Reconfigurable dual feed antenna for direct broadcast satellites

Direct Broadcast Satellites covering large countries such as Canada, require more than one spacecraft, located at different orbital positions, as well as the use of multiple shaped beams. This would minimize eclipse requirements over several time zones, provide increased capacity by frequency reuse and permit the use of cost effective ground receivers.Two such satellites are envisaged, one covering Eastern Canada, the other Western Canada, using two different sets of three highly shaped beams. This paper is the result of a feasibility study of a satellite antenna designed such that while at either orbital location it can be reconfigured in orbit, by ground command and hence can save the cost of one additional spare spacecraft.An offset parabolic reflector is proposed for the 12 GHz downlink, with a switched “dual feed” structure, consisting of two separate but contiguous sets of pyramidal horns and their associated beam forming networks (BFN). Only one BFN set is used at any one orbital location. Detailed radiation patterns demonstrate good beamshaping capabilities, with coverage efficiencies of the order of 94%. Other considerations such as the effect of orbital locations, gain equalization and TWTA standardization are discussed.It is concluded that a satellite, reconfigurable in orbit with a “dual feed” antenna, is feasible and cost effective, for a DBS spare as well as for the main spacecraft.     

Order of magnitude analysis of convective effects in dendritic solidification

The different types of convective phenomena which may occur during the dendritic solidification of metallic alloys are discussed from an order of magnitude analysis. Bulk thermal convection and/or interdendritic solutal convection have to be considered according to the values of the experimental data. Scaling laws for the solute boundary layer resulting from bulk thermal convection have already been derived. It is shown here that the interdendritic flow depends on a solutal Grashof number Gr based on the horizontal density gradient and a characteristic length L_s which is of the order of the liquid channels width. For Gr < 1, which is generally verified in practical cases, the interdendritic flow velocity U_r is proportional to the Grashof number. This a priori law compares favorably with the results of horizontal solidification experiments where the mean interdendritic flow velocity has been estimated from the resulting measured macrosegregation. In these experiments, as well as for most horizontal dendritic solidifications of metallic alloys at 1 g, the ratio $\text{U}{}_{\mathrm{r}}\text{R}$ (R is the growth rate) is of order one. In order to cancel the interdendritic flow effects, this ratio has to be lowered by one order of magnitude. According to our analysis, this can be obtained by performing the experiments either at a slightly reduced g level (～10^?1 g), or at 1 g in a vertical stable configuration with a sufficiently low residual horizontal thermal gradient.     

A new method of determining the spectral index for protons in the energy range about 10<Superscript>13</Superscript> eV

We consider a relationship between the difference in spectral indices of the spectra of single hadrons and all hadrons (_sngl – _h) and the difference in the indices of the spectra of galactic cosmic ray (GCR) protons and nuclei. It is demonstrated that at the mountain level the ratio (_p – _Z)/(_sngl – _h) is always larger than unity, if (_sngl – _h) > 0.1. From the experimental value _sngl – _h = 0.4 ± 0.05 we derive that, in the vicinity of E = 10 TeV, _p – _Z 0.49 ± 0.06 , i.e., _p 3.09 ± 0.06.__________Translated from Kosmicheskie Issledovaniya, Vol. 43, No. 2, 2005, pp. 83–87.Original Russian Text Copyright © 2005 by Grigorov, Tolstaya.     

Instrumentenentwicklungen für anwendungsaufgaben der fernerkundung photogrammetrie,geophysik und geodäsie

(Instrument Developments for Applications in Remote Sensing, Photogrammetry, Geophysics and Geodesy) The Modular Optoelectronic Multispectral Seanner MOMS-01, a CCD camera using the push-broom scanner principle, is presented in this paper in its flight configuration. This instrument will be the first European-built spaceborne unaging system for remote sensing applications (launch with Shuttle flight No. 7).Follow-on developments of this initial two-channel version are oriented to an extension of capabilities by a panchromatic high-resolution stereoscopic module for thematic mapping and two additional spectral channels in the reflective IR (up to 2.3 μm) offering a high interpretation potential for future earth resources exploration missions. Furthermore the subjects of advanced laser technology studies are introduced: A picosecond pulse laser system for detection of tectonic motions and for geodetic application, a CO laser for ultra precise range rate determination (Earth potential and Geoid) and a laser range finder for intersatellite distance measurements.     

