用FVM法计算固体火箭羽流的红外特性

建立了有限体积法(FVM)的理论模型模拟固体火箭羽流的红外特性,研究了燃气组分H2O,CO2,CO,HCL,OH,NO的吸收和发射,以及AL2O3粒子云的吸收、发射和散射,还研究了两相流场中气相和粒子云温度不均匀时对辐射传输方程的修正。计算一单喷管固体火箭的二维轴对称羽流在光谱2~5μm的红外特性,给出羽流辐射的空间分布和光谱分布并与文献计算的结果对比。研究表明:有限体积法能较好地模拟固体火箭羽流的红外特性;粒子辐射占固体火箭羽流红外辐射的主要部分;在光谱2~4μm粒子辐射使羽流辐射增强,而在光谱4~5μm粒子辐射使羽流辐射减弱。     

航天器的防污染技术

简单介绍了航天器污染的概念,污染对航天器的损害,航天器污染研究的重要性,以及国内外航天器防污染研究概况。着重介绍真空热试验中的污染控制方法。引入航天器自污染的概念,介绍消除航天器自污染的有效办法是真空烘烤。     

多机并联火箭羽流流场及其底部热环境分析

For the problem that the plume flow field structure of a multi engine parallel rocket is complicated and the bottom thermal environment is extremely harsh, which may cause the failure of the engine structural components, the plume flow field and thermal environment at different altitudes are studied through numerical simulation. The result is compared with the measured results in flight which shows that when the rocket is flying at a low altitude, the plume of the engines do not interfere with each other. As the flight altitude increases, the plumes gradually expand and begin to interfere with each other, and finally there is an obvious backflow at the bottom of the rocket. The maximum heat flux at the moment of take off is basically the same as the measured value in flight. Before the backflow occurs, the heat flux mainly consists of radiant heat, the convective heat flow increases as the flight altitude grows, but it is also much smaller than the peak heat flow at takeoff. The result has certain guiding significance for the optimal design of engine structure thermal protection.     

Effect of wall suction on leading edge contamination

This paper is devoted to an experimental study of swept wing leading edge contamination by the turbulence emanating from the wing-wall junction. The main objective is to delay the contamination onset by applying surface suction along the attachment line. Two series of experiments are described; the first one was performed in a small wind tunnel at CERT ONERA, the second one was carried out in the F2 wind tunnel at Le Fauga Mauzac centre. Hot film measurements showed that leading edge contamination could be delayed up to very large Reynolds numbers. We also studied the behaviour of the relaminarized boundary layer downstream of the sucked region, along the span as well as in the chordwise direction.     

天波超视距雷达电离层相位污染典型校正方法综合性能评估

对校正天波超视距雷达电离层相位污染的五种典型方法进行了综合性能评估,主要从校正效果、对不同污染的普适性、污染参数变化对方法的影响、信噪比对方法性能的影响、运算量等几个方面进行了比较与分析,为实际工程实现和改进电离层相位污染校正方法提供参考。     

分子吸附器在航天器污染控制中的应用研究

文章对分子吸附器这种新型的在轨清除航天器分子污染物的方法进行机理分析,研究分子吸附剂和基底材料的选择方法,探讨分子吸附器的吸收力和有效黏附系数的测定方案等,并简要介绍国内的研究现状,分析国内外的差距,提出发展建议。     

脉冲等离子体推力器羽流预测计算研究

为了能够将脉冲等离子体推力器成功地运用于空间,需对其羽流进行研究。将一维 MHD双温放电模型的计算结果作为入口条件,运用DSMC（Direct Simulation Monte\|Carlo ）／PIC（Particle in Cell）流体混合算法一体化模拟实验室PPT羽流。验证计算显示该模 型具有一体化模拟脉冲等离子体推力器羽流的能力。对不同初始放电能量下的羽流场进行模 拟,给出了离子、中性粒子、电子温度、轴线上质量流率和出口平面返流质量流率的变化情 况。计算结果显示高放电能量下返流量更大,同时中性粒子在返流中所占比例也越大。
     

稳态等离子体推力器羽流仿真及其对微波的衰减和相移作用

为了评估稳态等离子体推力器（SPT）羽流对微波造成的衰减和相位变化,使用二维轴对称的PIC-DSMC方法,在空间及室压6mPa的真空舱两种环境下,计算了SPT-100羽流场中的电子分布。在此基础上,通过分析特征频率和计算衰减因子、相位常数,估算了2,4,8,12.5GHz共4个频率微波穿过羽流场时的衰减量和相移。8GHz和12.5GHz微波未发现明显的衰减,相移为10°～120°。2GHz和4GHz微波在喷口附近衰减量范围为10～50dB。仿真结果表明,C波段和S波段在SPT羽流中容易发生衰减,而X波段以上的高频微波衰减量很小,同时这几个波段微波均发生较大相移。真空舱内6mPa背压下对衰减量的预测仅略高于实际飞行情况,但微波相移会有较大误差。     

飞机液压系统中污染物的分析与控制

着重分析了飞机液压系统污染物的来源、生成及其危害,提出了对于控制飞机液压系统污染物的几点粗浅体会,对提高飞机液压系统的可靠性及使用寿命具有参考价值。