Full-scale crash test and FEM simulation of a crashworthy helicopter seat

Crashworthy seat structure with considerable energy absorption capacity is a key component for aircraft to improve its crashworthiness and occupant survivability in emergencies.According to Federal Aviation Administration(FAA) regulations,seat performance must be certified by dynamic crash test which is quite expensive and time-consuming.For this reason,numerical simulation is a more efficient and economical approach to provide the possibility to assess seat performances and predict occupant responses.A numerical simulation of the crashworthy seat structure was presented and the results were also compared with the full-scale crash test data.In the numerical simulation,a full-scale three-dimensional finite element model of the seat/occupant structure was developed using a nonlinear and explicit dynamic finite element code LS-DYNA3D.Emphasis of the numerical simulation was on predicting the dynamic response of seat/occupant system,including the occupant motion which may lead to injuries,the occupant acceleration-time histories,and the energy absorbing behavior of the energy absorbers.The agreement between the simulation and the physical test suggestes that the developed numerical simulation can be a feasible substitute for the dynamic crash test.      

立楔诱导高超声速分离流动的被动控制研究

双模态超燃冲压发动机由于压力扰动可能发生不起动现象,造成推力严重下降,对飞行稳定性与飞行安全具有很强的破坏性.不起动初始阶段主要受到激波与边界层相互作用引起的流动分离影响,希望通过控制分离达到改善流动的目的.采用5阶特征型WENO(weighted essentially non-oscillator)格式与3阶TVD(total variation diminishing)型Runge-Kutta(R-K)格式的高精度数值方法,求解三维Navier-Stokes(N-S)方程,研究与分析了凸起物和被动吹吸两种被动控制方法对激波与边界层相互作用导致的高超声速流动分离现象的控制效果.结果表明:凸起物通过诱导流向涡形成,改变空间压力分布,减弱二次分离,影响分离结构;吹吸方式的被动控制技术通过平衡分离区与再附区之间的高低压差,降低逆压梯度,使压力分布与分离区域发生改变.      

An alternative Shell inversion technique - Analysis and validation based on COSMIC and ionosonde data

Multi-channel Global Positioning System (GPS) carrier phase signals, received by the six low Earth orbiting (LEO) satellites from the Constellation Observing System for Meteorology, Ionosphere, and Climate (COSMIC) program, were used to undertake active limb sounding of the Earth’s atmosphere and ionosphere via radio occultation. In the ionospheric radio occultation (IRO) data processing, the standard Shell inversion technique (SIT), transformed from the traditional Abel inversion technique (AIT), is widely used, and can retrieve good electron density profiles. In this paper, an alternative SIT method is proposed. The comparison between different inversion techniques will be discussed, taking advantage of the availability of COSMIC datasets. Moreover, the occultation results obtained from the SIT and alternative SIT at 500 km and 800 km, are compared with ionosonde measurements. The electron densities from the alternative SIT show excellent consistency to those from the SIT, with strong correlations over 0.996 and 0.999 at altitudes of 500 km and 800 km, respectively, and the peak electron densities (N_mF₂) from the alternative SIT are equivalent to the SIT, with 0.839 vs. 0.844, and 0.907 vs. 0.909 correlation coefficients when comparing to those by the ionosondes. These results show that: (1) the N_mF₂ and h_mF₂ retrieved from the SIT and alternative SIT are highly consistent, and in a good agreement with those measured by ionosondes, (2) no matter which inversion technique is used, the occultation results at the higher orbits (∼800 km) are better than those at the lower orbits (∼500 km).     

含钟差修正的脉冲星和太阳观测组合导航

为提高深空探测器巡航段的导航定位精度和钟差修正能力,提出一种利用X射线脉冲星和太阳观测信息的组合导航方法.利用脉冲星导航的脉冲到达时间测量值,同时利用太阳敏感器、分光计分别测量太阳视线矢量和探测器相对于太阳的径向速度,并将星载时钟钟差增广为状态变量,构建组合导航系统,利用基于扩展卡尔曼滤波的UD(Upper triangular matrix-Diagonal matrix)分解信息融合算法进行状态估计.仿真结果表明,该方法能有效解决因钟差漂移引起的导航滤波发散问题,同脉冲星导航相比,该方法提高了定位精度和钟差修正能力.     

