全文获取类型
收费全文 | 65篇 |
免费 | 23篇 |
国内免费 | 15篇 |
专业分类
航空 | 75篇 |
航天技术 | 18篇 |
综合类 | 8篇 |
航天 | 2篇 |
出版年
2023年 | 3篇 |
2022年 | 3篇 |
2021年 | 8篇 |
2020年 | 10篇 |
2019年 | 4篇 |
2018年 | 5篇 |
2016年 | 2篇 |
2015年 | 4篇 |
2013年 | 2篇 |
2012年 | 4篇 |
2011年 | 10篇 |
2010年 | 4篇 |
2009年 | 2篇 |
2008年 | 7篇 |
2007年 | 4篇 |
2006年 | 3篇 |
2005年 | 3篇 |
2004年 | 2篇 |
2003年 | 3篇 |
2002年 | 2篇 |
2001年 | 3篇 |
2000年 | 4篇 |
1999年 | 1篇 |
1997年 | 2篇 |
1996年 | 3篇 |
1994年 | 2篇 |
1992年 | 1篇 |
1989年 | 1篇 |
1986年 | 1篇 |
排序方式: 共有103条查询结果,搜索用时 15 毫秒
11.
为研究背压对撞击式喷嘴雾化特性的影响,将压力的变化等效为气体密度的变化,基于一种树形自适应加密算法,通过直接数值求解不可压Navier-Stokes方程组实现了不同背压条件下射流撞击雾化的数值模拟。首先将数值模拟结果与试验数据进行对比,验证数值模拟的有效性,在此基础上开展了高背压条件下雾化过程的数值模拟。结果表明,随着背压的提高,气动力相应增强,液膜的破碎更加剧烈,一次雾化区域的液滴数密度增大,雾场由稀疏向稠密发展;液膜在向下游运动过程中波动速度的幅值逐渐增大,并且随着背压的提高,液膜的波动由线性向非线性转变;背压增大导致破碎长度减小,经过参数修正得到了液膜破碎长度的经验公式,并与试验数据进行了对比;背压对液滴尺寸分布规律没有显著影响,但随着背压的提高,同一时刻大液滴所占的比例提高,整个雾场的Sauter平均直径有增加的趋势,当背压从0.1MPa增大到1MPa时,雾场的Sauter平均直径由155.5μm增大到166.9μm;背压增大,液滴粒径分布的均匀度指数减小,液滴尺寸分布更加不均匀。 相似文献
12.
液态射流撞击是液体火箭推进系统中广泛采用的一种燃料雾化方法,其破碎特征直接影响燃料最终的掺混及燃烧效率。采用直接数值模拟(DNS)工具,研究了低雷诺数(Rel=41)和中等韦伯数(Wel=163)条件下剪切稀化非牛顿射流撞击液膜破碎的问题,着重分析了对角液膜的三维结构、破碎特征和非牛顿特性等。研究结果表明:在所研究的射流参数下,该非牛顿撞击液膜破碎属于Open Rim类别,破碎过程具有三维特性并伴随液丝与边缘的融合、液丝向液滴的转变等时域流动特征。液体的总表面积随时间不断增长,但单位表面积随液膜破碎的发生而下降,液膜扩张半角随时间逐渐增加并趋于恒定值43°,而后部液膜的长度几乎不随时间发生变化。此外,撞击液膜表现出明显的剪切稀化特性,液体内部最低黏性系数仅为零剪切黏性系数的1/5。 相似文献
13.
数值研究了合成射流控制高速压气机静叶栅吸力面角区分离,对比分析了不同射流结构对叶栅内流场结构及气动性能的影响。研究结果表明:合成射流通过周期性地吹气和吸气推迟角区分离、降低总压损失,由于吹气和吸气阶段的作用效果不同,使得叶栅出口损失系数的改善效果呈现出周期性波动。合成射流对通道涡以及角区二次流的有效控制是其取得良好控制效果的关键,当冲角为2°时,局部、全叶高方案最大可使总压损失系数分别降低22.2%和23.8%。由于局部叶高方案无法控制叶展中部的流动,造成该区域的尾迹损失增大,从而导致其流动控制效果弱于全叶高方案。两种射流结构都具有良好的变工况适应特性,全叶高方案在大冲角时逐渐体现出其优势,当冲角为4°时,总压损失系数的改善幅度相比局部叶高方案提高了2.8%。 相似文献
14.
