多机并联火箭羽流流场及其底部热环境分析

For the problem that the plume flow field structure of a multi engine parallel rocket is complicated and the bottom thermal environment is extremely harsh, which may cause the failure of the engine structural components, the plume flow field and thermal environment at different altitudes are studied through numerical simulation. The result is compared with the measured results in flight which shows that when the rocket is flying at a low altitude, the plume of the engines do not interfere with each other. As the flight altitude increases, the plumes gradually expand and begin to interfere with each other, and finally there is an obvious backflow at the bottom of the rocket. The maximum heat flux at the moment of take off is basically the same as the measured value in flight. Before the backflow occurs, the heat flux mainly consists of radiant heat, the convective heat flow increases as the flight altitude grows, but it is also much smaller than the peak heat flow at takeoff. The result has certain guiding significance for the optimal design of engine structure thermal protection.     

Transonic buffet control research with two types of shock control bump based on RAE2822 airfoil

Current research shows that the traditional shock control bump (SCB) can weaken the intensity of shock and better the transonic buffet performance.The author finds that when SCB is placed downstream of the shock,it can decrease the adverse pressure gradient.This may prevent the shock foot separation bubble to merge with the trailing edge separation and finally improve the buffet performance.Based on RAE2822 airfoil,two types of SCB are designed according to the two different mechanisms.By using Reynolds-averaged Navier-Stokes (RANS) and unsteady Reynolds-averaged Navier-Stokes (URANS) methods to analyze the properties of RAE2822 airfoil with and without SCB,the results show that the downstream SCB can better the buffet performance under a wide range of freestream Mach number and the steady aerodynamics characteristic is similar to that of RAE2822 airfoil.The traditional SCB can only weaken the intensity of the shock under the design condition.Under the off-design conditions,the SCB does not do much to or even worsen the buffet performance.Indeed,the use of backward bump can flatten the leeward side of the airfoil,and this is similar to the mechanism that supercritical airfoil can weaken the recompression of shock wave.     

电子接插件在线质量检测研究

近年来,电子信息产业的迅猛发展,作为配套支持的接插件的生产规模也不断扩大。由于电子设备厂商对接插件的质量要求越来越高,接插件的检测也得到了越来越多的重视。由于检测速度快、运行稳定可靠的特点,机器视觉检测技术被广泛用于对接插件外观质量的在线检测。本文应用机器视觉检测技术对电子接插件质量进行了在线检测研究,并以其典型的冲压质量缺陷的检测为例对机器视觉在线检测系统的构成、核心处理模块、应用中存在的问题以及解决问题的新方法进行阐述,最后针对系统的可靠性进行了分析。     

High temporal resolution global PWV dataset of 2005–2016 by using a neural network approach to determine the mean temperature of the atmosphere

Atmospheric water vapour plays an important role in phenomena related to the global hydrologic cycle and climate change. However, the rapid temporal–spatial variation in global tropospheric water vapour has not been well investigated due to a lack of long-term, high-temporal-resolution precipitable water vapour (PWV). Accordingly, this study generates an hourly PWV dataset for 272 ground-based International Global Navigation Satellite System (GNSS) Service (IGS) stations over the period of 2005–2016 using the zenith troposphere delay (ZTD) derived from global-scale GNSS observation. The root mean square (RMS) of the hourly ZTD obtained from the IGS tropospheric product is approximately 4 mm. A fifth-generation reanalysis dataset of the European Centre for Medium-range Weather Forecasting (ECMWF ERA5) is used to obtain hourly surface temperature (T) and pressure (P), which are first validated with GNSS synoptic station data and radiosonde data, respectively. Then, T and P are used to calculate the water vapour-weighted atmospheric mean temperature (Tm) and zenith hydrostatic delay (ZHD), respectively. T and P at the GNSS stations are obtained via an interpolation in the horizontal and vertical directions using the grid-based ERA5 reanalysis dataset. Here, Tm is calculated using a neural network model, whereas ZHD is obtained using an empirical Saastamoinen model. The RMS values of T and P at the collocated 693 radiosonde stations are 1.6 K and 3.1 hPa, respectively. Therefore, the theoretical error of PWV caused by the errors in ZTD, T and P is on the order of approximately 2.1 mm. A practical comparison experiment is performed using 97 collocated radiosonde stations and 23 GNSS stations equipped with meteorological sensors. The RMS and bias of the hourly PWV dataset are 2.87/?0.16 and 2.45/0.55 mm, respectively, when compared with radiosonde and GNSS stations equipped with meteorological sensors. Additionally, preliminary analysis of the hourly PWV dataset during the EI Niño event of 2014–2016 further indicates the capability of monitoring the daily changes in atmospheric water vapour. This finding is interesting and significant for further climate research.     

