2K＋1正则图的自由边

本文利用 Tutte 定理,给出并证明了满足一定条件的2k 1正则图中的每个边都是自由边的结论。     

高分影像辅助下的航空高光谱严密几何检校方法

 惯性测量单元(IMU)与传感器视准轴的偏心角和偏心矢量是造成航空线阵列高光谱数据几何校正误差的主要原因之一。在分析偏心角与偏心矢量误差来源之后提出该误差由IMU主轴与传感器主轴的角度偏差、测区固定偏差、GPS中心与传感器投影中心相对偏差组成,在此基础上建立了较为严密的检校模型。针对模型解算时需要大量高精度控制点的问题,提出了一种高分影像辅助下的亚像元精度控制点自动提取方法。通过多地区、多传感器高光谱航测实验表明,亚像元精度控制点能有效提高模型解算精度。新检校模型可获得亚像元校正精度,推扫式传感器——应用型机载成像光谱仪(AISA)建模中误差约为0.39个像元,摆扫式传感器——实用型模块化成像光谱仪(OMIS)建模中误差约为0.23个像元,校正后的影像可直接进行拼接。     

扇面波导中馈电探针输入电阻数值计算

推导出扇面波导中激励探针的等效输入电阻表达式，探针是伸入波导中的同轴线的内导体，在Ｘ波段，计算了输入电阻值随着探针伸入波导中不同长度的变化。     

光线示波器振子的选用

为了准确地测量记录各种被测信号,应当正确地选用振子的固有频率和阻尼,适当地选取被测信号的大小,保持信号源内阻Ri与振子的内阻rg相匹配,同时要正确地调整光点位置,以减小圆弧误差.     

红外导引头光学系统的像质验收技术

从满足使用要求出发论述了红外导引头光学系统成像质量的验收原理、性能参数和方法。指出了性能验收的影响因素并提出了相应的解决措施。     

高阶对象的二阶模型匹配

本文证明了对于一类高阶对象，其输出可以用一系列系数连续变化的线性定常二阶系统的输出组合完全代替。     

Latitudinal distribution of solar coronal active regions

We studied the cyclic evolution of the latitudinal distribution of solar coronal active regions based on daily images from SOHO EIT for the period 1995–2017. Fully automated software was used, which included the following steps: initial preparation of images in the data series, normalization of histograms and correction of limb brightening, segmentation of images using threshold intensity values obtained from their histograms, scanning of segmented images in heliographic coordinates and obtaining profiles of latitudinal distribution of coronal active regions for each image of the data series. From the output data, we obtained a temporary change in the latitudinal distribution profiles and the migration of activity centers on the solar disk. From the period of minimum activity to the next minimum in both hemispheres, activity centers begin to migrate from high latitudes towards the equator. At the same time, the general center of activity repeatedly changes the direction of migration. The latitudinal distribution of the so-called presence factor of coronal active regions closely resembles the magnetic butterfly diagram, which proves their direct causal relationships. Variations in the presence factor of coronal active regions are correlated with cyclic variations in the sunspot daily numbers.     

Numerical investigation of flow mechanisms of tandem impeller inside a centrifugal compressor

This study numerically investigated a single stage centrifugal compressor ‘‘Radiver’’ with a wedge diffuser and several tandem-designed impellers to explore the flow phenomena within the tandem impeller and the potential to enhance compressor performance. The results demonstrate that tandem design and clocking fraction (λ_s) significantly affects the compressor performance. The compressor stage with tandem impellers of Series A of boundary layer growth interruption alone are observed to have a widely operating range but efficiency and total pressure ratio penalty compared with that of conventional impeller. The tandem impeller with at least the same impeller efficiency as the conventional design is considered as a critical design criteria so that further modification process based on the flow characteristic of tandem impeller is necessary. In order to restrain the inducer wake and exducer shock losses, parameters modification of blade angle and thickness distributions are necessary and the modified tandem impeller of Series B is obtained. The modified tandem impeller with 25% clocking arrangement shows an 8.45% stall margin increase and maintains the total pressure ratio and efficiency as the conventional design, which proves the potential of tandem impeller to improve compressor stage performance. It is noteworthy that the tandem impellers of Radiver have not shown obviously balanced exit flow field and the fundamental mechanism of stall margin extending of tandem impeller lies on the improved impeller/diffuser matching performance resulting from the incidence angle variation at diffuser inlet.     

Collaborative image compression and classification with multi-task learning for visual Internet of Things

Widespread deployment of the Internet of Things(Io T) has changed the way that network services are developed, deployed, and operated. Most onboard advanced Io T devices are equipped with visual sensors that form the so-called visual Io T. Typically, the sender would compress images, and then through the communication network, the receiver would decode images, and then analyze the images for applications. However, image compression and semantic inference are generally conducted separately, and t...     

线性模型跟踪控制系统的模型匹配设计

研究了用完全模型匹配方法求解模型跟踪控制的问题。对通常的模型匹配解法进行了扩展,并所据此引入广义最小方差控制思想,提出一种模型跟踪和误差的新方法。最后,对该方法在惯性导航系统中的应用进行了仿真研究。验证了其可行性和有效性。