WANDFULH液压比例阀在多功能液压试验台设计中的应用

比较详细的介绍了世界著名的液压元件公司—WANDFULH（瑞士）的液压比例阀在流量和压力控制方面的几种不同应用,并介绍了相应的Amplifier／oontmller card sd1伺服放大控制板的电路连接和软件应用,以及液压实验台的参数、功能要求和调试过程。     

Numerical Simulation for the 16 August 1999 EUV Brightenings

The 16 August 1999 EUV brightenings are numerically simulated by a third-order upwind compact scheme, basing on the TRACE observation. The present simulation can give a possible explanation to its formation and evolution. The numerical results show that the initial reconnection jets at around X-point are responsible for the occurrence of EUV brightening. The strong and superposed ejections caused by the first and second coalescence of magnetic islands are possibly related to the lifted material which initially appeared as absorption features and Later EUV-emitting structures respectively. The bi-directional reconnection jets may correspond to the lifted material that either continued to move upward along the apparently open field lines or fell down to the surface.      

赤道地区和中纬度地区扩展F的特点和比较

通过数值模拟研究了赤道地区和中纬度地区扩展F的触发机制间的联系,发现相同的触发机制在不同纬度的条件下所演化出的结构形态不相同,因此观测上会有所不同;研究了西向电场在赤道地区的作用,发现在适合的电离层参数组合下会产生观测到的电离层F区顶部扰动出现率高于底部扰动出现率的状况;在数值模拟的基础上提出了一个中纬度地区电波散射的模型,用以解释观测到的中纬度地区电波散射的出现率高于线性理论预期的现象.      

冲压发动机伴随蒸发过程的两相流流场计算

为了计算固液混合式火箭冲压发动机补燃室内带有燃料液滴的流场,用块隐式法计算气相流场,用分离流连续介质模型计算颗粒相的流动与蒸发过程,在控制方程组的联合求荽中,采用特定的算法来体现颗粒相的质量守恒律与尺寸的变化。算例表明,迭代过程能够快速收敛,计算结果定性正确。     

具有复杂边界的火箭冲压发动机流场数值计算

针对实际复杂的补燃结构和计算边界,以块隐式法计算流场,用代数法生成计算网格,通过改变离散方程来处理三维定常Ｎ－Ｓ方程边界条件。算例表明,该方法正确可靠,迭代过程能够快速收敛。     

流量调节器管路系统自激振荡特性研究

流量调节器管路系统在小流量大压降工况下会出现低频自激振荡现象.为了深入认识自激振荡产生机理,结合某稳流型流量调节器及管路系统,基于流量调节器弹簧振子动力学模型开展数值仿真研究.数值仿真得出自激振荡频率为94Hz,与发动机试验结果一致.分析了流量调节器结构参数对系统稳定性的影响作用,三角形滑阀节流口能够抑制管路系统自激振...     

Flow field characteristics,mixing and emissions performance of a lab-scale rich-quench-lean trapped-vortex combustor utilizing a quench orifice plate combined with a bluff-body

In this study, the low emission combustion technology of Rich-Quench-Lean (RQL) has been applied in Trapped-Vortex Combustor (TVC), and the combinative RQL-TVC shows a promising low emissions performance. By utilizing a quench orifice plate combined with a bluff-body, a lab-scale RQL-TVC was designed. The flow fields of RQL-TVC were measured by 2-D PIV and predicted by 3-D numerical simulation. Flow structures, radial profiles of normalized mean axial velocity, turbulence intensity and mixing level of the quench zone were analyzed. Results reveal that the dual-vortex and the single-vortex flow patterns both exist in cavities and quench zone of RQL-TVC, and the turbulence intensity is strong in the quench zone with some reverse flows. The spiral vortex was discussed by 3-D streamlines and the detail flow structures of the quench zone were analyzed based on the numerical results. The mixing level of the quench zone was determined, and results show that the quench device enhances the mixing level compared with TVC. Combustion efficiency and emissions performance were investigated experimentally, and results demonstrate that RQL-TVC has relatively higher combustion efficiency and lower emission index of CO, UHC and NO_x than the same size lab-scale TVC in present work.     

引导场对无碰撞电流片低频电磁不稳定性的影响

通过数值求解无碰撞电流片中可压缩磁流体力学模型下得到的一般形式的色散关系,讨论了无碰撞电流片中引导场对低频电磁波不稳定性的影响.结果表明,平衡态磁场中的引导场,对于三维扰动传播的波不稳定性有很强的影响.(1)在电流片中间平面上(z=0),无引导场时,没有不稳定性发生,但若存在引导场,不稳定性便发生,并随着引导场的增强,不稳定性明显增强,不稳定的波模可能是低混杂模.(2)在中间平面附近(z=0.2),电流片是不稳定的.随着引导场的增强,不稳定性增长率明显地增强,不稳定的波模从平行和反平行两个方向传播变为反平行方向一个方向传播,并且是斜传播的,具有低频哨声模或低混杂模的特征.(3)在电流片边缘附近(z=0.8),引导场对不稳定的波模和增长率没有明显影响,不稳定的波模都是准平行的哨声波.      

几何代数域内的光流场改进算法

提山了一种新的光流场计算方法：首先,在几何代数域内推导了光流约束方程的新形式;然后,在速度场平滑的基础上,通过求解关于初值问题的热传导方程求解光流场;最后,给出光流场的数值解和仿真结果。实验证明此方法是有效的。     

水冲压发动机燃烧稳定性数值研究

建立了水冲压发动机燃烧稳定性计算模型,对一次进水水冲压发动机燃烧室内流场进行数值模拟。研究了燃烧室长度、水燃比、液滴直径等因素对水冲压发动机燃烧稳定性的影响。研究表明,适当增加燃烧室长度、采用多次进水以减小局部水燃比并选取适当的雾化器,有利于水冲压发动机的稳定燃烧。