基于值域的多约束GNSS单频单历元定姿新算法

多天线增强了全球卫星导航系统（GNSS）单频单历元姿态测量解算模型的强度,但随着天线数量增加,模糊度维数成倍增加,从模糊度域确定搜索空间的计算量将显著增长。基于此,提出了基于值域的多约束多天线GNSS单频单历元姿态测量新算法：该算法将姿态约束融入值域搜索模型,利用姿态约束条件推导搜索步长,通过姿态域三维搜索确定模糊度搜索空间,以基于最优条件姿态解非迭代近似估计的方法固定模糊度。实验结果表明,新算法中模糊度搜索效率较原方法提高约65.8%,固定模糊度效率较标准迭代算法提高约95.3%,且与标准迭代算法性能相当;所提算法能够实现GNSS单频单历元的模糊度固定和载体全姿态测量,具有较高的正确率。     

Inertial parameter estimation and control of non-cooperative target with unilateral contact constraint

In this paper, the relative sliding motion between the target and the manipulator’s end-effector is considered and characterized as a unilateral contact constraint. A new possible solution is presented to estimate the inertial parameters of a non-cooperative target while the relative sliding motion exists. First, the detailed analysis of the dynamical model is presented, and a parameter-explicit linear time-varying model is obtained. Then, an extended state observer is constructed based on the new model, which can effectively estimate the unknown inertial parameters of the target when relative sliding motion exists. As the modified reactionless controller requires the knowledge of inertial parameters, a hybrid post-capture control scheme is also established based on the switch law between different controllers. The correctness and efficiency of the proposed algorithm are validated by numerical simulation, which proves a potential framework for the non-cooperative target post-capture operation.     

Parameter studies and evaluation principles of delamination damage in laminated composites

Delamination represents one of the most severe failure modes in composite laminates, especially when they are subjected to uniaxial compression loads. The evaluation of the delamination damage has always been an essential issue of composite laminates for durability and damage tolerance in engineering practice. Focusing on the most typical and representative elliptical delamination issue, an analytical model simultaneously considering the conservative buckling process and non-conservative delamination propagation process is implemented. Various computational cases considering different delamination depths, directions, aspect ratios, and areas are established, and the predicted results based on the analytical model are carefully compared. Effects of these geometrical delamination parameters on the buckling, delamination propagation, and failure behaviors of composite laminates are thoroughly analyzed, and innovative evaluation principles of the delamination damage have been concluded. It is found that the delamination area is the key factor that truly affecting the failure behaviors of delaminated composites, and the local / global buckling and failure loads show clear linearity with the delamination area, whilst the delamination depth and direction only have slight effects.     

一种高光谱图像的双压缩感知模型

高光谱图像因其海量数据性,给存储、传输及后续分析处理带来了挑战。压缩感知理论提供了一种全新的信号采集框架。针对高光谱数据的三维特性,提出一种双压缩感知的采样与重构模型。该模型在采样阶段兼顾高光谱数据的空间和谱间稀疏特性,构造了能同时实现空间和谱间压缩采样的感知矩阵;重构阶段不同于传统的压缩感知重构方法直接重构高光谱数据,而是将高光谱数据分离成端元和丰度分别进行重构,然后利用重构的端元和丰度信息合成高光谱数据。实验结果表明,所提双压缩感知在低采样率下重构精度较三维压缩采样提高了10 dB以上,更为显著的是运算速度提升了3个数量级,同时该方法还便于获得端元和丰度信息。     

控制力矩陀螺磁悬浮转子的指数趋近积分滑模控制研究

针对微重力、动框架等多源扰动下磁悬浮控制力矩陀螺磁轴承转子系统的强非线性、参数摄动及未建模动态等问题,开展控制力矩陀螺的磁轴承转子鲁棒控制研究。建立了磁轴承转子轴向通道动力学模型与电磁力工作点线性化模型,分析了系统参数摄动及未建模动态,并在此基础上提出了一种非线性系统指数趋近积分滑模控制方法,设计了含有电流及位移的积分滑模平面,采用指数趋近律与饱和函数抑制抖振实现到达阶段滑模控制律。实验结果表明：采用该方法可有效抑制滑模的抖振现象,参数摄动时系统具有较佳动态性能,同时在转子转动、框架工作时保证系统良好鲁棒性。     

Analysis on Potential Conflict Frequency of Intersected Air Routes in Terminal Airspace Design

In order to obtain accurate conflict risks in terminal airspace design, the concept and calculation model of potential conflict frequency for intersected routes are proposed. Conflict frequency is represented by the product of horizontal conflict frequency and vertical conflict probability. The horizontal conflict frequency is derived from the probability density distribution of conflicts in a period of time. Based on the recorded radar trajectory data, the concept and model of ROUTE distance are proposed, and the probability density function of aircraft height at a specified ROUTE distance is deduced by kernel density estimation. Furthermore, vertical conflict probability and its horizontal distribution are achieved. Examples of three intersected arrival and departure route design schemes are studied. Compared with scheme 1, the conflict frequency values of the other two improved schemes decrease to 53 % and 24%, respectively. The results show that the model can quantify potential conflict frequency of intersec ted routes.     