Identifying areas of high economic-potential copper mineralization using ASTER data in the Urumieh–Dokhtar Volcanic Belt,Iran

This study investigates the application of spectral image processing methods to ASTER data for mapping hydrothermal alteration zones associated with porphyry copper mineralization and related host rock. The study area is located in the southeastern segment of the Urumieh–Dokhtar Volcanic Belt of Iran. This area has been selected because it is a potential zone for exploration of new porphyry copper deposits. Spectral transform approaches, namely principal component analysis, band ratio and minimum noise fraction were used for mapping hydrothermally altered rocks and lithological units at regional scale. Spectral mapping methods, including spectral angle mapper, linear spectral unmixing, matched filtering and mixture tuned matched filtering were applied to differentiate hydrothermal alteration zones associated with porphyry copper mineralization such as phyllic, argillic and propylitic mineral assemblages.     

飞机机电综合管理框架下的液压系统仿真平台

在机电综合管理框架下,设计了飞机液压系统仿真平台,介绍了仿真平台的设计思想和总体架构,阐述了仿真平台各系统的工作原理和实现方式,分析了根据流量压力模拟液压负载用户外特性的思想,采用平均油温计算法对飞机在不同飞行阶段油液温度进行了模拟.给出了飞机液压综合管理仿真系统的设计方案以及仿真测试结果.仿真结果表明:在液压系统仿真平台上,能够有效地实现实际液压系统的所有功能特性,为飞机机电综合管理的最终实现提供有利支撑.     

“伽利略”卫星在轨任务控制系统高级规范综述

重点描述了＂伽利略＂卫星在轨任务控制系统高级规范的相关内容,其中包括系统规范和子系统规范,如系统监测和控制子系统、遥测监测子系统、遥控指令子系统和数据归档子系统等;就如何借鉴＂伽利略＂卫星在轨任务控制系统高级规范,提出了一些开展我国星座卫星在轨任务控制系统设计的策略和方法,如设计方法、实现途径、自动化和安全策略等。     

基于粒子群优化算法的月面巡视器全局路径规划

在月面巡视器遥操作系统中,路径规划分为任务级路径规划、全局路径规划和局部路径规划。根据巡视器全局路径规划的应用要求,引入粒子群优化算法应用于全局导航点的规划。针对粒子群算法在路径规划中容易造成不收敛或病态收敛的问题,对算法进行了修改,去掉了速度更新中的速度惯性因子,只保留自身认识因子和社会认识因子,使其在全局路径规划中能够快速收敛;同时引入经典遗传算法中的变异因子以增强算法的全局优化能力。仿真结果表明该算法具有计算简单、全局寻优能力强等特点,能够快速地找到优化的全局导航点。同时在不同的模拟月面地形上进行仿真试验,针对存在的问题提出了对应的二次优化方法,结果表明该方法较好地满足了巡视器全局路径规划的应用需求。     

多径干扰下GPS/INS跟踪环路的一种高斯码相位鉴别器

针对载体在多径信号的影响下,传统码相位鉴别器不能实时有效鉴别出码相位误差,提出一种高斯码相位鉴别器构建方法。在GPS/INS深组合模式中,接收机码相位鉴别器的构建将改变传统设计方法。INS系统利用GPS接收机产生的即时码相位信息,建立INS系统码相位鉴别器,该INS码相位鉴别器用于辅助GPS接收机码相位鉴别器,构建高斯码相位鉴别器,有效降低码相位跟踪误差。仿真结果表明,与传统的码鉴相器相比,高斯码相位鉴别器减小了噪声方差,能有效提高鉴相精度,从而在多径干扰下提高定位精度。     

QStrobe:一种高阶BOC卫星导航信号的无模糊多径抑制算法

二进制偏移子载波(BOC)技术是为解决有限导航频谱资源复用提出的调制技术,BOC信号相关峰的旁瓣导致传统超前减滞后延迟锁定环(DLL)出现跟踪模糊且不利于多径抑制。提出了一种将QBOC旁瓣消除技术与BPSK信号的Strobe抗多径技术相结合的QStrobe算法解决高子载波调制阶数的BOC信号无模糊抗多径问题。利用本地构造的QBOC信号去除相关峰旁瓣,再利用两组不同间隔超前/滞后码的线性组合构造仅有唯一稳定点,且控制延迟误差响应幅度的码跟踪鉴别曲线,实现无模糊的多径抑制。BOC(15, 2.5)与BOC(14, 2)信号的仿真试验结果表明,QStrobe算法消除了传统超前/滞后DLL的跟踪模糊,比QBOC超前/滞后DLL的6dB衰减多径误差包络面积分别改善51%和70%。