Effects of Mach numbers on Magnus induced surface pressure

Experimental and numerical methods were used to investigate the Magnus phenomena over a spinning projectile. The pressure force acting on the surface of a spinning projectile was measured for various cases by employing a relatively novel experimental technique. A set of miniature pressure sensors along with a data acquisition board, battery and storage memory were placed inside a spinning model and the surface pressure were obtained through a remotely controlled system. Circumferential pressures of the model for both rotational and static conditions were obtained at two different free stream Mach numbers of 0.4 and 0.8 and at different angles of attack. The results showed the ability of this new test method to measure the very small Magnus force via surface pressures over the projectile. The results provide a deep insight into the flow structure and illustrate changes in the cross-flow separation locations as a result of rotation. Similar results were obtained by the numerical simulations and were compared with the experimental data.     

均匀各向同性大气湍流对声爆传播特性的影响

基于离散Fourier模态有限和生成的随机大气湍流场，采用修正波形参数方法，开展了均匀各向同性大气湍流对典型超声速客机声爆传播特性的影响分析。计算采用的超声速客机模型为自行生成的简化超声速公务机模型。首先，应用航空工业空气动力研究院自主研制的CFD软件ARI_Overset在三维空间求解Navier-Stokes方程，得到作为声爆远场传播初始值的近场空间压力分布；其次，基于Von Karman能量谱，采用离散Fourier模态有限和形式生成随机均匀各向同性大气湍流场；最后，采用修正波形参数方法模拟了声爆信号在随机速度湍流场中的传播过程。数值结果表明：各向同性大气湍流对于地面声爆特征有重要影响。与无湍流状态相比，均匀各向同性大气湍流使得地面声爆特征增强的概率约为55%，使得地面声爆特征减弱的概率约为45%，故总体而言大气湍流效应更倾向于增强地面声爆特征；均匀各向同性大气湍流对于声爆传播路径影响相对较小，但是这一变化仍会导致地面信号接收点的不确定性。     

热力学排气系统中节流效应及其冷量利用分析

为更好地理解热力学排气系统(TVS)的运行机理，优化其运行参数，针对节流装置，建立了热力学模型，讨论了节流过程中状态参数的变化规律，对比了单相气体、单相液体节流的性能特性，进一步揭示了焦汤节流效应的原理，分析了不同节流背压下节流前低温工质(液氢和液氧)压力和温度对节流性能的影响，并结合TVS实际应用，阐述了节流最大制冷量的利用效果，提出了优化的TVS工作区间。研究表明：在节流过程不发生相变情况下单相气体节流制冷效应要比单相液体节流制冷效应更加显著；而在节流过程发生相变情况下液体节流至两相后，由于空化吸热导致流体温度降低，对于液氢，0.5MPa的压降可产生接近3 K的温降。对于液体节流，节流前压力对节流过程影响可忽略，〖JP2〗而节流前温度和节流背压对节流过程起主导作用；对于液氢在在轨运行工况下，考虑到节流制冷量的充分利用，同时保证换热过程体积含气率不高于90%，推荐TVS系统中节流背压范围为75～143 kPa。     

Aerodynamics of smart flap under ground effect

Aerodynamic characteristics of two-dimensional smart flap under the ground effect have been assessed by a numerical simulation. In this process, a pressure-based implicit procedure to solve Navier–Stokes equations on a nonorthogonal mesh with collocated finite volume formulation is used. The boundedness criteria for this procedure are determined from the Normalized Variable Diagram (NVD) scheme. The procedure incorporates the k–ε eddy–viscosity turbulence model. Cantilever beam with uniformly varying load with roller support at the free end is considered for the configuration of the smart flap. The method is first validated against experimental data. Then, the algorithm is applied for turbulent aerodynamic flows around airfoil with smart and conventional flaps for different attack angle, flap angle and ground clearance where the results of two flaps are compared. The comparisons show that the quality of the solution is considerable.     

野战环境下大型飞机超低空气动特性分析

针对野战环境下的大型飞机超低空飞行,采用CFD方法对地面存在前向或横向不对称障碍物时地面效应对气动参数的影响进行了数值分析,包括纵向稳定性和侧向摇晃等问题.研究结果表明,野战等非常规飞行条件下,地面不确定障碍物会造成大型飞机稳定性变差,严重时可能出现纵向点头和横侧向摇晃现象,容易导致触地危险.最后,从现代飞行控制理论角度提出了对常规布局大型飞机进行闭环控制的研究思路.     

