旋转固体火箭发动机飞行器章动不稳定机理述评

针对旋转固体火箭发动机发射小卫星最末级出现的章动现象,分析了其不稳定机理.根据实际观测的飞行数据,分析了飞行器章动不稳定性的特点,给出了几种可能导致飞行器发生侧向角运动的不稳定性机理,并结合实际情况,对各种机理进行了分析.结果显示,飞行器不稳定运动的主要原因是飞行器的质量变化、内部气流的非稳态流动与飞行器姿态运动的相互...     

MEMS陀螺静态误差补偿方法研究

针对典型MEMS陀螺静态误差大、 影响工程上使用的难题,提出基于时间序列模型的Kalman滤波方法.通过对典型MEMS陀螺数据进行分析,提取其趋势项,进行周期检验与相关性分析,建立时间序列模型;针对建立的时间序列模型,提出利用Kalman滤波方法,消除零位不稳定性.仿真及试验结果表明,该解算方法能够有效补偿MEMS陀螺静态误差,显著提升其静态指标.     

飞机反区时的操纵策略特性及物理机理研究

针对飞机在低动压飞行(如着舰)时处于阻力曲线反区所采用的Frontside操纵和Backside操纵方式,分别从指令控制、风扰抑制、执行机构影响三种情况对两种操纵策略的性能进行了仿真比较,得出相关结论,并分析了其内在物理原因。研究结果表明,Backside操纵性能优于Frontside操纵,具有响应快、超调小、无初始负调、抗风鲁棒性强,以及俯仰角、迎角和升降舵变化小等特点,但同时速度和推力变化大,且执行机构相位滞后对Backside操纵性能影响较大。     

安全阀性能检测系统的测量不确定度

分析了安全阀性能检测系统中的主要误差因素，对安全阀动作性能和排量系数的测量不确定度进行了初步计算。     

The evolution of mirror type magnetic fluctuations in the magnetosheath based on multipoint observations

Two orbits were selected in January–February 2006 when the separation between the Cluster spacecraft was large and mirror type magnetic field fluctuations were observed by all spacecraft in different regions of the terrestrial magnetosheath. Minimum variance analysis was applied to find the mirror type fluctuations, and the amplitude of the fluctuations was determined individually. Mirror mode structures are moving along the streamlines frozen in the plasma. A model was developed for the calculation of plasma flowtime from the bow shock to the observation point. The growth rate of the field strength perturbations was estimated by comparing the amplitudes of fluctuations observed simultaneously at distant locations (∼10,000 km) based on the assumption that δB ∼ exp(γt). The obtained growth rate values were about an order of magnitude smaller than those provided by linear models and they decreased in the inner regions of the magnetosheath, indicating some saturation in the growth of the waves when proceeding towards the magnetopause. The results of these two case studies suggest that mirror type fluctuations originate from the compression region downstream of the quasi-perpendicular bow shock, and the growth of the fluctuations cannot be described by linear approximations.     

Flow separation control on swept wing with nanosecond pulse driven DBD plasma actuators

A 15° swept wing with dielectric barrier discharge plasma actuator is designed.Experimental study of flow separation control with nanosecond pulsed plasma actuation is performed at flow velocity up to 40 m/s. The effects of the actuation frequency and voltage on the aerodynamic performance of the swept wing are evaluated by the balanced force and pressure measurements in the wind tunnel. At last, the performances on separation flow control of the three types of actuators with plane and saw-toothed exposed electrodes are compared. The optimal actuation frequency for the flow separation control on the swept wing is detected, namely the reduced frequency is 0.775, which is different from 2-D airfoil separation control. There exists a threshold voltage for the low swept wing flow control. Before the threshold voltage, as the actuation voltage increases, the control effects become better. The maximum lift is increased by 23.1% with the drag decreased by 22.4% at 14°, compared with the base line. However, the best effects are obtained on actuator with plane exposed electrode in the low-speed experiment and the abilities of saw-toothed actuators are expected to be verified under high-speed conditions.     

Transient simulation of regression rate on thrust regulation process in hybrid rocket motor

The main goal of this paper is to study the characteristics of regression rate of solid grain during thrust regulation process. For this purpose, an unsteady numerical model of regression rate is established. Gas–solid coupling is considered between the solid grain surface and combustion gas.Dynamic mesh is used to simulate the regression process of the solid fuel surface. Based on this model, numerical simulations on a H2O2/HTPB(hydroxyl-terminated polybutadiene) hybrid motor have been performed in the flow control process. The simulation results show that under the step change of the oxidizer mass flow rate condition, the regression rate cannot reach a stable value instantly because the flow field requires a short time period to adjust. The regression rate increases with the linear gain of oxidizer mass flow rate, and has a higher slope than the relative inlet function of oxidizer flow rate. A shorter regulation time can cause a higher regression rate during regulation process. The results also show that transient calculation can better simulate the instantaneous regression rate in the operation process.     

Parametric analyses for synthetic jet control on separation and stall over rotor airfoil

Numerical simulations are performed to investigate the effects of synthetic jet control on separation and stall over rotor airfoils. The preconditioned and unsteady Reynolds-averaged Navier–Stokes equations coupled with a k x shear stream transport turbulence model are employed to accomplish the flowfield simulation of rotor airfoils under jet control. Additionally,a velocity boundary condition modeled by a sinusoidal function is developed to fulfill the perturbation effect of periodic jets. The validity of the present CFD procedure is evaluated by the simulated results of an isolated synthetic jet and the jet control case for airfoil NACA0015. Then, parametric analyses are conducted specifically for an OA213 rotor airfoil to investigate the effects of jet parameters(forcing frequency, jet location and momentum coefficient, jet direction, and distribution of jet arrays) on the control effect of the aerodynamic characteristics of a rotor airfoil. Preliminary results indicate that the efficiency of jet control can be improved with specific frequencies(the best lift-drag ratio at F+= 2.0) and jet angles(40 or 75) when the jets are located near the separation point of the rotor airfoil. Furthermore, as a result of a suitable combination of jet arrays, the lift coefficient of the airfoil can be improved by nearly 100%, and the corresponding drag coefficient decreased by26.5% in comparison with the single point control case.     

相对论性离子束（环束）流引起的电磁不稳定性

在相对论性框架下，研究了冷离子流产生的右旋共振模，非共振模电磁不稳定性的特征结果表明，非共振模不稳定性增长率受离子流初始参数影响较大，而右旋共振模的增长率则受离子流初始参数影响较小。此结果可应用于太阳高能离子流通过低日冕区和地球磁层辐射带俘获的高能质子情形。     

Shock Wave Interaction with the Magnetopause

The magnetopause is in continuous motion and shock waves and impulsive acceleration events can occur. As an example, we show that the interaction of an interplanetary shock with the bow shock can generate a shock wave that after passing through the magnetosheath can interact with the magnetopause. In fluid dynamics, when a shock wave encounters a fluid discontinuity, the interface may become unstable and form bubbles and spikes. We consider this Richtmyer-Meshkov instability in magnetohydrodynamics. At the dayside magnetopause, the instability tends to be stabilized by the magnetic field. However, the shock wave interaction can initiate magnetic field reconnection for the southward IMF, which may be important in strong interplanetary shock events. This revised version was published online in August 2006 with corrections to the Cover Date.