封闭腔内旋转圆盘阻力扭矩特性和微沟槽减阻研究

为了研究旋转圆盘的微沟槽减阻的作用机理,结合离心泵圆盘减阻问题,采用数值模拟的方法对封闭腔体中旋转圆盘的流场进行了仿真计算,并对微沟槽减阻的效果和作用机理进行了分析.计算结果显示,较小的法向间隙和微沟槽都能够起到减阻作用,最大减阻率为13.1％.对壁面参数和流场结构的分析表明,产生减阻效应的原因是法向间隙和微沟槽改变了...     

模型燃烧室中值班火焰稳定器的燃烧不稳定性研究

针对值班火焰的燃烧不稳定性问题，通过试验得到了不同当量比工况下的火焰结构、压力脉动信号和热释放脉动信号。对脉动信号进行傅立叶分析，获得了脉动信号的频率和振幅。结果表明，随着当量比增加，火焰形态发生变化，燃烧室内发生了164Hz三阶模态向109Hz二阶模态的转换。对火焰平均结构、火焰瞬态结构和火焰正交分解（POD）结果进行分析后发现，漩涡脱落频率和燃烧室某一阶声学模态耦合是维持燃烧不稳定性的机理，耦合的强弱和漩涡脱落的尺度大小决定了热声振荡的振幅大小，火焰形态的变化导致热释放中心位置的变化是引起模态转换的机理。     

Effects of swirler position on flame response and combustion instabilities

This study is concerned with the experimental and theoretical investigation of the combustion instabilities in a premixed swirl combustor. It is focused on the effects of the swirl mixing distance on the intrinsic thermoacoustic mode. The swirler as an origin of the swirling flow is also the source of the flow disturbance, which has effects on the flame response. The location of the swirler is varied in the experiment to study the effect on combustion instabilities and flame transfer functions. ...     

Experimental investigation of characteristics of instability evolution in a centrifugal compressor

The stable range of operation for the centrifugal compressor significantly influences the dynamic, economic, and environment-friendly characteristics of power systems. A deep understanding of the characteristics of instability evolution is necessary to improve the compressor stability. A centrifugal compressor equipped with a vaneless diffuser is experimentally investigated using highresponse static-pressure measurements. The results obtained indicate that three typical rotationalspeed ranges ex...     

Experimental study on flow excursion instability of supercritical hydrocarbon fuel in scramjet regenerative cooling parallel channels

Flow instability of supercritical hydrocarbon fuel is a crucial issue in scramjet regenerative cooling structure. In this study, flow excursion instability and flow distribution in parallel tubes were experimentally studied for supercritical fluids. Two types of flow excursion occur in a single tube. Type I and Type II excursions, and they are corresponding to decreasing and increasing flow rate respectively. They can trigger flow maldistribution between parallel tubes and the hysteresis phenomenon of flow distribution. The effects of system parameters, including inlet temperature, system pressure, and heat flux, on flow distribution were analyzed. In addition, the relationship between flow excursion and the pseudo-critical interval proposed in the literature was established according to the heated tube outlet temperature at the onset of flow instability. Finally, the flow excursion instability boundary was obtained using two dimensionless parameters. These experimental results can provide helpful insight on the mechanism of Scramjet regenerative cooling.     

Similarity phenomena of lean swirling flames at different bulk velocities with acoustic disturbances

In this study, flame responses to acoustic disturbances with different frequencies and amplitudes were experimentally investigated in a lean premixed swirl-stabilized combustor operating at different bulk velocities. The total heat release rate fluctuations and spatial CH* chemiluminescence distributions were captured using a photomultiplier tube and high-speed camera, respectively. The results indicate that the heat release rate exhibits a relatively drastic oscillation and high-order harmonics for low-frequency disturbances. When the bulk velocity and forcing frequency were doubled simultaneously, similar flame structures were observed in the CH* chemiluminescence distributions. As the bulk velocity increases, the gain of the Flame Describing Function (FDF) extends toward the higher frequencies, and the delay time of the flame response decreases. The similarity among FDFs at different bulk velocities was effectively captured by introducing a non-dimensional parameter, defined as the ratio of the flame response delay to the forcing time scale, to replace the dimensional forcing frequency. Furthermore, the availability of the newly defined non-dimensional parameter was verified for flames with different swirl numbers, as this played an important role in determining the flame structures and associated unsteady heat release rate.     

Effect of baffle injectors on the first-order tangential acoustic mode in a cylindrical combustor

Combustion instability is a very important issue in the development of the propulsion systems used in aerospace. It is very important to associate the high frequency combustion instabilities with the acoustic characteristics of the combustion chamber. In this paper, the effects of various baffle injectors which were installed on the injector faceplate on the first-order tangential acoustic mode were investigated theoretically and experimentally. The effects of the gap between adjacent injectors on the first-order tangential acoustic mode in a cylindrical chamber were considered. The acoustic admittance of the injectors was derived. The results showed that the amplitude and frequency of the first-order tangential acoustic mode increase with the increase in the gap between adjacent injectors, but decrease with the increase in the number and height of the baffles. The baffle injectors have a greater influence on the amplitude and frequency of the first-order tangential acoustic mode than the baffle blades.     

旋转爆轰波与涡轮平面叶栅相互作用数值模拟

由于旋转爆轰燃烧室具有自增压特性，可提高热力循环效率，因此将旋转爆轰燃烧室应用于燃气轮机可进一步提高系统的性能。基于非稳态雷诺时均Navier-Stokes方法，采用剪切应力输运k-ω湍流模型，建立旋转爆轰燃烧室与涡轮平面叶栅耦合计算模型，研究旋转爆轰燃烧室内的复杂波系与涡轮叶片的相互作用，分析涡轮叶栅对高频爆轰压力振荡的抑制作用。结果表明：旋转爆轰燃烧室内的燃气在涡轮叶栅内加速，并且在斜激波后的局部区域马赫数的增加更为明显。斜激波与涡轮静转子叶片的前缘、压力面、吸力面以及尾缘相互作用，由于旋转爆轰波不同的传播方向，使得斜激波与静子叶片呈相互垂直或平行，进而形成两种不同的波系结构。涡轮叶栅对高频压力振荡存在明显的抑制作用，涡轮叶栅上下游高频压力振荡幅值的衰减率达到80%以上。研究结果展示了旋转爆轰波作用下涡轮叶栅内复杂波系结构特征，并对基于爆轰燃烧推进技术的应用提供了一定的理论基础。     

Electrochemical behavior of Ti-6.5Al-2Zr-1Mo-1V alloy under rotating condition with periodically fluctuating current density

Titanium alloy plays a crucial role in the electrochemical field due to its excellent corrosion resistance. The passivation and dissolution behaviors of Ti-6.5Al-2Zr-1Mo-1V（TA15） alloy in Na Cl solution were studied by simulating the electrochemical machining process in a rotating condition, which made the anode in a state with alternating high and low current density. Electron probe micro analysis, ultra-depth microscope, scanning electron microscope, and X-ray photoelectron spectrometer were u...     

On a plastic instability criterion for ultra-large radial-axial ring rolling process with four guide rolls

A dynamic mechanical model is proposed to describe the complexing actions of all the rolls on the ring during the ultra-large radial-axial ring rolling(RARR) process with four guide rolls. Based on the model, the calculation models for bending moment and normal stress at any section of the ring are deduced by force method. If the maximum section bending normal stress exceeds the yield stress of the ring materials, the ring will be distorted thus leading to the instability of the RARR process. Ac...