The impact of orbital errors on the estimation of satellite clock errors and PPP

Precise satellite orbit and clocks are essential for providing high accuracy real-time PPP (Precise Point Positioning) service. However, by treating the predicted orbits as fixed, the orbital errors may be partially assimilated by the estimated satellite clock and hence impact the positioning solutions. This paper presents the impact analysis of errors in radial and tangential orbital components on the estimation of satellite clocks and PPP through theoretical study and experimental evaluation. The relationship between the compensation of the orbital errors by the satellite clocks and the satellite-station geometry is discussed in details. Based on the satellite clocks estimated with regional station networks of different sizes (∼100, ∼300, ∼500 and ∼700 km in radius), results indicated that the orbital errors compensated by the satellite clock estimates reduce as the size of the network increases. An interesting regional PPP mode based on the broadcast ephemeris and the corresponding estimated satellite clocks is proposed and evaluated through the numerical study. The impact of orbital errors in the broadcast ephemeris has shown to be negligible for PPP users in a regional network of a radius of ∼300 km, with positioning RMS of about 1.4, 1.4 and 3.7 cm for east, north and up component in the post-mission kinematic mode, comparable with 1.3, 1.3 and 3.6 cm using the precise orbits and the corresponding estimated clocks. Compared with the DGPS and RTK positioning, only the estimated satellite clocks are needed to be disseminated to PPP users for this approach. It can significantly alleviate the communication burdens and therefore can be beneficial to the real time applications.     

Instantaneous rainfall estimation using neural network from multispectral observations of SEVIRI radiometer and its application in estimation of daily and monthly rainfall

In the present paper, an artificial neural network (ANN) based technique has been developed to estimate instantaneous rainfall by using brightness temperature from the IR sensors of SEVIRI radiometer, onboard Meteosat Second Generation (MSG) satellite. The study is carried out over north of Algeria. For estimation of rainfall, weight matrices of two ANNs namely MLP1 and MLP2 are developed. MLP1 is to identify raining or non-raining pixels. When rainy pixels are identified, then for those pixels, instantaneous rainfall is estimated by using MLP2. For identification of raining and non raining pixels, 7 input parameters from the IR sensors are utilized. Corresponding data of raining/non-raining pixels are taken from radar. For instantaneous rainfall estimation, 14 input parameters are utilized, where 7 parameters are information about raining pixels and 7 parameters are related with cloud features. The results obtained show the neural network performs reasonably well.     

The effect of spatial truncation error on variance of gravity anomalies derived from inversion of satellite orbital and gradiometric data

The spatial truncation error (STE) is a significant systematic error in the integral inversion of satellite gradiometric and orbital data to gravity anomalies at sea level. In order to reduce the effect of STE, a larger area than the desired one is considered in the inversion process, but the anomalies located in its central part are selected as the final results. The STE influences the variance of the results as well because the residual vector, which is contaminated with STE, is used for its estimation. The situation is even more complicated in variance component estimation because of its iterative nature. In this paper, we present a strategy to reduce the effect of STE on the a posteriori   variance factor and the variance components for inversion of satellite orbital and gradiometric data to gravity anomalies at sea level. The idea is to define two windowing matrices for reducing this error from the estimated residuals and anomalies. Our simulation studies over Fennoscandia show that the differences between the 0.5°×0.5°$0.5°\times 0.5°$ gravity anomalies obtained from orbital data and an existing gravity model have standard deviation (STD) and root mean squared error (RMSE) of 10.9 and 12.1 mGal, respectively, and those obtained from gradiometric data have 7.9 and 10.1 in the same units. In the case that they are combined using windowed variance components the STD and RMSE become 6.1 and 8.4 mGal. Also, the mean value of the estimated RMSE after using the windowed variances is in agreement with the RMSE of the differences between the estimated anomalies and those obtained from the gravity model.     

多退化变量下基于Copula函数的陀螺仪剩余寿命预测方法

针对惯性导航系统中陀螺仪多退化变量条件下的剩余寿命（RUL）预测问题,提出了一种基于Copula函数的多退化变量剩余寿命预测方法。首先,针对退化变量间不同的退化轨迹,采用不同的方法进行退化建模,并对于陀螺漂移系数样本标准差数据波动性随时间递增的特性,提出了一种方差时变的正态随机过程退化建模方法,得到了陀螺仪剩余寿命的边缘分布函数。然后,通过Copula函数来描述退化变量之间的相关性,将得到的剩余寿命的边缘分布进行融合,得到了陀螺仪剩余寿命的联合分布函数。最后,通过陀螺仪实例分析验证了方法的适用性和可行性。