基于遗传退火算法的电路模拟吸波材料设计

相比传统吸波材料,电路模拟吸波材料可以很好地减小材料厚度、提高吸波性能,其设计通常使用遗传算法进行优化。针对传统遗传算法的诸多不足,对交叉和变异概率进行了改进、引入了模拟退火思想作为子代接受准则并增加了算法终止准则。其中,对交叉和变异概率的改进是最大创新点。改进后的遗传算法只需进化100代即得到最优解,平均反射率为-15.0420,厚度为1.43 mm,均优于传统算法得出的结果。结果表明,改进后的遗传算法具有收敛速率快、不易陷入局部最优解等优点。     

利用一种声学阀门对发动机燃烧不稳定性进行的被动控制(英文)

为了对发动机燃烧不稳定性进行被动控制,利用亥姆赫兹声学共振器原理,设计一种声学阀门,当一个管道侧面安装的亥姆赫兹共振器的空腔壁面是柔软的时候,声学阀门的性能与频率就没有很强的关系,从而实现由于热声学不稳定带来的压力和热释放导致的不稳定燃烧进行被动控制。阀门的功能是让声音通过,但它必须阻止时间平均意义上的流动。本文对带有这种装置的热声学特征根问题给出数值解。结果显示声学阀门对燃烧室内的驻波结构造成很大改变,进而可以消除不稳定的特征根模态。只要阀门具备足够的尺寸,这种效果可以在任意的线性火焰声学特性中广泛实现。     

带旋转修正的弹簧-TFI混合动网格方法

网格存在大变形时,传统的超限插值(TFI)动网格方法易于引起网格正交性问题.依据几何关系并考虑其插值特点,提出了一种带旋转修正的TFI动网格方法.对结构网格块进行分块,在子块角点间建立弹簧元,并基于弹簧类比法计算角点位移;子网格内部结点位移采用修正后的TFI动网格方法进行计算,从而形成具有弹簧-TFI混合特征的动网格新...     

真空环境下行波型超声波电机的特性

真空环境下由于缺少空气介质,靠摩擦驱动的超声波电机的特性会与常态 下发生较大的变化。采用行波型超声波电机常用的三种摩擦材料（环氧树脂、聚四氟乙 烯烧结和生聚四氟乙烯填充为基的摩擦材料）对比分析了常态和真空环境下的超声波电机的 机械特性。发现除环氧胶外,其他摩擦材料制成的电机真空下的堵转力矩都有所增大,而空 载转速全部降低。为了分析变化产生的原因,实验比较了真空环境下三种摩擦材料在常规、 驻波和行波状态下的动摩擦系数,实验表明除环氧胶外其它摩擦材料的摩擦系数比常态下都 略有增大,且相应电机的堵转力矩也都增大。其次实验研究了行波型超声波电机的瞬态特性 ,当真空度增加到10 -2 Pa后,电机的起动时间和起动电压都有明显的增加,即电 机起动和运行的阻力逐步增大,导致电机空载转速的降低。最后测试了声悬浮力大小,其数 值不超过预紧力的1％,不是真空环境下特性变化的主因。导致电机真空环境下堵转力 矩和空载转速发生变化的主要原因在于摩擦材料动态摩擦系数和起动与运行阻力的变化。     

Characterization of an acoustic liner by means of Laser Doppler Velocimetry in a subsonic flow

This paper describes a new experimental approach to acoustic liner characterization in the presence of a grazing flow. The traditional methods of measurement use microphones to determine liner impedance. The in situ method in particular requires the simultaneous use of two microphones. The first is mounted flush with the surface of the liner grazed by the flow and the second is flush-mounted to the rear face of the liner. However, this method is invasive and assumes the reaction of the liner to be independent of the incidence of the waves (locally-reacting liner). The approach suggested here is radically different since Laser Doppler Velocimetry (LDV) is used to measure the acoustic perturbation of velocity, or acoustic velocity. This latter allows us to determine the acoustic displacement, which is the key parameter in Galbrun's linear theory for assessing the perturbation of pressure and the field of active intensity. The wall impedance and the propagation paths of acoustic energy in the presence of the liner may be deduced without any assumption and non-invasively. This approach was applied for characterizing a resistive liner in a test bench specially designed for aeroacoustic measurements, with a 2D LDV system. The flow was turbulent and the measured nominal Mach number was 0.13. The impedance and field of active intensity were then obtained. A comparison was carried out between the new approach and the in situ method using microphones. According to previous theoretical works in the literature and the presented test results, one has to be cautious about the definition of the impedance when performing in-flow acoustic measurements.     