Particle swarm optimization applied to hypersonic reentry trajectories

This paper presents the novel use of the particle swarm optimization(PSO)to generate the end-to-end trajectory for hypersonic reentry vehicles in a quite simple formulation.The velocitydependent bank angle profile is developed to reduce the search space of unknown parameters based on the constrained PSO algorithm.The path constraints are enforced by setting the fitness function to be infinite on condition that the particles violate the maximum allowable values.The PSO algorithm also provides a much easier means to satisfy the terminal conditions by adding penalty terms to the fitness function.Furthermore,the approximate reentry landing footprint is fast constructed by incorporating an interpolation model into the standardized bank angle profiles.Numerical simulations demonstrate that the PSO method is a feasible and flexible tool to generate the end-to-end trajectory and landing footprint for hypersonic reentry vehicles.     

无源滤波器频率漂移的一种迭代算法

文章介绍了无源滤波器在试验过程中产生的典型幅频特性漂移曲线，并针对这些典型曲线提出了基于均方误差最小原则和牛顿迭代的频率漂移算法。     

卷簧式浅层月壤取样器设计及动力学分析

面向浅层月壤取样,文章设计了新颖的卷簧式可伸缩小型月壤取样器,它包括柔性取样臂和振动式取样头。对取样器进行了动力学有限元分析,研究了取样臂为不同长度时取样头的振动模态及频率响应,得出取样臂一阶横振频率与取样臂长度呈负幂函数关系;对取样器测控系统进行了振动试验,通过扫频方式测量取样臂为不同长度时的自振频率,给出了取样臂长...     

基于层次评估理论的弹道导弹末段突防制导律研究

针对弹道导弹末段突防问题,应用层次性能评估体系,对弹道导弹末段典型突防制导律进行对比分析.并通过对弹道导弹制导精度、弹道导弹最大过载、弹道飞行时间和反导导弹脱靶量以及它们的均值、均方差的重要性和需求性分析,合理设置评估体系的指标及其权值,应用随机仿真分析方法,对比仿真经典比例导引、修正比例导引和变结构比例导引三种突防制导律的性能.仿真结果证明,层次评估理论可以用于弹道导弹末段突防制导律的评估及优选.     

叶片反扭对跨声速大涵道比风扇性能的影响

使用基于流固耦合算法的叶片反扭程序,考虑了非定常气动力对叶片变形的非线性作用,研究了叶片反扭对跨声速大涵道比风扇性能的影响.以冷态叶型为起点,先计算离心力作用下的叶片变形,在此基础上使用流固耦合程序获得非定常气动力作用下的变形.考察了3个转速下叶片的动态变形对大涵道比风扇气动性能的影响.结果表明:在跨声速工况下,叶片表面激波位置的变化对叶片反扭角有很大作用,在考察的转速范围内,堵塞点使用设计叶型计算的流量大于动态叶型下的流量,数值达7%,将导致发动机起飞推力小于预测值.结果表明在大涵道比风扇设计阶段,预测气动性能使用准确叶型的重要性.      

预燃式等离子体射流点火器工作特性实验研究

为解决发动机点火包线小于飞行包线的实际问题,提供等离子体点火技术在航空发动机中的工程应用新思路,论文设计了一种预燃式等离子体射流点火器,实验研究了放电特性和射流特性。结果表明,预燃式等离子体射流点火器与空气等离子体射流点火器相比,在提升射流能量降低电源功率方面有着较大的优势,电流相同时通入甲烷在较大流量时可减小驱动电源功率,总流量为44L/min时,减幅可达14.99%;同时预燃式等离子体射流较空气等离子体射流稳定,且射流长度增加,扩大了点火面积,有利于点火。