手工计划模拟CDA燃油的节省

飞机在飞行中,普遍采用的阶梯下降程序,这需要航空器频繁改变推力、增加下降角度和调整高度,这样加大了飞行员和管制员的工作压力,同时对最后阶段飞行的油量也有增加。通过对连续下降进近（CDA）的现状进行分析,给出连续下降进近相对传统进近方式的优势,并结合航空公司手工飞行计划制作的方法及原理对连续下降进近在最后阶段飞行时间和燃油方面的节约进行验证。     

高逼真度燃油重心控制仿真平台开发

针对现有燃油重心控制仿真手段存在的不足,提出了基于Flowmaster、CATIA与VB交联仿真的燃油重心控制仿真技术方案,重点论述了该技术方案中涉及的燃油质量特性数据库建立和燃油系统交联仿真,在此基础上搭建了燃油重心控制仿真平台。以某型飞机为例,进行了燃油重心控制仿真分析,验证了平台的可行性和有效性。     

碳氢燃料的热稳定性研究：沉积的导热系数试验测定

用保持壁温为常值条件下的装置测定有燃油流动下沉积的导热系数数据。用专门试验段形成沉积及金属板夹层复合结构来测定没有燃油流动下沉积的导热系数值。与文献上结果比较数据的分散性大大改善。本文所用的方法以及结果都较Tevelde和Glickstein的方法及结果为合理。本文所做的试验数据已为工业界所应用。     

苏—27飞机燃油带式综合仪表的原理特点及维修途径

ＣＴＰ７－２ＡＫ燃油油量表－耗量表系统代表了俄罗斯当代燃油测控系统的水平。本文论述了ＣＴＰ７－２ＡＫ产品的组成、工作原理及技术特点，同国产及英美产品当前的技术水平做了比较，并在此基础上提出了今后维修和国产化的途径。     

某型压差活门的动态特性分析

压差活门是航空发动机数控系统燃油计量装置中重要的液压部件,其稳定性和动态性能直接影响控制系统的整体性能。根据压差活门非线性微分方程,采用小偏差线性化方法,推导出了压差活门的动态数学模型,得到了压差活门的方框图以及传递函数。选取某压差活门参数建立了Simulink仿真模型,分别在频域和时域分析了其动态性能。结果表明:在频域上,比较了有无节流器时的回路增益函数伯德图,认为敏感油路上的节流器可以改善稳定性且提高控制精度,通过设计节流器的尺寸可以调节穿越频域,从而改善系统的动态性能;在时域上,分析了不同节流器尺寸下阶跃响应的动态性能,其试验结果与实际工程经验一致。     

航空发动机燃油计量装置特性仿真与试验研究

燃油计量装置作为航空发动机燃油控制系统的执行机构对航空发动机的性能有直接影响,全面掌握燃油计量装置特性是非常重要的。基于AMESim软件建立了航空发动机燃油计量装置的热液压模型,分析了燃油计量装置特性及受温度影响的规律,并通过试验验证了仿真结果。结果表明:建立的模型具有较高的精度,在控制器指令不变的情况下,随着油温的升高,燃油质量流量会有一定程度减小。     

PR状态方程在超临界喷射模型中的应用

针对超临界流体物性的特殊性,对超临界喷射数值模拟方法进行研究。基于PR状态方程建立了考虑超临界流体特点的超临界喷射数值模型,并采用该模型对超临界C10H22喷射到超临界N2环境中的喷射进行了数值模拟。对比研究了采用PR状态方程的真实气体模型和理想气体模型得出的密度、温度、质量分数分布以及超临界喷射长度和喷射扩张角的变化规律和差异性,并与试验数据进行了对比。结果表明:2种模型在物性预测上的差异会造成以上喷射特性模拟结果的巨大差异,理想气体模型模拟结果与试验数据误差很大,利用真实气体模型能够得到与试验数据较为吻合的结果。基于PR状态方程的超临界喷射数值模型准确可靠,可为碳氢燃料的超临界喷射现象提供参考。     

Near-wall topological patterns and flow structures over a simplified Danaus plexippus model

Studies on the high-lift mechanisms of butterfly gliding flights shed light on the design of the micro air vehicles. The flow field around a simplified Danaus plexippus model is investigated using the hydrogen bubble visualization and the Particle Image Velocimetry (PIV) techniques. There are three near-wall topological patterns with different Angles of Attack (AoAs): the separation bubble, the Leading-Edge Vortex (LEV) and the high AoAs flow. For the separation bubble pattern, two saddles and two foci form in the middle of the model. The features of the LEV pattern are the leading-edge separation lines. The topological characteristics of the separation lines are changed by the interaction between the LEV and the Wing-Tip Vortex (WTV). For the high AoAs flow pattern, four unstable foci are found at the forewing and the hindwing respectively. The angle between the trajectory of the WTV and the model increases with increasing AoA even though the slope of the WTV angle versus AoA curve declines at the moderate AoAs.     

One-dimensional numerical investigation on multi-cylinder gasoline engine fueled by micro-emulsions,CNG, and hydrogen in dual fuel mode

This research work is the novel state-of-the-art technology performed on multi-cylinder SI engine fueled compressed natural gas, emulsified fuel, and hydrogen as dual fuel. This work predicts the overall features of performance, combustion, and exhaust emissions of individual fuels based on AVL Boost simulation technology. Three types of alternative fuels have been compared and analyzed. The results show that hydrogen produces 20% more brake power than CNG and 25% more power than micro-emulsion fuel at 1500 r/min, which further increases the brake power of hydrogen, CNG, and micro-emulsions in the range of 25%, 20%, and 15% at higher engine speeds of 2500–4000 r/min, respectively. In addition, the brake-specific fuel consumption is the lowest for 100% hydrogen, followed by CNG 100% and then micro-emulsions at 1500 r/min. At 2500–5000 r/min, there is a significant drop in brake-specific fuel consumption due to a lean mixture at higher engine speeds. The CO, HC, and NO_x emissions significantly improve for hydrogen, CNG, and micro-emulsion fuel. Hydrogen fuel shows zero CO and HC emissions and is the main objective of this research to produce 0% carbon-based emissions with a slight increase in NO_x emissions, and CNG shows 30% lower CO emissions than micro-emulsions and 21.5% less hydrocarbon emissions than micro-emulsion fuel at stoichiometric air/fuel ratio.