减阻表面换热特性的实验

采用实验方法对带"V"型沟槽表面通道在不同雷诺数下的流动与换热特性进行了研究.研究结果表明:宽与深均为0.5 mm的沟槽板通道在实验范围内具有明显的减阻效果, 减阻效果随着雷诺数的增大而减小;相比平板通道流动, 低雷诺数范围下(10000相似文献   

基于激光反射层析法的换能器声场测量技术及仿真研究

换能器的辐射声场分布能够直接反映出换能器声学性能的好坏,若不能精确测量出换能器的辐射声场,则会对换能器的诊断和评估造成严重影响。从理论仿真的角度出发,推导了运用激光反射层析法重建换能器辐射声场的理论公式,着重利用推导出的理论公式对激光反射层析法进行了仿真计算。结果表明激光反射层析法能够精确地重建出换能器的辐射声场分布及声场中的声压量值,这为换能器的声场重建及声压测量提供了一种可行的方法。     

Hypervelocity impact induced shock acoustic emission waves for quantitative damage evaluation using in situ miniaturized piezoelectric sensor network

Manmade debris and natural meteoroids, travelling in the Low Earth Orbit at a speed of several kilometers per second, pose a severe safety concern to the spacecraft in service through the HyperVelocity Impact(HVI). To address this issue, an investigation of shock Acoustic Emission(AE) waves induced by HVI to a downscaled two-layer Whipple shielding structure is performed,to realize a quantitative damage evaluation. Firstly a hybrid numerical model integrating smoothparticle hydrodynamics and finite element is built to obtain the wave response. The projectiles, with various impact velocities and directions, are modelled to impact the shielding structure with different thicknesses. Then experimental validation is carried out with built-in miniaturized piezoelectric sensors to in situ sense the HVI-induced AE waves. A quantitative agreement is obtained between numerical and experimental results, demonstrating the correctness of the hybrid model and facilitating the explanation of obtained AE signals in experiment. Based on the understanding of HVI-induced wave components, assessment of the damage severity, i.e., whether the outer shielding layer is perforated or not, is performed using the energy ratio between the regions of ‘‘high frequency" and ‘‘low frequency" in the acquired AE signals. Lastly, the direct-arrival fundamentalsymmetric wave mode is isolated from each sensing signal to be input into an enhanced delay-andsum algorithm, which visualizes HVI spots accurately and instantaneously with different sensor network configuration. All these works demonstrate the potential of quantitative, in situ, and real time HVI monitoring using miniaturized piezoelectric sensor network.     

风扇前传噪声及声衬特性研究

为了探究航空发动机的风扇噪声,通过试验研究了缩尺风扇前传噪声在不同转速工况下的频谱特性和周向模态特性,并对所设计的环形声衬降噪效果进行了验证。研究结果表明,基于试验测量数据分析得到的频谱特性和周向模态特性满足转静干涉噪声理论。随着转速的提高,风扇纯音噪声越显著,高转速工况下纯音噪声的能量约占风扇前传噪声的85%。在所研究的工况范围内,该声衬对目标频率及模态均有显著的降噪效果,且在85%转速工况时的纯音降噪效果最优,其主模态的传声损失约为59dB。该声衬对于设计频率附近的宽频噪声也有一定降噪效果,在85%转速时的宽频噪声平均传递损失约为3dB。     

分布式波浪前缘静子叶片对单级轴流风扇单音噪声影响的数值研究

为了适应逐年严苛的适航噪声标准，改善飞机噪声环境，突破航空发动机降噪技术的瓶颈，有必要开发新的降噪手段以指导叶轮机械降噪设计。本文采用URANS与FW-H方程混合方法，通过将波浪前缘构型运用在叶片流动损失较大、声源强度较强的部分后，进一步观察其气动性能和降噪效果。研究表明：与基准叶片相比，分布式波浪前缘静子叶片可以在1BPF（Blade Passing Frequency）时降低风扇入口声功率级0.67~1.9dB，2BPF时降低风扇入口声功率级1.87~4.18dB，3BPF时降低风扇入口声功率级2.4~6.8dB，同时，总压比最高提升0.027%，等熵效率最高提升0.28%。因此，分布式波浪前缘静子叶片在叶轮机械降噪方面有很好的运用前景。