空气压强对激光推进器冲量耦合系数影响

设计并加工了激光推进器实验模型,以空气为推进工质,利用脉冲式CO2激光器,研究了空气压强对激光推进器冲量耦合系数影响。实验结果表明,空气压强对激光推进器性能有显著影响。在文中实验条件下,当空气压强大于6 kPa时,激光推进器冲量耦合系数随压强减小而减少较慢;当空气压强小于6 kPa时,激光推进器冲量耦合系数随压强减小而减少很快。     

国外几种新型微化学推力器

介绍了国外几种以微机电系统 (MEMS)技术为基础的液体和固体微化学推力器。这些新型微化学推力器具有MEMS技术微型化、低成本和批量生产的优点 ,并考虑了体积限制和高度集成等空间限制 ,能产生 10 -6～ 10N·s的推力脉冲 ,可用于微型卫星和纳米卫星的姿态调整、变轨和定向的精确控制。同时阐述了这几种微推力器结构特点和制造工艺 ,并与其他类型的推进器进行了比较     

弓激波前内透射离子动力学横场流静电不稳定性

本文讨论了地球弓激波前内背景电子速度分布函数为平顶形式时的透射离子横场流静电不稳定性.结果表明,在超临界(Alfvén Mach数M_A>3)准垂直激波区(激波法向与行星际磁场之间的夹角75°)情况下,透射离子流产生的静电不稳定性增长率峰值要比电子速度为Maxwell分布时更加显著,并满足动力学性质.     

非硅氧化物的滤出及其机理探讨

 采用B核磁共振仪,激光拉曼光谱仪,隧道扫描显微镜及各种化学分析等方法,较系统地研究了沥滤温度、时间和酸液浓度对拉制的钠硼硅玻璃纤维纯度的影响。结果表明,高钝超细SiO_2,纤维可以用酸沥滤法获得;揭示了纤维中非硅氧化物沥出的规律;并初步探讨了沥滤机理,认为沥滤过程主要是B~(3+)和N~+与H~+发生交换扩散的过程。     

航空发动机进气畸变诱导叶片振动的研究

介绍了进气畸变导致的叶片振动响应的一般分析方法 ,讨论了引起叶片振动响应的周向总压畸变导致的激振力谐波的计算方法 ,并结合某型发动机叶片试验结果和计算结果进行对比 ,对叶片在周向总压进气畸变条件下的振动响应进行了分析和讨论     

Microstructure,porosity and mechanical properties of selective laser melted AlSi10Mg

Finite element modeling (FEM), microscopy, X-ray computed tomography (CT) and mechanical property tests were used to study the microstructure, porosity and mechanical properties of an AlSi10Mg alloy produced by selective laser melting (SLM). The simulation of the melt pool and thermal history under different energy densities produced an optimized result with an energy density of 44.5 J·mm⁻³. The high cooling rate during the SLM process significantly refined the previous α-Al dendrites. The growth direction of the network-like Al-Si eutectic structure at different orientations confirmed the anisotropic nature of the microstructure. Furthermore, the microhardness, tensile testing and fracture analysis results proved that there were no obvious distinctions in the strength between the transverse and longitudinal directions, and that the ductility was anisotropic, possibly due to the shape and distribution of the pores. The pores measured by X-ray CT at different energy densities confirmed that the sphericity of the pores was inversely related to pores volumes. With optimized processing conditions, the porosity of the selective laser melted sample decreased leading to the improved fabricated fuel system component via SLM.     

10cm氙离子推力器变推力特性研究

非重力阻尼的连续、快速、高精度补偿是实现重力梯度测量卫星精细重力场测量的关键技术之一,直接影响到整星工程任务的成败。针对重力梯度测量卫星在轨飞行期间对电推进系统宽范围连续变推力能力的应用需求,分析了10cm氙离子推力器推力调节响应特性。在此基础上,通过对阳极电流、励磁电流和阳极流率等推力高敏感响应参量的组合调节,开展了推力调节试验研究,验证了10cm氙离子推力器宽范围连续变推力调节能力,获得了1～20mN范围内的推力调节性能及其变化规律。试验结果表明：在采用地面供电、供气设备条件下,10cm氙离子推力器能够在100～597W的功率范围内实现0.98～20.29mN的推力宽范围调节,比冲175～3500s,推力分辨率优于50μN。研究为建立10cm氙离子电推进系统的推力控制数学模型及调节控制算法奠定基础。     

用于光波纳米推力器的颗粒供应技术和光聚积技术研究

为提高光波纳米推力器在轨应用的可行性,针对与其匹配的颗粒供应技术和光聚积技术进行研究。提出整个推进系统的设计思路,通过建立理论计算和数值计算模型,分析颗粒供应技术和光聚积技术的各项核心结构参数的设计方法。计算结果表明:颗粒供应装置的正负电极内径之比(W/D)会影响正负电荷产生的总量之比,在W/D=300/322附近时,正负电荷比例接近1:1。静电诱导电压为9 V,当中和通道长度大于37.5mm时,正负颗粒可以视为完全中和。光聚积设计思路可令聚积球对光能的利用率在32.8%左右。两种相关技术的装置与推力器在结构上能够对接、在性能上可以匹配,从理论上表明了两种支撑技术的可行性。     

Spectroscopic Constraints on Models of Ion-cyclotron Resonance Heating in the Polar Solar Corona

Using empirical velocity distributions derived from UVCS and SUMER ultraviolet spectroscopy, we construct theoretical models of anisotropic ion temperatures in the polar solar corona. The primary energy deposition mechanism we investigate is the dissipation of high frequency (10-10000 Hz) ion-cyclotron resonant Alfvén waves which can heat and accelerate ions differently depending on their charge and mass. We find that it is possible to explain the observed high perpendicular temperatures and strong anisotropies with relatively small amplitudes for the resonant waves. There is suggestive evidence for steepening of the Alfvén wave spectrum between the coronal base and the largest heights observed spectroscopically. Because the ion-cyclotron wave dissipation is rapid, even for minor ions like O⁵⁺, the observed extended heating seems to demand a constantly replenished population of waves over several solar radii. This indicates that the waves are generated gradually throughout the wind rather than propagated up from the base of the corona. This revised version was published online in June 2006 with corrections to the Cover Date.     

公差原则中相关要求的计算问题

关于公差原则中的相关要求的计算问题 ,本文提出了两种方法 :计算法和图解法。运用这两种方法可以简化此类问题的计算过程 ,准确求得计算结果。