飞机进近着陆系统电磁环境建模与仿真

针对现代导航着陆系统附近电磁环境复杂及机场可用空间的日益缩小的现状,提出了用电磁环境建模和仿真的方法来预测和分析电磁散射对着陆系统影响.根据这一方法可以计算出飞机在进近路径上各点的导航参量的变化.实验结果表明,其仿真结果在实际的应用中具有一定的借鉴作用.     

基于MSC/PATRAN的飞机结构强度静力试验数据实时跟踪与处理系统开发

 在Windows环境下,以MSC/PATRAN为平台,利用平台提供的二次开发语言PCL(Patran Command Language),并结合C++语言,通过客户化、增设特定的命令和窗体等技术开发了飞机结构强度静力试验数据实时跟踪与处理系统TestDTAS（Test Data Tracking, Analyzing and Processing System）。在结构试验进行中,TestDTAS可以实时地监测结构试验件中应力和位移的变化情况,并与理论分析结果进行对比,而在试验结束后,TestDTAS可以进行试验数据回放和分析,从而将试验与理论分析有机的结合在一起,对结构静力试验和结构设计有很高的实用价值。     

Periodic Error Compensation for Quartz MEMS Gyroscope Drift of INS

In order to improve the navigation accuracy of an inertial navigation system （INS）, composed of quartz gyroscopes, the existing real-time compensation methods for periodic errors in quartz gyroscope drift and the periodic error term relationship between sampled original data and smoothed data are reviewed. On the base of the results, a new compensation method called using former period characteristics to compensate latter smoothness data （UFCL for short） method is proposed considering the INS working characteristics. This new method uses the original data without smoothing to work out an error conversion formula at the INS initial alignment time and then compensate the smoothed data errors by way of the formula at the navigation time. Both theoretical analysis and experimental results demonstrate that this method is able to cut down on computational time and raise the accuracy which makes it a better real-time compensation approach for periodic error terms of quartz micro electronic mechanical system （MEMS） gyroscope＇s zero drift.     

航天器舷窗玻璃超高速撞击损伤与M/OD撞击风险评估

用北京卫星环境工程研究所的18mm口径二级轻气炮(TLGG)和20 J激光驱动微小飞片装置(LDFF-20)对用作航天器舷窗玻璃的熔融石英玻璃的超高速撞击损伤特性进行了实验研究和分析.其中,TLGG发射的球形铝弹丸直径分别为1 mm和3 mm,速度2～6.5 km/s;LDFF-20发射的圆柱形飞片厚度7 μm,直径1 mm,速度1～8.3 km/s.撞击结果为:对12 mm厚的熔融石英玻璃,直径为3mm的弹丸甚至在2.8 km/s的低速下就将其穿透,而直径为1 mm的弹丸在6.5km/s的高速下没有穿透,这说明弹丸直径对撞击损伤特性有很强的影响;LDFF-20发射的微小飞片的撞击仅在玻璃表面产生很浅的凹坑,没有裂纹产生,但微小飞片的累积撞击损伤明显地降低了玻璃的透光性.实验初步获得了侵彻深度PC、侵彻直径D1与弹丸撞击速度Vp、弹丸质量Mp之间的经验关系.依据实验结果和目前的微流星体/空间碎片(M/OD)环境工程模型,建议对于高度为400 km、轨道倾角42°、寿命为3年的典型航天器,其舷窗玻璃的临界安全(非穿透)厚度至少为12mm.     

转发式干扰下GPS定位精度的仿真分析

根据GPS转发式干扰的原理,建立了转发式干扰对GPS定位精度影响的数学模型.讨论了两种转发式干扰模式对定位的影响.最后通过计算机仿真分析得出了GPS转发式干扰对GPS定位精度影响的相关结论.     

