无动力飞行器的制导与控制系统

提出了考虑常值风影响时无动力飞行器的动力学方程。基于变结构控制策略设计了三维的制导律和控制律，以此高度非线性、强耦合、时变的模型为基础进行了六自由度仿真，仿真结果表明这种考虑了风影响的动力学模型更接近实际，制导律和控制律是有效的，具有工程应用价值。     

液氢液氧火箭发动机非线性静态特性仿真与分析

在考虑泵后推进剂温度和密度变化的情况下,建立低温液体火箭发动机非线性稳态工作的数学模型,以设计点参数为初始值采用离散牛顿法对大范围参数扰动下氢氧发动机的静态特性进行仿真,并对包括真空推力和真空比冲在内的重要参数的变化情况做相应的分析;在引入故障影响因素的情况下,针对液体火箭发动机中常见的典型故障模式进行稳态故障效应仿真和分析,为该发动机的故障检测与诊断工作奠定了基础。     

混杂纤维复合材料的界面

本文首先揭示和分析了混杂复合材料的特异现象—混杂效应,并认为混杂效应产生的主要原因是混杂界面。从而对混杂界面进行了研究和论述。指出混杂界面层与单一纤维复合材料界面层不同,为更加不均匀过渡,并以多相、多层次方式存在使混杂复合材料得以多种功能综合于一体。     

空间重粒子击中卤虫卵的定位技术及其生物效应

为了能够估价空间重粒子对单个生物细胞的放射生物学效应,我们设计、制成了卤虫卵-核乳胶夹层式生物包.经搭载我国“8885”卫星飞行数天后回收.用图象分析仪研究了空间重离子在核乳胶上留下的径迹及其分布;并实验观察了卤虫卵的前期发育情况.看到:随星飞行过的卤虫卵与地面对照组相比,其发育能力明显降低,表现为孵化率低且发育时间推迟.实验表明:生物样品板-核乳胶影象定位技术能清楚而比较准确地给出卤虫卵(或其他生物细胞)受重离子作用的信息,是重离子生物效应及其作用机理研究的可行实验手段及分析方法之一.     

地效飞行器发展回顾及前景展望

介绍了国内外地效飞行器发展情况和研制的最新进展,对其特点和应用前景进行了叙述.分析了地效飞行器发展中存在的技术障碍.探讨了地效飞行器的发展方向.     

The accuracy of data from ionosondes for the estimation of hmF2 and the identification of global change in the ionosphere

A long temporal series of simulated ionograms was generated with a superimposed secular variation of −14 km/century on the h_mF2 parameter. These ionograms were interpreted by the automatic scaling program Autoscala. By applying four different empirical formulas, four artificial series of h_mF2 were generated and then processed with the same methods used by other authors for real data sets. Data analysis of the simulated ionograms revealed the artificially imposed long-term trend. These results lead to the conclusion, that regardless of the empirical formula used, the accuracy of h_mF2 from ionosonde measurements would be adequate to observe a long-term trend of −14 km/century.     

偏转弹头导弹控制系统设计与仿真

根据弹头的可偏转特性,利用无根多刚体系统动力学方法建立了偏转弹头导弹的动力学模型,并对通道间的耦合特性及弹头偏转对弹体运动的影响进行了分析。在此基础上,将通道间的耦合及弹头偏转对弹体运动的影响作为干扰项处理,将气动参数的非线性变化等效为标称参数的摄动,利用变结构控制理论设计了偏转弹头导弹的控制器。仿真结果表明,所设计的变结构控制器能够有效地减小和消除俯仰、偏航通道对滚转通道的耦合作用以及弹头偏转对弹体运动的影响,较好地抑制了导弹气动参数的摄动,具有较高的稳态精度和良好的动态性能。     

A simulation study on the mode conversion process from slow Z-mode to LO mode by the tunneling effect and variations of beaming angle

For a particular angle of incidence wave, it is possible for a slow Z-mode wave incident on an inhomogeneous plasma slab to be converted into an LO mode wave. But for another wave normal angle of the incident wave, it has been considered impossible, since an evanescence region exists between two mode branches. In this case we expect that the mode conversion takes place through the tunneling effect. We investigate the effect of the spatial scale of the density gradient on the mode conversion efficiency in an inhomogeneous plasma where the mode conversion can occur only by the tunneling effect. We use the computer simulation solving Maxwell’s equations and the motion of a cold electron fluid. By considering the steepness of the density gradient, the simulation results show the efficient mode conversion could be expected even in the case that the mismatch of the refractive indexes prevents the close coupling of plasma waves. Also, we show for these cases the beaming angle does not correspond to Jones’ formula. This effect leads to the angles larger and smaller than the angle estimated by the formula. This type of mode conversion process becomes important in a case where the different plasmas form a discontinuity at their contact boundary.     

Mach reflection in steady supersonic flow considering wedge boundary-layer correction

Mach reflection in steady supersonic flow is an important phenomenon having received extensive studies, among which simplified theoretical models to predict the size of Mach stem and other flow structure are of particular interest. Past efforts for such models were based on inviscid assumption while in real cases the flow is viscous. Here in this paper we consider the influence of wedge boundary layer on the Mach stem height. This is done by including a simplified boundary layer model into a recently published inviscid model. In this viscous model, the wedge angle and the trailing edge height, which control the Mach stem height, are replaced by their equivalent ones accounting for the displacement effect of the wedge boundary layer, with the boundary layer assumed to be laminar or fully turbulent. This viscous model is shown to compare well with numerical results by computational fluid dynamics and gives a Mach stem height as function of the Reynolds number and Mach number. It is shown that due to the viscous effect, the Mach stem height is increased, through increasing the effective wedge angle.     

空气流速和自热效应对湿度传感器测量准确度的影响

通过对多种典型型号湿度传感器在不同空气流速条件下对同一相对湿度测量结果的变化的实验研究,得出了0～1.5 m/s流速范围内湿度传感器的示值随流速的变化趋势,即示值随流速增大而增大,总变化量最大达2%RH以上,且变化主要发生0.5 m/s以下的低流速情况下,同时传感器表面温度随流速增大而降低,两者变化趋势相互吻合。进一步分析表明,上述现象是湿度传感器的自热效应和空气与传感器之间的对流换热效应共同作用的结果,它给湿度传感器的测量结果带来新增不确定度。