编队飞行卫星群描述及摄动分析

定义了一组新的编队飞行卫星群相对运动描述参数 ,以及基于此的构型设计方法 ;并分析了地球非球形摄动对这组参数的影响 ,给出了为消除摄动长期影响所需的速度脉冲量 ,并对部分参数给出了减少摄动影响的设计方法     

移动质心飞行器的参数辨识和补偿控制

受质量块大小和位移的限制,移动质心不能像空气舵那样产生很大的力矩.因此飞行器的再入攻角对静稳定度很敏感,尤其在小静稳定度下,静稳定度稍有改变,配平攻角将发生很大变化.飞行器再入过程中的烧蚀、侵蚀以及边界层转捩所造成的小不对称量所产生的不对称力矩与质心移动后产生的控制力矩相比,不是小量.以所建立的移动质心控制飞行器的数学模型为基础,辨识飞行器静稳定度和小不对称量,对小不对称量造成的气动力矩用前馈一反馈复合控制加以补偿.仿真分析表明,移动质心控制对高速再入的飞行器具有良好的末修能力,能有效提高再入段的控制精度.     

Analytical expression for distant retrograde orbits around a small natural satellite

An analytical expression for distant retrograde orbits (DROs) is obtained in this study. Owing to the fact that a planar DRO is a closed orbit and can be expressed as an approximately elliptical orbit, respective geometries and periods of DROs are analytically calculated. A switching point, where various properties of planar DROs change abruptly with an increase in the orbital radius, is determined. The Mars–Deimos system is taken as a case study in this work. The proposed method can be applied to cases where the Hill’s approximation of the restricted three-body problem is valid. Numerical calculations are performed to validate the proposed method.     

Influence of deformation zone length on bending radius of SS304 tubes with small diameters manufactured via free bending-based active motion

In three and six-axis free-bending equipment, the deformation zone length(A) is a fixed mechanical structure parameter modified when the relevant structure is redesigned and manufactured. In this study, a six degree of freedom(6-DOF) parallel mechanism was used as the control mechanism of the bending die, and a new method of changing the deformation zone length(A)was proposed. Firstly, an idealized geometric model of free bending-based active motion was established. Then, the influence of the de...     

固体运载器在航天领域的地位及作用

结合我国固体发动机的实际水平，讨论了发展上型固体运载器的现实性，可行性以及可达到的运载能力，并根据当前世界空间技术发展动态，简述了固体技术在我国航天领域的地位及作用。     

单站多普勒跟踪定轨的优化算法

由于低轨道小卫星应用的日益广泛，在轨卫星数目的迅速膨胀，对传统的多个地面站相互协调管理卫星领域模式提出了挑战。小卫星的低成本特性必然要求存在与之相应的地面站设施降低复杂性、降低成本。本文针对当前已提出的单站多普勒定轨方案，进一步研究了多普勒定轨的有关方法，提出和建立了多普勒定轨的优化算法与模型，最后进行了仿真分析与模型的有效性验证。     

我国小卫星、微小卫星有效载荷的发展

文章简要介绍了国内外小卫星、微小卫星的发展历史,分析了适用于小卫星、微小卫星的有效载荷的发展趋势,简单介绍了我国光学有效载荷的研究现状,通过归纳分析,就有效栽荷实现体积小型化、功能单一化、接口标准化提出了解决方法。     

Asteroid and comet hazard: Identification problem of observed space objects with the parental bodies

This article focuses on the genetic identification of observed small cosmic bodies with alleged parental bodies; namely, comets, asteroids and meteoroid swarms. There is a problem of the upper D-value limit as a measure of proximity between the orbits of the bodies in the five-dimensional phase space (Southworth and Hawkins, 1963). In the study of genetic relationships of the comet and meteor complexes, the D value is usually taken as equal to 0.2 for all meteor showers. However, the upper D limit should be investigated for each meteoroid complex. For example, such investigation was performed for the Taurid meteor complex (Porub?an et al., 2006). In this paper, the upper D-criterion limit value was investigated for the Perseid meteor shower. The 1862 III Swift–Tuttle comet is its parental comet.     

小积液情况下卧式转子的稳定性实验研究

盘腔积液现象在舰用燃气轮机工作过程中时有发生，汽化的滑油和水蒸气凝结形成积液。转子带动腔内的积液旋转，引发振动失稳，严重时会对发动机结构造成致命性破坏。为此，本文开展燃气轮机压气机盘腔积液的模拟实验研究，以双盘双支承的卧式柔性转子系统作为研究对象，重点关注小积液量的特点，对积液转子的动力学稳定性进行了研究。观测到转子的失稳现象，开展了不同积液体积、不同积液类型（水、植物油和滑油）等因素的影响规律研究，揭示了小积液的卧式转子动力学特征。研究结果表明：①对于积液失稳振动，存在失稳边界积液量，当积液量大于该边界值时，失稳将会发生。②失稳边界转速及恢复转速均高于临界转速。当转速高于失稳边界转速时，失稳将会发生。转速进一步增加，高于恢复转速时，失稳现象可能消失。③失稳时的振动特征为：出现幅值突增，次谐波成分也随之增加；基频和次谐波发生调制，表现出拍振特征。④随着积液体积的增加，失稳边界转速先减小后增加。⑤随着积液粘度系数增大，失稳边界转速和边界积液量均增大。     

有机小分子杂化阻尼材料研究进展

从组成、制备工艺、阻尼机理讨论了有机小分子杂化阻尼材料的研究现状，并给出了一些该类阻尼材料的实例及其阻尼性能数据，提出了有机小分子杂化阻尼材料目前存在的问题，指出该类阻尼材料阻尼性能突出、Tg可设计，是一种颇有前景的材料。