水下超声速射流对上浮水雷受力特性影响研究

固体火箭发动机具有功率密度大、推力大等优势,常被用于上浮水雷的推进器。然而发动机在水下工作时燃气射流使流场压力发生剧烈脉动,进而影响发动机的推力性能及上浮水雷的受力特性。基于VOF多相流模型和理想气体模型,建立了上浮水雷在不同工作状态(欠膨胀、完全膨胀、过膨胀)下的数值模型,研究了水下燃气喷射流对上浮水雷的受力特性影响。结果显示,欠膨胀工况时,发动机推力平缓,大小为12.2KN,上浮水雷受力未出现负值;完全膨胀时,射流发生颈缩、胀鼓现象位置距离雷体较远,导致发动机推力及水雷壳体受力振荡不剧烈;过膨胀工况时,射流发生颈缩、胀鼓现象距离喷管较近,发动机推力发生剧烈脉动,产生21.37%的振荡幅度,胀鼓现象发生时,流场压力显著降低使得上浮水雷后体受力减小,壳体阻力增大,上浮水雷最大产生27KN的负推力。     

Experimental investigations of the spray structure and interactions between sectors of a double-swirl low-emission combustor

In this paper, the spray characteristics of a double-swirl low-emission combustor are analyzed by using Particle Imaging Velocimetry (PIV) and Planar Laser Induced Fluorescence (PLIF) technologies in an optical three-sector combustor test rig. Interactions between sectors and the influence of main stage swirl intensity on spray structure are explained. The results illustrate that the swirl intensity has great effect on the flow field and spray structure. The spray cone angle is bigger when the swirl number is 0.7, 0.9 than that when the swirl number is 0.5. The fuel distribution zone is larger and the distribution is more uniform when the swirl number is 0.5. The fuel concentration in the center area of the center plane of side sector (Plane 5) is larger than that of the center plane of middle sector (Plane 1). The spray cone angle in Plane 5 is larger than that in Plane 1. The width of spray cone becomes larger with the increase of Fuel–Air Ratio (FAR), whereas the spray cone angle under different fuel–air ratios are absolutely the same. The results of the mechanism of spray organization in this study can be used to support the design of new low-emission combustor.     

螺旋桨目标的雷达回波信号相位解缠技术

建立了螺旋桨的雷达回波信号模型。对模型回波信号的相位混叠效应进行了理论分析,讨论了回波相位混叠效应出现的原因,通过模型改进获得了螺旋桨的雷达回波相位的理论表达式。提出插值与可调门限相结合的算法和自适应数值积分算法两种相位解缠方法,分别用于桨叶数为偶数和奇数时的相位解缠。仿真结果表明:两种算法有较高的精度。     

运动的核弹比静止的核弹威力小?——多普勒效应、红移、光行差和动体的质能当量关系

证明爱因斯坦立足于光速不变假设和长度收缩假设的洛伦茨变换未能正确地解释多普勒效应、红移和光行差现象;他也未能给出正确的动体的质能当量关系.作者立足于完全符合相对性原理的伽利略变换,成功地解决了上述问题.     

小不对称物体配平性能风洞实验研究

用阶跃响应法,在风洞中测量小不对称物体配平性能的实验原理、实验装置、数据处理及部分实验结果。 模型支承于空气静压轴承。在模型内部设有电磁机构,在一次吹风中,可以阶跃方式多次提供不对称量。由高精度、非接触的感应同步器数字测量模型俯仰角变化历程。用修正Newton-Raphson法处理数据,求出小不对称量引起的配平角δ_o、俯仰力矩C_mo和气动刚度C_ma、气动阻尼C_mq等参数。 对11°斜切锥,钝度比分别为0.06及0.16的模型进行了风洞实验。实验M数为33.5和4。实验结果表明,所采用的实验原理、设备及方法可提供较好的精度及分辨率。实验还求出了配平性能(δ_o,C_mo)以及C_ma,C_mq随M数的变化。