热变形对TC4氩弧拼焊板拉伸与疲劳性能的影响

在700℃下,对TC4氩弧拼焊板进行了3个变形量(主应变0.5％、1.6％、2.7％)的等双向拉伸成形,研究了热变形对TC4氩弧拼焊板单向拉伸性能和疲劳寿命的影响.结果表明:等双拉变形前后,TC4氩弧拼焊板拉伸试样均断裂在焊接热影响区,热影响区的强度低于母材和焊缝.随着等双拉热变形量增加,TC4拼焊板试样疲劳寿命有所增加,这是因为一定变形量的热成形释放了焊接残余应力.     

针刺C/C复合材料拉伸强度及渐进失效数值预测

基于金相显微镜观测的针刺C/C复合材料细观结构,考虑材料内部纤维的真实分布,建立了针刺C/C复合材料单胞模型。采用Linde失效准则,考虑纤维渐进损伤对材料进行了刚度折减,通过引入周期性位移边界条件,对针刺C/C复合材料的拉伸破坏进行了有限元法（FEM）数值模拟,分析了单胞模型的渐进失效过程,并预测了材料的拉伸强度。开展了针刺C/C复合材料拉伸试验,采用扫描电子显微镜（SEM）观察了材料的断口形貌,数值预测结果与试验吻合良好。针刺C/C复合材料受拉伸载荷后发生准脆性断裂,拉伸应力-应变曲线呈双线性,0°无纬碳布发生纤维断裂和基体开裂破坏,90°无纬碳布出现横向基体劈裂,最终断裂发生在针刺纤维与面内无纬碳布交叉区域。     

Prediction of cutting forces in ball-end milling of 2.5D C/C composites

Machining of carbon/carbon (C/C) composite materials is difficult to carry out due to its high specific stiffness, brittleness, anisotropic, non-homogeneous and low thermal conductivity, which can result in tear, burr, poor surface quality and rapid wear of cutters. Accurate and fast pre-diction of cutting forces is important for milling C/C composite materials with high quality. This paper presents an alternative cutting force model involving the influences of the directions of fiber. Based on the calculated and experimental results, the cutting forces’ coefficients of 2.5D C/C com-posites are evaluated using multiple linear regression method. Verification experiment has been car-ried out through a group of orthogonal tests. Results indicate that the proposed model is reliable and can be used to predict the cutting forces in ball-end milling of 2.5D C/C composites.     

C/SiC复合材料反射镜研究进展

反射镜在空间光学系统中起着非常关键的作用,目前已发展到第四代C/SiC复合材料。C/SiC复合材料具有低密度、高模高强、结构设计灵活等优点,已成为非常重要的新型反射镜材料。本文对四代反射镜的特点进行了归纳和对比,对C/SiC复合材料反射镜的结构设计、几种常用的制备工艺进行了整理和总结,并对目前国内外的研究进展进行了综述。     

骨特异性转录因子Runx2对抗空间骨丢失效应的初步研究

为了构建稳定过表达Runx2 (骨特异性转录因子)的C2C12 (小鼠成肌细胞)和MG63 (前成骨细胞)细胞株, 并用于研究Runx2在对抗空间骨丢失效应中的作用. 利用实时定量聚合酶链式反应鉴定Runx2下游基因I型胶原、碱性磷酸酶表达情况, 在二维回转器中培养稳定细胞株, 通过定量聚合酶链式反应,观察在模拟失重效应下Runx2基因对其下游基因表达的影响. 结果表明, 通过筛选获得稳定转染的C2C12-Runx2和MG63-Runx2细胞株, 经鉴定都能过表达Runx2. 转染后的细胞 I 型胶原和碱性磷酸酶mRNA表达增高. 回转组与对照组相比, MG63, C2C12-Runx2, MG63-Runx2细胞的I型胶原和碱性磷酸酶mRNA表达降低, 但在模拟失重效应下, 转染细胞中I型胶原和碱性磷酸酶的mRNA表达下降程度明显低于未转染细胞株. 所构建的C2C12-Runx2和MG63-Runx2细胞株比较稳定, 并证实Runx2能部分对抗失重引起的成骨特异性分子的降低.      

