三角翼DBD等离子体流动控制研究进展

现代战机采用较多的三角翼，在大迎角绕流时存在前缘涡破裂等气动问题。作为新型主动流动控制技术，等离子体激励频带宽、响应快、结构简单、便于闭环控制，在解决三角翼气动问题上具有潜力。回顾了介质阻挡放电（DBD）等离子体气动激励的基本原理，及其用于三角翼前缘涡控制的研究进展。从来流条件、几何构型、激励参数等方面分析了DBD等离子体激励对流动控制效果的影响规律；结合不同激励频率下流场演化特性，分析了流动控制机理。最后，从理论研究和工程应用的角度，对三角翼前缘涡控制的发展进行总结展望。     

自制等离子喷枪冷却系统的设计及测试

等离子喷枪是制备热障涂层中的研究重点。目前关于等离子喷枪的研究多集中于喷嘴(阳极)、阴极,鲜有关于喷枪冷却系统方面的研究;喷枪冷却系统的优劣直接影响喷枪的工作寿命和喷涂过程的稳定性,同时制备热障涂层的质量也与冷却效果紧密相关。本文利用三维模型,详细阐述了自制的喷枪冷却系统通道及工作原理,并对设计进行了理论计算,对自制的喷枪进行点火试验和喷涂测试,结果显示自制的喷枪冷却系统功能良好,喷枪工作稳定,涂层质量较好。     

Application of small-size antennas for estimation of angles of arrival of HF signals scattered by ionospheric irregularities

A modification of the Doppler Interferometry Technique is suggested to enable estimating angles of arrival of comparatively broadband HF signals scattered by random irregularities of the ionospheric plasma with the use of small-size weakly directional antennas. The technique is based on the measurements of cross-spectra phases of the probe radiation recorded at least in three spatially separated points. The developed algorithm has been used to investigate the angular and frequency-time characteristics of HF signals propagating at frequencies above the maximum usable one (MUF) for the direct radio path Moscow-Kharkiv. The received signal spectra show presence of three families of spatial components attributed, respectively, to scattering by plasma irregularities near the middle point of the radio path, ground backscatter signals and scattering of the sounding signals by the intense plasma turbulence associated with auroral activations. It has been shown that the regions responsible for the formation of the third family components are located well inside the auroral oval. The drift velocity and direction of the auroral ionosphere plasma have been determined. The obtained estimates are consistent with the classical conception of the ionospheric plasma convection at high latitudes and do not contradict the results of investigations of the auroral ionosphere dynamics using the SuperDARN network.     

Spectroscopy peculiarities of thermal plasma of electric arc discharge between electrodes with Zn admixtures

Plasma of the free burning electric arc between Ag–SnO₂–ZnO composite electrodes as well as brass electrodes were investigated. The plasma temperature distributions were obtained by Boltzmann plot method involving Cu I, Ag I or Zn I spectral line emissions. The electron density distributions were obtained from the width and from absolute intensity of spectral lines. The laser absorption spectroscopy was used for measurement of copper atom concentration in plasma. Plasma equilibrium composition was calculated using two independent groups of experimental values (temperature and copper atom concentration, temperature and electron density). It was found that plasma of the free burning electric arc between brass electrodes is in local thermodynamical equilibrium. The experimental verification of the spectroscopic data of Zn I spectral lines was carried out.     

基于新型丝状电极等离子体激励器的前体涡控制

本文首次将新型丝状暴露电极DBD等离子激励器应用于大迎角下细长体非对称涡控制.丝状暴露电极的材料的选择对DBD推力以及推力效率至关重要,通过地面精细推力测量对丝状暴露电极等离子体激励器进行了优化,结果表明,本文研究材料中采用钨丝作为暴露电极,其推力效率最优;且随着电极直径从d=0.3 mm减小到d=0.08 mm,DB...     

等离子体气动激励抑制压气机叶栅角区流动分离的仿真与实验

进行了等离子体气动激励抑制低速压气机叶栅角区流动分离的数值仿真研究,并进行了实验验证.小攻角情况下,叶片吸力面角区流动分离导致显著的尾迹总压损失.来流速度为50 m/s(雷诺数为223 000)时,等离子体气动激励可以有效的抑制角区流动分离,降低总压损失.激励电压、频率分别为10 kV和22 kHz时,50%叶高处的尾迹压力分布基本不变,60%和70%叶高处的最大总压损失分别减小了13.83%和10.74%.增加激励电极组数或激励电压,可以增强抑制效果.      

脉冲等离子体推力器放电波形设计评估仿真研究

运用磁流体动力学的方法,对脉冲等离子体推力器推力室工作过程开展三维双温MHD数值仿真,并开展对推力室的工作机理的分析研究。通过该模型计算得到的推进剂烧蚀质量和元冲量与实验结果相符,同时针对不同初始电压、电容以及两种特征波形的情况进行评估,为推力器的放电波形设计提供指导依据。结果显示在推力器波形设计的初期,是采用电流高变化率低能量水平,还是采用电流低变化率高能量水平,需要结合实际,进行优化评估。     

脉冲等离子体推力器羽流特性数值研究

以脉冲等离子体推力器羽流为研究对象,建立三维物理模型,简化并离散电子动量方程,运用单元粒子-直接模拟蒙特卡罗混合法模拟非稳态羽流流动.假定脉冲周期内推进剂粒子按正弦规律进入流场,分析流场中电势、电子、离子和原子数密度分布随着时间变化情况,并通过与已有实验数据的对比验证仿真模型.研究表明:模型能在垂直和平行于推力器极板的两个平面内预测等离子体羽流流场参数.该研究方法、结果对更深入研究脉冲等离子体推力器(PPT)羽流具有参考价值.      

介质阻挡放电等离子体对翼型流动分离控制的实验研究

在低速开口风洞中进行了等离子体激励器对NACA0015翼型流动分离控制的实验研究。采用PIV技术,对翼型绕流流场进行了测量,显示了施加等离子体激励后流场的变化。通过五分量天平对升力和阻力的测量,研究了激励电压和激励频率对翼型流动分离控制的规律。研究表明,低风速下在翼型前缘施加等离子体激励,能够有效地控制翼型流动分离,在来流为20m／s时,最大升力系数增加11％,失速迎角增加6°;在给定的流动状态下,激励电压和激励频率存在一个阈值,不同迎角下该阈值不同,迎角越大,分离越严重,对激励强度的要求也越高。     

等离子体对翼型流动分离控制历程的PIV试验研究

采用粒子图像测速（Particle Image Velocimetry,PIV）技术,研究了介质阻挡放电等离子体激励对NA—CA0015翼型表面流动分离的控制特性及控制效果随时间历程的变化规律。结果表明,激励电压存在一个阈值,当电压小于阈值时,控制无效或效果不明显;当电压接近阈值时,控制表现出不稳定性并最终趋于稳定;当电压大于阈值时,控制效果稳定且显著,气流能够很好地重附在翼型表面。