A new method of determining the spectral index for protons in the energy range about 10<Superscript>13</Superscript> eV

We consider a relationship between the difference in spectral indices of the spectra of single hadrons and all hadrons (_sngl – _h) and the difference in the indices of the spectra of galactic cosmic ray (GCR) protons and nuclei. It is demonstrated that at the mountain level the ratio (_p – _Z)/(_sngl – _h) is always larger than unity, if (_sngl – _h) > 0.1. From the experimental value _sngl – _h = 0.4 ± 0.05 we derive that, in the vicinity of E = 10 TeV, _p – _Z 0.49 ± 0.06 , i.e., _p 3.09 ± 0.06.__________Translated from Kosmicheskie Issledovaniya, Vol. 43, No. 2, 2005, pp. 83–87.Original Russian Text Copyright © 2005 by Grigorov, Tolstaya.     

Radar Performance with Multipath Using the Complex Angle

The complex angle (CA) method for resolving a low angle target from its multipath signal is evaluated in the presence of system noise. It is shown that standard deviation improvements of around 3-to-1 can be achieved at a 20-dB signal-to-noise power ratio relative to a normal monopulse system without the CA. It is also shown that the CA method is unbiased, giving bias improvements of as much as 100 times relative to normal monopulse. Evaluation of the assumptions in the technique shows very little sensitivity to knowledge of the reflecting surface's conductivity or dielectric constant. However, the method is somewhat sensitive to knowledge of surface roughness.     

Investigations of Stability & Dynamic Performances of a Current-Injected Regulator

The stability and dynamic performances of a buck/boost regulator employing a current-injected control are examined. Small-signal models for the power state, the multiloop error processor, and the duty-cycle pulse modulator are developed. The error-processor model which incorporates the current-injected loop, the dc loop, and the compensation network permits evaluation of the effects of each individual control loop and their combined efforts toward shaping the performance characteristics of the closed-loop system. Comparisons are made between this modeling approach and earlier approaches. Some important yet subtle dissimilarities are discussed. This model predicts the constant-frequency 50-percent duty-cycle instability which is inherent to the current-injected control.     

Review of flow control mechanisms of leading-edge vortices

Vortex control concepts employed for slender and nonslender delta wings were reviewed. Important aspects of flow control include flow separation, vortex formation, flow reattachment, vortex breakdown, and vortex instabilities. The occurrence and relative importance of these phenomena strongly depend on the wing sweep angle. Various flow control methods were discussed: multiple vortices, control surfaces, blowing and suction, low-frequency and high-frequency excitation, feedback control, passive control with wing flexibility, and plasma actuators. For slender delta wings, control of vortex breakdown is achieved by modifications to swirl level and external pressure gradient acting on the vortex core. Effects of flow control methods on these two parameters were discussed, and their effectiveness was compared whenever possible. With the high-frequency excitation of the separated shear layer, reattachment and lift enhancement in the post-stall region is observed, which is orders of magnitude more effective than steady blowing. This effect is more pronounced for nonslender wings. Re-formation of vortices is possible with sufficient amplitude of forcing at the optimum frequency. Passive lift enhancement on flexible wings is due to the self-excited wing vibrations, which occur when the frequency of wing vibrations is close to the frequency of the shear layer instabilities, and promote flow reattachment.     

An Automatic System for the Control of Multiple Drone Aircraft

A conceptual system is proposed and described for the control of a multiplicity of drone aircraft. Each target (drone) aircraft is controlled, during a given mission, over a separate preprogrammed path comprised of straight line and circular arc segments. Full control of each target's altitude, plan position, and velocity is available. Position measurement can be obtained by use of either a radar or a bilateration method where altitude is measured in either case by each aircraft and telemetered to a central control point. Velocity is obtained by smoothing position data in a central computer, which also controls the entire mission complex.     

Polish radar technology

Polish radar research and development since 1953 is reviewed, covering the development and production of surveillance radars, height finders, tracking radars, air traffic control (ATC) radars and systems, and marine and Doppler radars. Some current work, including an L-band ATC radar for enroute control, a weather channel for primary surveillance radar, signal detection in non-Gaussian clutter, adaptive MTI filters and postdetection filtering, and a basic approach to radar polarimetry, is examined.<>     

The Pre-CME Sun

The coronal mass ejection (CME) phenomenon occurs in closed magnetic field regions on the Sun such as active regions, filament regions, transequatorial interconnection regions, and complexes involving a combination of these. This chapter describes the current knowledge on these closed field structures and how they lead to CMEs. After describing the specific magnetic structures observed in the CME source region, we compare the substructures of CMEs to what is observed before eruption. Evolution of the closed magnetic structures in response to various photospheric motions over different time scales (convection, differential rotation, meridional circulation) somehow leads to the eruption. We describe this pre-eruption evolution and attempt to link them to the observed features of CMEs. Small-scale energetic signatures in the form of electron acceleration (signified by nonthermal radio bursts at metric wavelengths) and plasma heating (observed as compact soft X-ray brightening) may be indicative of impending CMEs. We survey these pre-eruptive energy releases using observations taken before and during the eruption of several CMEs. Finally, we discuss how the observations can be converted into useful inputs to numerical models that can describe the CME initiation.     

Observation of fundamental magnetoplasma emissions excited in magnetosphere by modulated electron beams

There were several cases when modulated electron beam had been injected from APEX satellite into an otherwise unmodified ionospheric plasma. The beams were formed from 2 μs pulses repeated at a rate of 40kHz. Injections took place in the altitude range 400–1100km over Europe. The onboard receiver connected to the dipole antenna swept the frequency interval 1–10 MHz in 1 sec. Due to a relatively narrow receiver bandwidth (15 kHz), moderate frequency step (50 kHz), slow changes of f_n and f_c (local electron plasma and gyro frequencies) fine structure of excited emissions was detected. In many cases, a very prominent doublet could be convincingly identified as a (f_n,f_u=sqrt(f_n^*f_n+f_c^*f_c)) band, with f_n practically equal to the local plasma frequency in the unperturbed ionosphere. Determination of plasma frequency is of prime importance in analysis of complex structures composed from various harmonics f_n,f_c,f_u. Complexity is manifested as coalescing of various harmonics with maxima shifted from nominal frequencies or splitting them into components due to mixing of local and propagation effects. Despite the existence of strong emissions on frequencies characteristic for the unperturbed ionosphere, very strong broadcasting transmissions are frequently cut off, even when the beam is directed upward. Most typical spectra are discussed.     

On Relationship of Flow Swirl Parameters and Gas-Dynamic Efficiency of Gas Turbine Engine Interturbine Transition Duct

The paper highlights significance of the interturbine transition duct as part of the high pressure and low pressure turbine spool. The correlations have been suggested allowing us to estimate variation of the average cross section flow swirl while its passing the interturbine transition duct.