SIGMA observations of hard X-ray and soft gamma-ray emission from X-ray binaries

After more than two years of operation, the imaging γ-ray SIGMA telescope has accumulated several days of observation toward well known X-ray binaries. Four bright sources falling in this category have been detected so far: The pulsar GX 1+4 near the center of our galaxy, the stellar wind accreting system 4U 1700-377, and the black hole candidates Cygnus X-1 and GX 339-4. Moreover, SIGMA have observed three transients sources, which turned out to be also hard X-ray sources : The burster KS 1731-260, Tra X-1, and the Musca Nova. The properties of these systems in the SIGMA domain will be reviewed and a spectral distinction between black holes and neutron stars will be sketched.     

Matched Filter Criteria and Range Weighting for Weather Radar

The effective weighting function for weather radar is defined. This weighting function considers the effects of both the transmitted signal and the receiver filter. It is used to assign effective ranges to samples taken at prescribed times. For uniformly distributed targets it is shown that "signal"-to-noise ratio depends on the receiver filter, transmitted signal envelope, and receiver noise spectral density. Maximization of this signal-to-noise ratio when range resolution constraints are imposed is discussed, and a receiver design approach specifically adapted for Doppler weather radars is developed.     

Planetary Accumulation with a Continuous Supply of Planetesimals

Previous calculations of the accumulation of small (∼10 km) planetesimals at ∼1 AU to form Mars-sized bodies assumed that the initial assemblage of planetesimals were all present at the outset. This is an obviously reasonable assumption in systems in which the time scale for growth time of ∼10²⁶ g planetary bodies is long compared to estimates of the evolutionary time scale of a protosolar disk, as was the case in the pioneering work of Safronov (1969). It is now found that as a result of the preplanetary assemblage being unstable with respect to the runaway growth of the largest bodies, this is unlikely to be the case. The more realistic alternative of adding the initial planetesimals on a ∼10⁵ year time scale is considered here, as well as the consequences of the initial planetesimals being considerably smaller than those assumed previously. It is found that although the time scale for runaway growth is now actually controlled by the availability of planetesimals, for planetesimal production time scales of ∼10⁵ yrs, the final consequences are very similar. These calculations do show, however, that as a consequence of continuous infall during the runaway growth process, the late initial planetesimals are likely to be catastrophically disrupted by mutual collisions. For this reason, a more detailed treatment of the growth of planetesimals into planetary embryos will require a better understanding of the difficult problem of formation of the initial planetesimals themselves. This revised version was published online in June 2006 with corrections to the Cover Date.     

Europa planetary protection for Juno Jupiter Orbiter

NASA’s Juno mission launched in 2011 and will explore Jupiter and its near environment starting in 2016. Planetary protection requirements for avoiding the contamination of Europa have been taken into account in the Juno mission design. In particular Juno’s polar orbit, which enables scientific investigations of parts of Jupiter’s environment never before visited, also greatly assist avoiding close flybys of Europa and the other Galilean satellites.     

Removing orbital debris with lasers

Orbital debris in low Earth orbit (LEO) are now sufficiently dense that the use of LEO space is threatened by runaway collision cascading. A problem predicted more than thirty years ago, the threat from debris larger than about 1 cm demands serious attention. A promising proposed solution uses a high power pulsed laser system on the Earth to make plasma jets on the objects, slowing them slightly, and causing them to re-enter and burn up in the atmosphere. In this paper, we reassess this approach in light of recent advances in low-cost, light-weight modular design for large mirrors, calculations of laser-induced orbit changes and in design of repetitive, multi-kilojoules lasers, that build on inertial fusion research. These advances now suggest that laser orbital debris removal (LODR) is the most cost-effective way to mitigate the debris problem. No other solutions have been proposed that address the whole problem of large and small debris. A LODR system will have multiple uses beyond debris removal. International cooperation will be essential for building and operating such a system.