磁静日期间中国大陆地区外源弱磁场研究

利用第四代地磁场综合模型CM4, 研究了中国大陆地区1960-2000年磁静日期间地磁外源弱磁场的变化情况, 计算并分析了外源场中的电离层感应场、环形场以及磁层感应场的分布和变化. 结果显示, 北向分量X的磁层感应场强度总体呈先增加后减少的趋势, 共减少了约7.3nT; 东向分量Y的磁层感应场强度呈先减少后增加的趋势, 共增加了约0.8nT; 垂直分量Z的磁层感应场强度呈先增加后减少的趋势, 共增加了约5.5nT. 三个分量的电离层感应场以及环形场变化幅度很小, 其分布在1960-1970和1970-1980年, 1980-1990 和1990-2000年呈现正负互相变换的现象, 认为该现象可能与太阳11年活动周期有关. 最后对弱磁场随时间变化的结果进行了分析说明.      

Orbital phase spectroscopy of four high mass X-ray binary pulsars to study the stellar wind of the companion

Our work focuses on a comprehensive orbital phase-dependent spectroscopy of the four High Mass X-ray Binary Pulsars (HMXBPs) 4U 1538-52, GX 301-2, OAO 1657-415 and Vela X-1. We hereby report the measurements of the variation of the absorption column density and iron-line flux along with other spectral parameters over the binary orbit for the above-mentioned HMXBPs in elliptical orbits, as observed with the Rossi X-ray Timing Explorer (RXTE) and the BeppoSAX satellites. A spherically symmetric wind profile was used as a model to compare the observed column density variations. Out of the four pulsars, only in 4U 1538-52, we find the model having a reasonable corroboration with the observations, whereas in the remaining three the stellar wind seems to be clumpy and a smooth symmetric stellar wind model appears to be quite inadequate in explaining the data. Moreover, in GX 301-2, neither the presence of a disk nor a gas stream from the companion was validated. Furthermore, the spectral results obtained in the case of OAO 1657-415 and Vela X-1 were more or less similar to that of GX 301-2.     

月面冯·卡门撞击坑的着陆选址和科学探测目标浅析

冯·卡门（Von Kármán）撞击坑位于月球背面南极—艾肯（South Pole-Aitken,SPA）盆地中部,是中国“嫦娥4号”计划的优先级较高的探测目标。对该撞击坑的着陆和探测,有助于揭示月球形成和演化的一些关键问题,在月球科学研究中具有重大的意义。论文概要总结了冯·卡门撞击坑的研究意义和科学价值;结合LRO卫星LOLA数据、Clementine UV-VIS数据、GRAIL数据、“嫦娥2号”卫星CELMS等数据,简要分析了冯·卡门撞击坑的地形、成分、深部结构和亮?%rater are analyzed with LRO satellite LOLA data,Clementine UV-VIS data,GRAIL data,and Chang''E-2 CELMS data and their scientific meanings are also presented. Finally,combined with our results and the previous prospects about theVon Kármán crater,three candidate landing sites and the possible scientific discoveries are proposed.     

“嫦娥4号”中继星任务轨道确定问题初探

"嫦娥4号"任务将采用着陆器、巡视器和绕飞地月拉格朗日L2点中继星进行月球背面的探测,中继星已先期发射,进入环绕地月L2点的晕(Halo)轨道。在中继星使命轨道动力学模型的基础上,通过相关仿真工作,开展了中继星在Halo轨道上的摄动源量级及影响定轨预报的主要因素分析,结果表明:太阳光压摄动是其主要影响因素。为降低其相关影响,提高定轨精度,在太阳光压球模型的基础上,结合中继星在轨运行特点及其星体结构特点,提出了一种求解光压等效面积的方法。经仿真分析,使用修正后的太阳光压球模型进行定轨求解,速度精度可提升约一个量级。