IntroductionBreakup and atomization of roundliquidjetshad been widely used in internal combustion en-gines,gas turbines,and liquid rocket engines.Recently,with the development of scramjet en-gines and the deepening of fuel atomization re-search,it attract… 相似文献
15.
针对重复使用火箭垂直着陆过程的喷流流场问题开展研究,利用计算流体力学(Computational Fluid Dynamics, CFD)方法研究了壁面效应和发动机布局对超声速喷流的影响。研究表明,着陆距离(L)在2.24D~11.2D(D为喷管出口的直径)的范围内,地面效应对喷管出口中心处的温度分布影响较小;在当前计算条件下,当L<2.24D时,超声速喷流撞击地面会形成强烈的激波,随着离地高度的降低,该激波位置往喉部方向移动,由于壁面效应,喷管内部形成斜激波,导致中心喷管壁面处的温度升高;中心喷管相对外侧喷管往外突出增大了壁面流动速度,导致外侧喷管出口的温度降低;研究还表明子级火箭底部端面的喷管数量增加后,会导致喷管的温度升高。研究结果将为火箭发射及回收方案选取提供参考。 相似文献
16.
Zero mass flux jets, synthesized by acoustic actuators, have been used for the purpose of jet mixing enhancement and jet vectoring. Zero mass flux jets composed of entirely entrained fluid allow momentum transfer into the embedding flow. In the present experiments, miniature-scale high aspect ratio actuator jets are placed along the long sides and near the exit plane of a primary two-dimensional jet. In different modes, the primary jet can be vectored either towards or away from the actuator jets and the jet mixing is enhanced. The disturbance of the excitation frequency is developed while the unstable frequency of the primary jet is completely suppressed. 相似文献
17.
L. Foschini L. Maraschi F. Tavecchio G. Ghisellini M. Gliozzi R.M. Sambruna 《Advances in Space Research (includes Cospar's Information Bulletin, Space Research Today)》2009
It has been suggested that some radio-loud narrow-line Seyfert 1 contain relativistic jets, on the basis of their flat-spectrum radio nuclei and studies on variability. We present preliminary results of an ongoing investigation of the X-ray and multiwavelength properties of 5 radio-loud NLS1 based on archival data from Swift and XMM-Newton. Some sources present interesting characteristics, very uncharacteristic for a radio-quiet narrow-line Seyfert 1, such as very hard X-ray spectra, and correlated optical and ultraviolet variability. However, none of the studied sources show conclusive evidence for relativistic jets. γ-Ray observations with Fermi are strongly recommended to definitely decide on the presence or not of relativistic jets. 相似文献
18.
低Weber数射流撞击雾化的数学模型 总被引:3,自引:1,他引:2
通过分析低Weber数无粘射流撞击形成液膜雾化的特征, 由质量守恒和动量守恒, 并借鉴前人的理论和实验结果, 推导出Taylor心形波作用下计算液膜厚度和形状的近似解析式, 数值计算结果与文献所给实验数据基本吻合一致。结合矩形喷孔形成的扇形液膜的破碎理论, 进一步计算了不同撞击角下雾化形成液滴尺寸的大小及分布。 相似文献
19.
Periodic atomization characteristics of an impinging jet injector element modulated by Klystron effect 总被引:1,自引:0,他引:1
An experimental study on the Klystron effect of periodic injection modulated by pressure drop fluctuations on subsequent atomization is conducted. Time-resolved atomization backlit images and atomization Mie scatter images are captured by using the high speed camera. It is found that periodicity of forced atomization relies on pressure drop fluctuation amplitude and phase differences between atomization and pressure drop fluctuations relate to fluctuation frequencies. This feature of periodic atomization induced by Klystron effect corresponds to periodicities and high amplitudes of pressure fluctuations in unstable combustion chambers and chaos and low amplitudes of pressure fluctuations in stable combustions chambers. Drastically periodic varying of gross surface area of droplets with time was shown in Mie scatter images. The importance of periodic impinging jet atomization modulated by pressure drop fluctuations for acoustic liquid propellant combustion instabilities is illustrated. 相似文献
20.