一种新的卫星通信系统中的载波频率同步技术

针对卫星通信中传统载波频偏估计算法精度低的问题,提出一种新的频偏估计方法。该方法首先利用传统方法在解调前端进行初始频偏估计,然后充分利用译码信息对残留频偏进行进一步估计和补偿。仿真结果表明,该方法可有效抑制传统频偏估计方法带来的残留频偏的波动,减少残留频偏对系统性能的影响,提高了系统译码性能,降低了解调门限,在不占用系统频带的同时,提高了系统功率利用率。     

Optimization of communication network topology for navigation sharing among distributed satellites

Navigation sharing among distributed satellites is quite important for coordinated motion and collision avoidance. This paper proposes optimization methods of the communication network topology to achieve navigation sharing. The whole communication network constructing by inter-satellite links are considered as a topology graph. The aim of this paper is to find the communication network topology with minimum communication connections’ number (MCCN) in different conditions. It has found that the communication capacity and the number of channels are two key parameters affecting the results. The model of MCCN topology for navigation sharing is established and corresponding method is designed. Two main scenarios, viz., homogeneous case and heterogeneous case, are considered. For the homogeneous case where each member has the same communication capacity, it designs a construction method (Algorithm 1) to find the MCCN topology. For the heterogeneous case, it introduces a modified genetic algorithm (Algorithm 2) to find the MCCN topology. When considering the fact that the number of channels is limited, the Algorithm 2 is further modified by adding a penalized term in the fitness function. The effectiveness of these algorithms is all proved in theoretical. Three examples are further tested to illustrate the methods developed in this paper.     

星载可展开天线热振动数值分析

根据非耦合动力学理论及有限元方法,研究分析了星载可展开天线的热振动。利用半正弦波温度冲击模拟热动力荷载,对天线典型节点的热振动位移和应力以及形面精度进行了数值分析。研究表明,急剧变化的温度荷载将导致该天线结构发生热振动,热振动响应明显大于静力学响应。     

基于四路信号处理的载波锁相环

载波跟踪环是独立导航接收机中最为脆弱的部分,在一定载噪比下,影响载波跟踪环跟踪门限的主要因素是动态应力。科斯塔斯锁相环是最常用的载波跟踪环之一,由于频率牵引范围的限制,其对动态应力非常敏感,该频率牵引范围由最大相位牵引范围决定。传统科斯塔斯锁相环是基于两路信号处理进行载波相位锁定的,其相位牵入范围仅为［-π/2,π/2］。文章提出了一种基于四路信号处理的科斯塔斯锁相环,增加的两路信号分别与原来两路相位相差π/4,其相位牵入范围可以达到［-3π/4,3π/4］,较传统方式提高了1/2。仿真结果显示文中提出的设计方法能够明显提高环路的动态性能     

测量时刻偏差对单星定轨误差的影响分析

为评估测量时刻偏差对单星定轨等效测量误差的影响,根据单星定轨处理策略分析了其理论模型,指出测站接收机的测量时刻偏差由测站时钟钟差以及测量时刻不准确度等组成。试验数据分析表明,测站钟差经一阶多项式拟合后的残差可近似为零均值的测量噪声;数值仿真结果表明,卫星信号发射时刻1ms误差导致GEO、IGSO、MEO三种卫星的等效测距误差分别为006cm、40cm、80cm。     

卫星编队对空间非合作目标测距相对导航精度分析

针对单颗卫星对空间非合作目标测距不能估计全部相对运动状态的问题,提出利用编队中多颗卫星同时测距相对导航。建立了相对运动状态估计的系统模型;推导了系统可观测矩阵;通过计算系统可观测度和采用无迹卡尔曼滤波（UKF）对目标相对运动状态进行估计,研究了观测矢量方向和数量与相对导航精度的关系。结果表明双星测距能估计全部相对运动状态,观测矢量夹角越大,相对导航精度越高,在编队尺寸远小于目标距离的前提下,多于两颗的卫星测距并不能明显提高相对导航精度。     

基于多失效模式的扭簧可靠性优化分析

基于广义应力 广义强度分布干涉理论和单一失效模式下扭簧可靠性计算模型,建立了多失效模式下扭簧可靠度优化数学模型,采用规格化加权法进行各失效模式影响相同（等失效效应）和有差异（非等失效效应）两种情况下的扭簧可靠度计算。在给定扭簧结构和工况约束条件下,应用提出的计算模型和技术进行了失效模式影响相同和有差异的基于可靠度最大的扭簧结构优化,与非优化结构的扭簧可靠度的比较,以及这两种情况下的扭簧可靠度比较。结果表明,提出的可靠度优化模型和方法是可靠和有效的,对于航天工程中零部件的可靠性优化分析具有很好的借鉴作用。     

Geostationary orbit determination using SATRE

A new strategy of precise orbit determination (POD) for GEO (Geostationary Earth Orbit) satellite using SATRE (SAtellite Time and Ranging Equipment) is presented. Two observation modes are proposed and different channels of the same instruments are used to construct different observation modes, one mode receiving time signals from their own station and the other mode receiving time signals from each other for two stations called pairs of combined observations. Using data from such a tracking network in China, the results for both modes are compared. The precise orbit determination for the Sino-1 satellite using the data from 6 June 2005 to 13 June 2005 has been carried out in this work. The RMS (Root-Mean-Square) of observing residuals for 3-day solutions with the former mode is better than 9.1 cm. The RMS of observing residuals for 3-day solutions with the latter mode is better than 4.8 cm, much better than the former mode. Orbital overlapping (3-day orbit solution with 1-day orbit overlap) tests show that the RMS of the orbit difference for the former mode is 0.16 m in the radial direction, 0.53 m in the along-track direction, 0.97 m in the cross-track direction and 1.12 m in the 3-dimension position and the RMS of the orbit difference for the latter mode is 0.36 m in the radial direction, 0.89 m in the along-track direction, 1.18 m in the cross-track direction and 1.52 m in the 3-dimension position, almost the same as the former mode. All the experiments indicate that a meter-level accuracy of orbit determination for geostationary satellite is achievable.     

电磁监测试验卫星矢量磁场探测方法

电磁监测试验卫星是中国第一颗近地轨道电磁场科学探测试验卫星, 探测空间背景磁场是其重要任务之一. 空间背景磁场探测需要在卫星平台上对空间矢量磁场进行长期稳定准确探测, 电磁监测试验卫星采用磁通门磁强计和基于CPT效应的绝对磁场校准装置(Coupled Dark State Magnetometer, CDSM)分别探测空间相对矢量磁场以及绝对标量磁场, 通过数据处理, 使最终的矢量磁场探测数据具有准确性. 这种数据处理方法在理想模型下拥有解析解, 实施过程中载荷的噪声、 准确度及稳定性影响模型的准确性, 会产生数据校准误差. 通过对在轨磁场探测的模拟确定了这种数据处理方法的性能, 验证了在载荷设计性能的基础上电磁监测试验卫星的磁场探测可以实现1 nT的准确度.      

星间链路天线相对姿态的地面模拟

星间链路天线的相对姿态模拟为星间链路的测试验证提供近真实的动态姿态环境,是星间链路系统地面测试的重要组成部分。建立多个坐标系统将两颗卫星天线的位置和姿态联系起来,利用卫星星历将天线的相对姿态表示为一颗卫星天线在另一颗卫星天线坐标系中的方向向量,利用两个二轴转台实现此方向向量,最终通过控制转台的转角模拟卫星天线的相对姿态变化。同时计算天线波束的方向,分析了两颗卫星的可见性。天线相对姿态的模拟为星间链路的建立和保持提供动态测试环境。