“嫦娥二号”卫星拓展试验轨道计算中心天体的选取

飞行器的星历积分不可避免涉及中心天体的选取问题。“嫦娥二号”卫星在拓展试验期间处于弱引力区,文章针对拓展试验期间的轨道状态,从受摄运动二体问题角度分析得出适宜选取太阳作为中心天体。进而结合真实力模型情况,使用行星星历表计算行星产生的摄动力,从理论上推导得出在忽略小天体摄动的前提下,由于摄动天体同时对中心天体和飞行器产生摄动作用,以地球为中心天体产生的摄动力类似于潮汐力,而以太阳为中心天体则不然,因而更适宜选取地球作为中心天体计算轨道运动问题     

基于EKF容错滤波方法的编队卫星相对轨道自主确定

为避免因卫星测量野值导致的相对轨道估计与滤波精度下降,提出了一种基于残差正交性的扩展Kalman滤波（EKF）容错滤波算法的编队卫星相对轨道确定方法。根据卫星相对运动与相对位置量测方程,用残差序列方差的迹实现对野值的剔除及在线修正,保证滤波器有较强的鲁棒性、稳定性和精度。仿真结果表明：该法简单、有效,有较高的理论和工程应用价值。     

MCAV/IMU integrated navigation for the powered descent phase of Mars EDL

Pin-point landing is considered as a key technology for future manned Mars landing and Mars base missions. The traditional inertial navigation system (INS) based guidance, navigation and control (GNC) mode used in the Mars entry, descent and landing (EDL) phase has no ability to achieve the precise and safe Mars landing, so novel EDL GNC methodologies should be investigated to meet this goal. This paper proposes the MCAV/IMU integrated navigation scheme for the powered descent phase of Mars EDL. The Miniature Coherent Altimeter and Velocimeter (MCAV) is adopted to correct the inertial bias and drift and improve the performance of integrated navigation. Altitude and velocity information derived from MCAV and the lander’s state information sensed by inertial measurement unit (IMU) are integrated in extended Kalman filter algorithm. The validity of the proposed navigation scheme is confirmed by computer simulation.     

磁暴期间的地磁导航精度分析

地磁导航是无源自主导航技术研究的新方向. 分析了地磁导航的基本原理, 描述了典型磁暴过程, 并针对地磁导航在磁暴环境中的适用性进行了研究. 在采用曲面样条方法对实测地磁场数据建立观测模型的基础上, 结合广义卡尔曼滤波方法讨论了磁暴不同阶段对地磁导航精度造成的影响. 分别采用理论典型磁暴数据以及实测磁暴数据进行仿真, 仿真结果表明, 在磁暴的初相、恢复相的中后时段以及中等强度以下的磁暴全过程仍然可以采用地磁来进行导航定位, 导航精度在200 m以内, 满足飞行器中程制导的精度要求.      

面向空间目标相对轨道确定的编队优化方法

针对提高空间目标相对轨道确定精度的问题，研究了在主航天器轨道运动受限时，通过设计和优化辅航天器相对轨道要素的航天器编队优化方法。首先，介绍了基于扩展卡尔曼滤波的双视线测量相对轨道确定方法；之后，通过研究双视线测量下的空间目标定位误差变化规律，得到了减小定位误差的角度条件；然后，通过分析该角度条件和辅航天器相对轨道要素的关系，设计并采用遗传算法优化了辅航天器相对轨道；最后，数学仿真结果表明，设计的编队可保证目标相对位置估计误差收敛，优化后的编队可使目标相对位置估计误差减小至0.3 km且不超过1.2 km。     

Integrated passage design based on extended free-form deformation and adjoint optimization

Inspired by the three-dimensional design of flow passages in turbomachinery, this study proposes the concept of integrated passage design. The capability of adjoint method for efficient optimization and the flexibility of the parameterization method based on extended free-form deformation have been considered to develop a feasible approach to design an integrated passage. This concept was applied to redesign a typical transonic fan, Rotor 67, and the results were analyzed by CFX. It is shown that the passage was adequately adjusted in all three dimensions and reduced the strength of shock wave and wake-induced flow. In particular, the secondary flow was appropriately reorganized and the corner separation was well controlled in the end wall region, leading to significant improvements in adiabatic efficiency and diffusion.     

System-level prognostics approach for failure prediction of reaction wheel motor in satellites

The reaction wheels actuated by motors are widely used for advanced attitude control of satellites. During the satellite operation, the performance of reaction wheel motor degrades and results in unexpected failures. To guarantee the reliability and safety of satellites, it is important to predict its remaining useful life while it is in operation. To address this issue, this study presents a system-level prognostics approach for the reaction wheel motor, by regarding it as a system composed of multiple components. The approach is demonstrated by using the motor operation data obtained during the accelerated-life tests on ground for 3 years. Health degradation of each components of the motor are estimated using the adaptive extended Kalman filter. Failure threshold of the motor performance is established by the design requirement on characteristic curve. The anomaly detection and failure prediction are performed using the shifting kernel particle filter.     

导弹滑模抗干扰自动驾驶仪设计

针对拦截弹的抗干扰控制问题，设计了一种基于扩张状态观测器和快速滑模控制的三通道自动驾驶仪。首先建立考虑有界未知不确定性和外界干扰的拦截弹系统模型，构建扩张状态观测器对有界未知不确定性和外界干扰进行估计；在此基础上，根据自动驾驶仪系统特性，设计了一种快速滑模控制算法使得系统在受到有界未知不确定性和外界干扰的情况下仍然能精准快速跟踪指令信号，并基于李雅普诺夫函数证明了其稳定性。仿真结果验证了所设计控制算法的有效性。     

SINS/GNSS integrated navigation system based on maximum versoria filter

In the missile-borne Strapdown Inertial Navigation System/Global Navigation Satellite System (SINS/GNSS) integrated navigation system, due to the factors such as the high dynamics, the signal blocking by obstacles, the signal intefereces, etc., there always exist pulse interferences or measurement information interruptions in the satellite receiver, which make nonstationary measurement process. The traditional Kalman Filter (KF) can tackle the state estimation problem under Gaussian white noise, but its performance will be significantly reduced under non-Gaussian noises. In order to deal with the non-Gaussian conditions in the actual missile-borne SINS/GNSS integrated navigation systems, a Maximum Versoria Criterion Extended Kalman Filter (MVC-EKF) algorithm is proposed based on the MVC and the idea of M-estimation, which assigns a smaller weight to the anomalous measurements so as to suppress the influence of anomalous measurements on the state estimation while maintaining a relatively low calculation cost. Finally, the integrated navigation simulation experiments prove the effectiveness and robustness of the proposed algorithm.     

Stationkeeping of halo orbits in Jupiter-Europa-Io system

Europa is one of the most promising exploration targets in search for extraterrestrial life. In the observation of Europa, halo orbits are suitable locations, because they are periodic and three-dimensional, and stationary with respect to Europa. However, halo orbits are naturally unstable and thus need stationkeeping. This study addresses the stationkeeping problem of halo orbits in the Jupiter-Europa system perturbated by another Galilean moon Io, in which case Io’s mass and orbital rate are assumed to be unknown. A tight stationkeeping scheme is proposed while accounting for autonomous navigation. To deal with the unknown gravitational perturbation from Io, the mass and orbital rate of Io are estimated during the flight and are then used to enhance the control robustness and stability, and improve the navigation accuracy. The control saturation problem is addressed by introducing adjustable parameters into the control law. The accuracy and error distribution of estimation is evaluated through Monte Carlo simulation.