单周期冲跃飞行轨迹性能参数影响程度分析

对高超声速飞行器的单周期冲跃飞行轨迹进行了研究。建立了动力学模型和约束条件。仿真分析了升阻比、初始速度和初始弹道倾角对飞行轨迹性能的影响,并讨论了影响程度,确定了适于该飞行器的最佳飞行走廊,为后续的冲跃飞行轨迹完整设计和优化提供了参考。     

低轨卫星编队飞行的地面覆盖及轨道调整

通过施加冲量的方法消除J2项摄动和大气阻力摄动对编队飞行的影响,在编队的相对构型和整体绝对位置得到控制后,研究了低轨卫星编队飞行的地面覆盖问题,最后通过算例给出了卫星编队在南北纬86°之间全球覆盖所需的时间、周期、圈数和覆盖角。计算结果表明,对于偏心率较小的低轨编队飞行,根据本文所推导公式计算出的结果是比较可靠的。     

推力矢量发动机燃气舵舵间干扰的数值分析

通过求解N-S方程,对某空空导弹燃气舵在不同状况下的三维湍流干扰流场进行数值仿真,得到了燃气舵在不同舵偏角下绕流流场的复杂波系结构,计算了测量舵在无干扰舵和有干扰舵情况下升力和阻力等参量随舵偏角的变化曲线。所得舵间干扰相对误差不超过2%,与实际要求相吻合。结果表明,所采用的流动模型和数值模拟方法对燃气舵的气动性能进行预示是有效的。     

火箭靶弹零升阻力系数辨识

火箭靶弹无控飞行过程中飞行攻角较小且无法准确模拟,为提高靶弹弹道理论预估精度,弹道理论计算可假定飞行攻角为零,将飞行攻角产生的诱导阻力贡献折算为对零升阻力系数的修正。建立了火箭靶弹气动特性工程计算方法,针对火箭靶弹零升阻力系数计算模型不确定性问题,利用火箭靶弹A飞行试验GPS遥测数据对其零升阻力系数进行了参数辨识,基于辨识结果对火箭靶弹零升阻力系数工程计算方法进行了修正。经火箭靶弹B飞行试验结果验证,由于综合考虑了飞行攻角产生的诱导阻力贡献,采用修正后的零升阻力系数,弹道理论预估精度大大提高,满足工程要求。     

基于大气阻力实时辨识的Drag-free卫星最优控制研究

研究了基于大气阻力实时辨识的Drag-free卫星最优控制。将Drag-free卫星和其内部的验证质量等效为两颗内、外编队卫星并建立动力学方程,推导了基于卫星和验证质量的相对运动状态观测值反演大气阻力的算法。建立了状态最优调节器模型,采用动态规划求解经典的二次型最优控制。对低轨圆轨道Drag-free卫星的仿真计算结果表明方法的求解精度较高,计算消耗较小。     

Measurements of heat transfer and pressure in a trailing edge cavity of a turbine blade

 An experimental investigation is conducted to obtain the heat transfer and pressure drop data for an integral trailing edge cavity test section that simulates a novel turbine blade's internal cooling passage with bleed holes. Local heat transfer is measured on both the suction and pressure sides by a transient liquid crystal technique, while pressures at six positions are recorded by pressure calibrators. Moreover, flow characteristic and its effect on heat transfer are analyzed for conditions with or without bleed flow. The experimental results show that, in the cases with bleed flow, local heat transfer on the pressure side exceeds that on the suction side in the first and second channels. In the cases without bleed flow, in the first and third channels, local heat transfer on the suction side weakens whilst it increases significantly on the pressure side. For the second channel, non-bleed condition leads to a more balanced heat transfer distribution between the upstream and downstream channel. Besides, after the bleed holes are blocked, heat transfer in the first bend region on the suction side declines sharply, while the opposite phenomenon occurs for the second bend region on the pressure side. In both bleed and non-bleed cases, the total pressure of six measurement positions decreases continuously along the channel at the same Reynolds number and it promotes for higher Reynolds number. Among all the measurement points, under the same flow rate condition, the highest speed occurs at Position 5, which also shows the maximum difference between the total and static pressures. When the bleed holes are blocked, the total pressure at each measurement position appears to increase.     

