稳定性的效果明显,当翻边高16 mm,法兰厚度1.5 mm时补强效果最好。这是由于增加法兰翻边高度和厚度相当于提高了开孔周边的刚度,而刚度对腹板稳定性有显著的影响。     

Stability characteristics and airworthiness requirements of blended wing body aircraft with podded engines

Blended-Wing-Body(BWB) aircraft have a relatively short fuselage and no horizontal tail, and they usually adopt podded engines and a V tail instead of a vertical tail. Generally,BWB aircraft have decreased longitudinal and directional static stability and damping. In this paper, the three-axis static and dynamic stability characteristics of an example BWB aircraft with podded engines are studied. According to the differences in flight characteristics of BWB aircraft and conventional aircraft, th...     

Adaptive feedback control of stability in an axial compressor with circumferential inlet distortion

The adaptive feedback control of stability with circumferential inlet distortion has been experimentally investigated in a low-speed, axial compressor. The flat-baffles with different span heights are used to simulate different distorted inflow cases. Compared with auto-correlation and root-mean-square analysis, cross-correlation analysis used to predict early stall warning does not depend on the distortion position. Hence, the cross-correlation coefficient was used to monitor the stable status of the compressor and provide the feedback signal in the active control strategy when suffering from different distortions. Based on the stall margin improvement of tip air injection obtained under different distorted inflow cases and the sensitivity analysis of cross-correlation coefficients to injected momentum ratios, tip air injection was adopted as the actuator for adaptive feedback control. The digital signal processing controller was designed and applied to achieve adaptive feedback control in distorted inflow conditions. The results show that the adaptive feedback control of air injection nearly achieves the same stall margin improvement as steady air injection under different distortion intensities with a reduced injection mass flow. Thus, the proposed adaptive feedback control method is ideal for the engine operation with circumferential distorted inflow, which frequently occurs in flight.     

Passive attitude stabilization of ionic-wind-powered micro air vehicles

The ionic-wind-powered Micro Air Vehicles (MAVs) can achieve a higher thrust-to-weight ratio than other MAVs. However, this kind of MAV has not yet achieved controlled flight because of the unstable thrust produced by the ionic wind and the dynamic instability related to the small size. In this paper, a passive attitude stabilization method of the ionic-wind-powered MAV using air dampers is introduced. The key factors that influence the performance of the air dampers, including the layout, position, and area of the air dampers, are theoretically studied. The appropriate optimal position of the air dampers is also obtained by Monte Carlo stochastic simulations. Then the proposed passive attitude stabilization method is applied to the ionic-wind-powered MAVs of different wingspan (2 cm and 6.3 cm). Finally, the experimental results show that using the proposed method, attitude stabilization is achieved for the first time for the ionic-wind-powered MAV. Moreover, the altitude control of an ionic-wind-powered MAV with a wingspan of 6.3 cm is also demonstrated.     

Numerical investigation on leakage and rotordynamic performance of the honeycomb seal with swirl-reverse rings

Honeycomb seals are a crucial component to restrict the leakage flow and improve system stability for the turbomachines and aero-engines. In this work, the leakage and rotordynamic performance of honeycomb seals with the Swirl-Reverse Ring(SRR) is predicted by employing the approach of Computational Fluid Dynamics(CFD) and the multifrequency whirling model theory.Numerical results show that the positive preswirl flow and circumferential velocity can be effectively weakened for the honeycomb seal...     

遥感卫星多路数据传输系统同频共用方法

为节省频率资源，遥感卫星通常采用扩频体制实现多路数据的同频共用传输，针对通道间容易引起相互干扰的问题进行了研究，通过改进码分多址干扰估算模型，对采用平衡Gold码序列扩频系统抗干扰容限上界进行预测。在满足国际电信联盟（ITU）对卫星辐射功率通量密度约束条件下，提出了一种基于直接序列扩频体制的两路业务数据同频共用传输方法。仿真结果表明：当载波频率2GHz左右，两路辐射源的EIRP之差不大于8～15dBw时可以实现同频共用传输；如对信号扩频带宽进行差异化处理，则其相互兼容性还可进一步提高。     

天梯动力学与控制研究进展

简要介绍了天梯系统的组成和初始部署形式。在此基础上，针对天梯初始部署和运行中存在的复杂动力学与控制问题，分别从天梯动力学建模、天梯稳定性、天梯绳索振荡、攀爬器运动引起的绳索振荡及振荡抑制、天梯初始部署动力学五个方面分析归纳了天梯动力学与控制的发展状况，最后对天梯动力学与控制的发展方向进行了总结及展望。     

高精度星间测距与超稳振荡器研究

高精度K频段微波星间测距系统（KBR）采用双路微波测距技术,测量精度可达到1μm／s,是地球重力场测量卫星的三大有效载荷之一。作为整个系统时间基准的超稳定振荡器（USO）,是实现KBR微米级测量精度的关键。文章在研究KBR测距技术的基础上,对USO进行了研究和设计,研制成功的USO的短期频率稳定度达到了5×10^-13／s（Allan方差）,达到了指标要求。