全文获取类型
收费全文 | 311篇 |
免费 | 49篇 |
国内免费 | 63篇 |
专业分类
航空 | 295篇 |
航天技术 | 42篇 |
综合类 | 39篇 |
航天 | 47篇 |
出版年
2024年 | 2篇 |
2023年 | 6篇 |
2022年 | 8篇 |
2021年 | 14篇 |
2020年 | 18篇 |
2019年 | 17篇 |
2018年 | 19篇 |
2017年 | 19篇 |
2016年 | 21篇 |
2015年 | 21篇 |
2014年 | 31篇 |
2013年 | 24篇 |
2012年 | 21篇 |
2011年 | 30篇 |
2010年 | 26篇 |
2009年 | 18篇 |
2008年 | 15篇 |
2007年 | 15篇 |
2006年 | 22篇 |
2005年 | 12篇 |
2004年 | 10篇 |
2003年 | 6篇 |
2002年 | 6篇 |
2001年 | 7篇 |
2000年 | 7篇 |
1999年 | 3篇 |
1998年 | 6篇 |
1997年 | 2篇 |
1996年 | 2篇 |
1995年 | 1篇 |
1994年 | 1篇 |
1993年 | 4篇 |
1992年 | 5篇 |
1991年 | 3篇 |
1989年 | 1篇 |
排序方式: 共有423条查询结果,搜索用时 31 毫秒
81.
82.
The shape approximation method has been proven to be rapid and practicable in resolving low-thrust trajectory; however, it still faces the challenges of large deviation from the optimal solution and inability to satisfy the specific flight time and fuel mass constraints. In this paper, a modified shape approximation low-thrust model is presented, and a novel constrained optimization algorithm is developed to solve this problem. The proposed method aims at settling the bi-objective optimization o... 相似文献
83.
SRAM FPGA电离辐射效应试验研究 总被引:1,自引:0,他引:1
针对SRAM FPGA空间应用日益增多,以100万门SRAM FPGA为样品,进行了单粒子效应和电离总剂量效应辐照试验。单粒子试验结果是:试验用粒子最小LET为1.66 MeV·cm2/mg,出现SEU(单粒子翻转);LET为4.17 MeV·cm2/mg,出现SEFI(单粒子功能中断),通过重新配置,样品功能恢复正常;LET在1.66~64.8 MeV?cm2/mg范围内,未出现SEL(单粒子锁定);试验发现,随SEU数量的累积,样品功耗电流会随之增加,对样品进行重新配置,电流恢复正常。电离总剂量辐照试验结果是:辐照总剂量75 krad(Si)时,2只样品功能正常,功耗电流未见明显变化。辐照到87 krad(Si)时,样品出现功能失效。试验表明SRAM FPGA属于SEU敏感的器件,且存在SEFI。SEU和SEFI会破坏器件功能,导致系统故障。空间应用SRAM FPGA必须进行抗单粒子加固设计,推荐的加固方法是三模冗余(TMR)配合定时重新配置(Scrubbing)。关键部位如控制系统慎用SRAM FPGA。 相似文献
84.
航空发动机环形燃烧室噪声总声级的GMDH方法研究 总被引:1,自引:1,他引:0
采用数据处理的组合方法(GMDH),研究航空发动机环形燃烧室测试数据。通过简单的二元二次回归原理来构造出下一代较为复杂的次级回归方程,并且利用"优选原理"淘汰掉次级回归方程中的那些不理想的项,得到燃烧室噪声总声级的高阶方程,获得较客观的描写复杂非线性系统的非线性模式。 相似文献
85.
86.
《中国航空学报》2006,19(1):10-17
In order to provide the line of-sight blockage of the engine face for an advanced Uninhabited Combat Air Vehicle(UCAV), a highly curved serpentine inlet is proposed and experimentally studied. Based on the static pressure distribut ion measurement along the wall, the flow separation is found at the top wall of the second S duct for the baseline inlet design, which yields a high flow distortion at the exit plane. To improve the flow uniformity, a single array of vortex generators (VGs) is employed within the inlet. In this experimental study, the effects of mass flow ratio, free stream Mach number, angle of attack and yaw on the performance of a serpentine inlet instrumented with VGs are obtained. Results indicate: (1) Compared with the baseline serpentine design without flow control the application of the VGs promotes the mixing of core flow and the low momentum flow in the boundary layer and thus prevents the flow separation. Under the design condition, the exit flow distortion () decreases from 11. 7% to 2.3% by using the VGs. (2) With the descent of the free stream Mach number the total pressure loss decreases. How ever, the circular total pressure distortion increases. When the angle of attack rises from - 4° to 8°, the total pressure recovery and the circular total pressure distortion both go down. In addition, with the increase of yaw the total pressure recovery is fairly constant, while the circular total pressure distortion ascends gradually. (3) When Ma0=0.6-0.8, α= −4°-8° and β= 0°-6°, the total pressure recovery varies between 0.936 and 0.961, the circular total pressure distortion coefficient varies between 1.4% and 5.4% and the synthesis distortion coefficient has a ranges from 3.8% to 7.0%. The experimental results confirm the excellent performance of the newly designed serpentine inlet incorporating VGs. 相似文献
87.
88.
Wen-jie Wang Ze-ping Wu Dong-hui Wang Wei-hua Zhang Kun Zhao Patrick N. Okolo Gareth J. Bennett 《Advances in Space Research (includes Cospar's Information Bulletin, Space Research Today)》2019,63(11):3706-3720
Hypersonic vehicles are receiving increased attention within the aerospace community due to their high cruise speed and long-range capabilities. In this paper, a modified Sequential Approximate Optimization method is proposed for an optimized aerodynamic design of a hypersonic vehicle. As part of this approach, a constrained experimental design method is developed to handle the constraints more efficiently. A radial basis function is used to surrogate time-consuming CFD analysis. An efficient and more robust numerical mesh morphing scheme for the hypersonic vehicle is developed for the generation of high-quality meshes. Within this paper, a novel adaptive infilling strategy is proposed which uses an inaccurate search technique coupled with an elite archive. This allows the location of a more promising sample region and hence improves the surrogate accuracy, thereby further enhancing the optimization efficiency. A hypersonic vehicle aerodynamic design problem is solved using the proposed approach and satisfactory results are obtained at much lower computational costs. The lift-to-drag ratio is increased by 23.8% when compared with the base configuration while also satisfying the volume and lift constraints. The pressure and Mach contours have been compared with those of the base configuration and the results demonstrate the strength of the optimized configuration. The modified sequential approximate optimization for designing an improved hypersonic vehicle is worth referencing in future work. 相似文献
89.
90.
针对传统的基于最优消谐波理论的逆变器 ,应用了一种全新的神经网络控制器。当系统工作时 ,由在线神经网络实时调节逆变器输出电压的大小 ;同时各功率管的开关角由另一个神经网络通过对最优 PWM最优开关角的拟合 ,直接计算出来。整个控制系统具有结构简单、反应灵敏、调压精确、输出电能质量高且全数字化的特点。 相似文献