水气动量交换的实验研究

在风浪槽中进行水气动量交换实验，测量了不同风速和风区下的波浪及空气湍流流场。测量数据表明水面上风速分布符合对数律，水气界面附近在小范围的动量交换常通量层。阻力系数ＣＤ随风速增加线性增长，随波龄增加而减小。这一趋向与理论分析及外海帝测结果一致。对风浪发展过程中波浪和空气湍流谱结构的分析证明了水气运动的耦合关系。     

Refining DORIS atmospheric drag estimation in preparation of ITRF2008

In preparation of ITRF2008, all geodetic technique services (VLBI, SLR, GPS and DORIS) are generating new solutions based on combination of individual analysis centers solutions. These data reprocessing are based on a selection of models, parameterization and estimation strategy unique to each analysis center and to each technique. While a good agreement can be found for models between groups, thanks to the existence of the IERS conventions, a great diversity still exist for parameter estimation, allowing possible future improvements in this direction. The goal of this study is to focus on the atmospheric drag estimation used to generate the new DORIS/IGN ignwd08 time series prepared for ITRF2008. We develop here a method to inter-compare different processing strategies. In a first step, by analyzing single-satellite solutions for a few weeks of data but for a large number of possible analysis strategies, we demonstrate that estimating drag coefficient more frequently (typically every 1–2 h instead of previously every 4–8 h) for the lowest DORIS satellites (SPOTs and Envisat) provides better geodetic results for station coordinates and polar motion. This new processing strategy also solved earlier problem found when processing DORIS data during intense geomagnetic events, such as geomagnetic storms. Differences between drag estimation strategies can mostly be found during these few specific periods of extreme geomagnetic activity (few days per year). In such a case, when drag coefficient is only estimated every 6 h or less often for single-satellite solution, a significant degradation in station coordinate accuracy can be observed (120 mm vs. 20 mm) and significant biases arose in polar motion estimation (5 mas vs. 0.3 mas). In a second step, we reprocessed a full year of DORIS data (2003) in a standard multi-satellite mode. We were able to provide statistics on a more reliable data set and to strengthen these conclusions. Our proposed DORIS analysis is easy to implement in all software packages and is now already used by several analysis centers of the International DORIS Service (IDS) when submitting reprocessed solutions for ITRF2008.     

Reconfigurable Flight Control Design for Combat Flying Wing with Multiple Control Surfaces

With control using redundant multiple control surface arrangement and large-deflection drag rudders,a combat flying wing has a higher probability for control surface failures.Therefore,its flight control system must be able to reconfigure after such failures.Considering three types of typical control surface failures(lock-in-place(LIP),loss-of-effectiveness(LOE) and float),flight control reconfiguration characteristic and capability of such aircraft types are analyzed.Because of the control surface redundancy,the aircraft using the dynamic inversion flight control law already has a control allocation block.In this paper,its flight control configuration during the above failures is achieved by modifying this block.It is shown that such a reconfigurable flight control design is valid,through numerical simulations of flight attitude control task.Results indicate that,in the circumstances of control surface failures with limited degree and the degradation of the flying quality level,a combat flying wing adopting this flight control reconfiguration approach based on control allocation could guarantee its flight safety and perform some flight combat missions.     

自然通风和蒸发冷却在新疆建筑应用的数值分析

为了使新疆和田地区夏季在经济性合理前提下使室内通风环境满足人体热舒适要求。利用蒸发冷却技术将室外空气处理后送入室内，通过数值模拟分析得出在夏季室内负荷最大时刻采用机械辅助式自然通风，使得室温能够雏持在26-8℃，风速为0．6m/s，基本满足人体热舒适要求。在室外温度适宜的过渡季节采用Trombe墙和太阳能烟囱复合的自然通风系统，建筑太阳能烟囱的经济高度为10m。