低轨道卫星GPS精密定轨动力学方法的研究

结合低轨卫星简化动力学定轨算法,以及不同几何信息精度条件下的纯几何定轨和动力定轨精度比较,定量分析星载双频GPS实现精密定轨过程中的主要因素,得到星载GPS接收机性能设计所需的关键技术指标,为卫星精密定轨系统的顶层设计提供了科学合理的参考依据。     

空间在轨氢氧内燃机技术研究

用于空间在轨运行的氢氧内燃机是低温末级火箭流体集成系统（IVF）中的关键组件。分析了国内外空间在轨氢氧内燃机的发展现状,通过Chemkin燃烧软件仿真分析获得了氢氧内燃机设计关键参数。开展了氢氧内燃机地面点火验证试验。结果表明：氢氧内燃机具有较好的点火启动性能,通过降低混合比和压缩比能够将氢氧内燃机缸内的温度和压力控制在合理范围内。氢氧内燃机在稳定的转速下工作,所消耗的氢气、氧气质量流量小于低温贮箱的平均蒸发量。     

Pro／E二次开发技术在卫星结构设计中的应用

为解决卫星协同设计过程中总体、结构信息同步滞后问题,基于Pro／E软件进行二次开发,实现对总体与结构接口文件的自动解析;利用解析出来的接口数据,在模型上进行表阵列的自动创建,使总体设计模型的变更能够在结构设计模型中及时得到反映,从而实现“总体一结构”设计结果的快速同步。文章中开发的软件工具,在多颗卫星的研制过程中得到了应用。     

Stochastic modelling considering ionospheric scintillation effects on GNSS relative and point positioning

Global Navigation Satellite Systems (GNSS), in particular the Global Positioning System (GPS), have been widely used for high accuracy geodetic positioning. The Least Squares functional models related to the GNSS observables have been more extensively studied than the corresponding stochastic models, given that the development of the latter is significantly more complex. As a result, a simplified stochastic model is often used in GNSS positioning, which assumes that all the GNSS observables are statistically independent and of the same quality, i.e. a similar variance is assigned indiscriminately to all of the measurements. However, the definition of the stochastic model may be approached from a more detailed perspective, considering specific effects affecting each observable individually, as for example the effects of ionospheric scintillation. These effects relate to phase and amplitude fluctuations in the satellites signals that occur due to diffraction on electron density irregularities in the ionosphere and are particularly relevant at equatorial and high latitude regions, especially during periods of high solar activity. As a consequence, degraded measurement quality and poorer positioning accuracy may result.     

Eliminating negative VTEC in global ionosphere maps using inequality-constrained least squares

Currently, ground-based Global Navigation Satellite System (GNSS) stations of the International GNSS Service (IGS) are distributed unevenly around the world. Most of them are located on the mainland, while only a small part of them are scattered on some islands in the oceans. As a consequence, many unreasonable zero values (in fact negative values) appear in Vertical Total Electron Content (VTEC) of European Space Agency (ESA) and Center for Orbit Determination in Europe (CODE) IONEX products, especially in 2008 and 2009 when the solar activities were rather quiet. To improve this situation, we directly implement non-negative physical constraints of ionosphere for global ionosphere maps (GIM) with spherical harmonic functions. Mathematically, we propose an inequality-constrained least squares method by imposing non-negative inequality constraints in the areas where negative VTEC values may occur to reconstruct GIM models. We then apply the new method to process the IGS data in 2008. The results have shown that the new algorithm efficiently eliminates the unwanted behavior of negative VTEC values, which could otherwise often be seen in the current CODE and ESA GIM products in both middle and high latitude areas of the Southern Hemisphere (45°S∼90°S) and the Northern Hemisphere (50°N∼90°N). About 64% of GPS receivers’ DCBs have been significantly improved. Finally, we compare the GIM results between with and without the inequality constraints, which has clearly shown that the GIM result with inequality constraints is significantly better than that without the inequality constraints. The inequality-constrained GIM result is also highly consistent with the final IGS products in terms of root mean squared (RMS) and mean VTEC.