某动力调谐陀螺挠性接头抗冲击能力分析

挠性接头是动力调谐陀螺中最薄弱的部分，在运输时，外界和弹体自身的振动和冲击不可避免地对挠性接头的薄弱环节造成较大的影响，对接头抵抗冲击能力的研究可以帮助制定储运策略。为了弄清某型动力调谐陀螺的挠性接头承受冲击载荷的能力，论文首先建立了陀螺的离散动力学模型，通过直接积分法得到系统在特定冲击作用下的响应，并根据响应得到挠性结构的变形；然后采用有限元方法计算挠性部分的应力和变形的对应关系，进而获得接头挠性结构处的应力；最后运用累积损伤理论对挠性接头的疲劳寿命进行了估算。结果表明该型陀螺能承受的极限冲击加速度约为150g-180g。     

轴对称降落伞稳定下降阶段的流场特性

文章根据降落伞的特点,通过3点假设(伞衣的薄膜假设、降落伞的轴对称假设和流场的定常 假设),将三维复杂流动问题,转化成二维轴对称问题,以节约计算时间。然后,建立轴对称降落伞的流体力 学计算模型,利用数值模拟手段,求解RNG(Renormalization Group)k-epsilon湍流模型下的N—S方程组,获 得与有关单位试验相吻合的计算结果。分析发现带顶孔的轴对称降落伞绕流和亚临界状态下带中心孔的 圆球绕流,在尾流区拓扑结构上几乎完全一致。结果表明建立的轴对称降落伞模型,能够揭示降落伞流场 的本质特性,为进一步研究降落伞流场的流动机理和流固耦合问题打下基础。     

交会对接最终逼近段制导控制律设计方法研究

针对空间交会对接最终逼近阶段要求较高的控制精度以及连续控制力（转矩）难于实现等问题，文中在制导律设计方面使用了一种基于Hill方程的直线型制导及其常值推力等效实现的策略，在姿态控制方面使用补偿线性化以及PWPF调节器实现的控制方法，对于以上两种制导控制律，利用半物理仿真平台对算法的有效性和可行性给予了验证。     

基于特征点的地形数据存储模型

低空突防在现代战争中发挥着越来越重要的作用，而机载数字地图是现代自主式低空突防系统的一个关键子系统。突防区域内的三维地形数据是数字地图最重要的信息源，故数字地图子系统的成功构筑有赖于在机载环境下有效地存储三维地形数据。本文提出了一种基于地形特征点的三维地形存储模型，其中给出了地形特征点的提取方法及地形特征点的存储编码方式。研究表明，该存储模型可大大减小地形数据的存储空间，并有利于提高三维地形的显示速度。     

翼柱型装药发动机点火升压过程计算

利用实验获得的翼槽内火焰传播规律经验公式,在Ｐ（ｔ）模型的基础上,建立了翼柱型发动机的点火升压计算模型。计算结果与实测数据吻合较好。同时就点火器流量、推进剂燃速、喷管堵盖打开压强等设计参数对发动机点火升压过程的影响进行了分析。     

A Geosynchronous Orbit Search Strategy

Since more than 10 years there is evidence that small-size space debris is accumulating in the geosynchronous orbit (GEO), probably as the result of breakups. Two break-ups have been reported in GEO. The 1978 break-up of an EKRAN 2 satellite, SSN 10365, was identified in 1992, and in 1992 a Titan 3C Transtage, SSN 3432, break-up produced at least twenty observable pieces. Subsequently several nations performed optical surveys of the GEO region in the form of independent observation campaigns. Such surveys suffer from the fact that the field of view of optical telescopes is small compared with the total area covered by the GEO ring. As a consequence only a small volume of the orbital element-magnitude-space is covered by each individual survey. Results from these surveys are thus affected by observational biases and therefore difficult to compare. This paper describes the development of a common search strategy to overcome these limitations. The strategy optimizes the sampling for objects in orbits similar to the orbits of the known GEO population but does not exclude the detection of objects with other orbital planes. A properly designed common search strategy clearly eases the comparison of results from different groups and the extrapolation from the sparse (biased) samples to the entire GEO environment.     

2D碳/碳复合材料CVI过程的数值模拟研究

本文根据３Ｄ碳／碳复合材料的结构特征及ＣＶＩ工艺的特点建立了孔隙模型和动力学模型，并利用该模型对其ＣＶＩ过程进行了模拟与分析。模拟结果与实验结果的对比表明该数学模型是合理的。     

智能结构及其控制系统集成优化设计

将智能结构的振动控制性能指标和集成结构的质量为目标函数，结构尺寸参数和控制系统的控制参数同时作为独立的设计变量，并施加约束条件，从而将智能结构及其控制系统集成优化设计问题转化为多目标数学规化问题，数值结果表明，利用本文方法设计出的智能结构及其控制系统，能极大地抑制系统的振动。     

Tether Satellite System Collision Study

A study was performed to determine the probability of collision with resident space objects and untrackable debris for the tether component of the Tethered Satellite System (TSS) after it broke away from the Space Shuttle orbiter (mission STS-75) in February 1996. Both an analytical and a numerical approach were used in this study, and the results obtained with these two methods were found to be in good agreement. These results show that the deployed tether is expected to have been impacted by several particles 0.1mm or larger in size. The probability of collision with objects 10cm in size or larger was on the order of 10^–3 per month. Since the severed tether reentered within one month after deployment, the collision hazard to other objects while in orbit was small. The analytical methods used in this study are useful for tether collision evaluations in general.     

宇航科学文献情报源初析

本文通过对《宇航学报》1981～1988年322篇论文中2466条参考文献的统计分析,得出以下结论,(a)宇航科学的文献情报源重在期刊类文献。(b)以《宇航学报》、《航空学报》、《AIAA,Jourual》等六种期刊类文献为重点文献。(c)中文的引文作者和论文作者相对集中。(d)期刊类文献的半衰期为8～10年。