数字调制信号误差矢量幅度校准研究

从计量领域的现状看,对于矢量信号分析仪的误差矢量幅度,分析其准确度尚没有业内统一的方法。通过对数字调制信号的调制过程和解调过程的分析,罗列出影响误差矢量幅度的各种因素。在此基础上,总结出一套对误差矢量幅度的测量结果的理论计算方法,从而提出一种EVM测量结果的不确定度评定方法。此方法能够有效地分析误差矢量幅度的数字特性。     

航空树脂基复合材料技术发展

通过介绍我国航空树脂基复合材料的发展现状和应用情况,讨论并分析了航空树脂基复合材料未来的发展趋势和重点方向,强调了这种“低成本”、“工程化”技术应在“一体化”思想指导下综合协调发展。     

飞机钣金零件展开计算方法的研究和应用现状

分析了飞机钣金零件展开的复杂性,按照飞机钣金零件的结构和成形分类,对钣金零件展开计算方法进行了综述和归类,在此基础上提出了典型飞机钣金零件数字化展开计算方法的解决思路。     

数字图像最佳插值算法研究

对常用的数字图像插值算法进行了深入的分析,指出双线性内插法和立方卷积法的本质是利用直接邻点的灰度值和(或)邻点间灰度值的变化率对待采样点进行内插,并在此基础上提出了最佳插值算法的公式,最后通过试验提出了最佳插值公式中权值参数的建议值。     

数字示波器的波形测量方法

通过实验对比的方法,详细阐述了使用数字示波器进行波形测量过程中经常遇到的波形失真问题,总结了数字示波器的取样率低于或高于被测信号频率时的波形测量方法。     

Water takeoff performance calculation method for amphibious aircraft based on digital virtual flight

Owing to the strong coupling among the hydrodynamic forces, aerodynamic forces and motion of amphibious aircraft during the water takeoff process, the water takeoff performance is difficult to calculate accurately and quickly. Based on an analysis of the dynamics and kinematics characteristics of amphibious aircraft and the hydrodynamic theory of high-speed planing hulls, a suitable mathematical model is established for calculating the hydrodynamics of aircraft during water takeoff. A pilot mode...     

A novel architecture of electro-hydrostatic actuator with digital distribution

To address the flow imbalance rapidly of the asymmetric Electro-Hydrostatic Actuator (EHA), this paper presents a novel architecture of asymmetric EHA with the Digital Distribution (EHA-DD). It also improves the flow nonlinearity and control accuracy of the pump, especially in the low-speed condition. The digital distribution with two High-Speed on–off Valves (HSVs) not only balances flow instead of the check valves, but also replaces the pump at the low-speed to control output flow by adjusting the PWM signal. The pump and HSVs are the crucial components to control flow output. Firstly, the flow calculation models of the pump and the duty ratio inversed model of the HSV are obtained through experimental tests and the identification method. To get the control input signal for the required flow, the pump speed and PWM duty ratio for the HSVs are inversed to compensate for flow output. Further, a multimode digital flow distribution control method based on pump speed, mainly including the pump-controlled mode for large flow demand and valve-controlled mode for little flow demand, is proposed to control the accurate flow output actively. The step extension experiments based on the flow calculation models are conducted on the EHA-DD prototype under elastic, opposite varying load. The results demonstrate that the EHA-DD realizes little position error by accurate flow control, and it is also beneficial to improve the service life of the pump.     

数字化干涉仪测角技术

数字化干涉仪测角采用的是高精度数字鉴相技术，该技术与传统的模拟鉴相技术相比可以大幅度提高鉴相精度，从而满足高精度干涉仪测角的要求。基于数字干涉仪鉴相算法，通过两路正交本振信号分别与两路待测相信号相乘，使用CIC 滤波器除乘积中的高频信号，最后通过CORDIC 算法计算出相位差。经过干涉仪测角模拟器上测试结果表明，其数字鉴相误差小于0.2°。     

非线性编辑在电视节目制作中的应用

以DY-3000型非线性编辑系统的应用实践出发，论述了非线性编辑的特点及在实际工作中的应用，同时指出了它的不足及今后的发展趋势。     

一类导弹控制系统的模态解耦

本文研究非旋转式导弹控制系统的模态解耦能力。证明了具有俯仰、偏航和滚动三个控制通道的控制系统可以实现俯仰、偏航两种运动模态对滚动运动模态的完全解耦。给出了模态解耦控制系统的设计方法。对一种导弹控制系统进行了验证性设计,做了数字仿真。