The effect of the magnetizing inductance on the small-signaldynamics of the isolated Cuk converter

The magnetizing inductance of the isolated Cuk converter introduces an undesirable pair of closely spaced complex zeros and poles, or a glitch, in the control-to-output transfer function. Limited analysis and experimentation in the past have shown that sufficient increase in the magnetizing inductance or manipulation of the ratio of the capacitances of the energy transfer capacitors can reduce the glitch. In this work, the isolated Cuk converter with coupled input and output inductors has been studied and the dependence of the glitch on various circuit parameters has been determined analytically. A condition has been derived for the ratio of the capacitances of the two energy transfer capacitors which completely eliminates the glitch at a given operating point. With this condition satisfied, it is shown that the energy transfer capacitors can be easily damped by a simple RC network to eliminate the glitch from a wide range of operation about an operating point     

To Calculation of Regenerative Cooling of a Liquid Fuel Rocket Engine Chamber

This paper demonstrates that in transition from the one-dimensional longitudinal-channel motion of the coolant in the regenerative cooling system of the liquid propellant engine to the twodimensional (interchannel) channel motion (transpiration) through a porous mesh material (PMM), the hydraulic losses decrease. Experimental data on PMM hydraulic resistance coefficients and heat transfer in porous paths with the interchannel coolant transpiration (ICCT) is presented.     

The OSIRIS-REx Thermal Emission Spectrometer (OTES) Instrument

The OSIRIS-REx Thermal Emission Spectrometer (OTES) will provide remote measurements of mineralogy and thermophysical properties of Bennu to map its surface, help select the OSIRIS-REx sampling site, and investigate the Yarkovsky effect. OTES is a Fourier Transform spectrometer covering the spectral range 5.71–100 μm (\(1750\mbox{--}100~\mbox{cm}^{-1}\)) with a spectral sample interval of \(8.66~\mbox{cm}^{-1}\) and a 6.5-mrad field of view. The OTES telescope is a 15.2-cm diameter Cassegrain telescope that feeds a flat-plate Michelson moving mirror mounted on a linear voice-coil motor assembly. A single uncooled deuterated l-alanine doped triglycine sulfate (DLATGS) pyroelectric detector is used to sample the interferogram every two seconds. Redundant ～0.855 μm laser diodes are used in a metrology interferometer to provide precise moving mirror control and IR sampling at 772 Hz. The beamsplitter is a 38-mm diameter, 1-mm thick chemical vapor deposited diamond with an antireflection microstructure to minimize surface reflection. An internal calibration cone blackbody target provides radiometric calibration. The radiometric precision in a single spectrum is \(\leq2.2 \times 10^{-8}~\mbox{W}\,\mbox{cm}^{-2}\,\mbox{sr} ^{-1}/\mbox{cm}^{-1}\) between 300 and \(1350~\mbox{cm}^{-1}\). The absolute integrated radiance error is \(<1\%\) for scene temperatures ranging from 150 to 380 K. The overall OTES envelope size is \(37.5 \times 28.9 \times 52.2~\mbox{cm}\), and the mass is 6.27 kg. The power consumption is 10.8 W average. OTES was developed by Arizona State University with Moog Broad Reach developing the electronics. OTES was integrated, tested, and radiometrically calibrated on the Arizona State University campus in Tempe, AZ.     

The Rotation and Interior Structure Experiment on the InSight Mission to Mars

The Rotation and Interior Structure Experiment (RISE) on-board the InSight mission will use the lander’s X-band (8 GHz) radio system in combination with tracking stations of the NASA Deep Space Network (DSN) to determine the rotation of Mars. RISE will measure the nutation of the Martian spin axis, detecting for the first time the effect of the liquid core of Mars and providing in turn new constraints on the core radius and density. RISE will also measure changes in the rotation rate of Mars on seasonal time-scales thereby constraining the atmospheric angular momentum budget. Finally, RISE will provide a superb tie between the cartographic and inertial reference frames. This paper describes the RISE scientific objectives and measurements, and provides the expected results of the experiment.     

Concepts of Gas Turbine Engine Improvement Through the Use of Choked-Flow Turbines

The new conceptual design of simple gas turbine engines for different purposes is presented. A choked-flow low-pressure turbine is used that allows reducing the number of stages and gas temperature in the relative motion ahead of blades. Application of such turbines with uncooled blades to reduce the cost of power-limited engines is considered.     

Influence Analysis of the Second Bypass Air Bleed Parameters on the Engine Performance

This paper considers double bypass aircraft engine with controlled air bleed to the second bypass duct. Its performance is evaluated by mathematical modeling techniques. The second bypass air bleed amount is determined to provide the best engine efficiency at various operating modes.     

3D Investigations of the High Pressure Turbine Vane Platform Convection Cooling and Convection-Film Cooling

3D ANSYS CFX conjugate calculation was carried out to compare cooling effectiveness of the high pressure turbine vane platforms with the film cooling and the convection-film cooling.     

Disaster assessment and satellite communication: on the threshold of a new era

Disaster events have always been with us. Success or failure of a disaster response is often determined by timely access to communication and the exchange of reliable information. Especially, crucial is information acquired by on-site first responders responsible for initial disaster assessment. The rapid progress in satellite communication development is laying a foundation for a future where lack of communications will no longer be a limiting or paralyzing factor in disaster response. This paper discusses emerging satellite communications tools that can enhance on site assessment and change the way disaster management is viewed and carried out in the next century.     

The dynamics of blood biochemical parameters in cosmonauts during long-term space flights

Most of the previously obtained data on cosmonauts' metabolic state concerned certain stages of the postflight period. In this connection, all conclusions, as to metabolism peculiarities during the space flight, were to a large extent probabilistic. The purpose of this work was study of metabolism characteristics in cosmonauts directly during long-term space flights. In the capillary blood samples taken from a finger, by "Reflotron IV" biochemical analyzer, "Boehringer Mannheim" GmbH, Germany, adapted to weightlessness environments, the activity of GOT, GPT, CK, gamma-GT, total and pancreatic amylase, as well as concentration of hemoglobin, glucose, total bilirubin, uric acid, urea, creatinine, total, HDL- and LDL cholesterol, triglycerides had been determined. HDL/LDL-cholesterol ratio also was computed. The crewmembers of 6 main missions to the "Mir" orbital station, a total of 17 cosmonauts, were examined. Biochemical tests were carried out 30-60 days before launch, and in the flights different stages between the 25-th and the 423-rd days of flights. In cosmonauts during space flight had been found tendency to increase, in compare with basal level, GOT, GPT, total amylase activity, glucose and total cholesterol concentration, and tendency to decrease of CK activity, hemoglobin, HDL-cholesterol concentration, and HDL/LDL - cholesterol ratio. Some definite trends in variations of other determined biochemical parameters had not been found. The same trends of mentioned biochemical parameters alterations observed in majority of tested cosmonauts, allows to suppose existence of connection between noted metabolic alterations with influence of space flight conditions upon cosmonaut's body. Variations of other studied blood biochemical parameters depends on, probably, pure individual causes.