Structure of the Venusian atmosphere from surface up to 100 km

The goal of this paper is to summarize the experimental data on the atmosphere of Venus obtained after 1985, when the VIRA (Venus International Reference Atmosphere) or COSPAR model was published. Among the most important results that have appeared since then are the following: measurements of the vertical temperature profile by the VEGA spacecraft with high precision and high altitude resolution; measurements made with balloons of the VEGA spacecraft; radio occultation measurements of Magellan, Venera-15, and Venera-16; and temperature profiles derived from the data of infrared spectrometry obtained by Venera-15. The new result as compared to VIRA is the creation of a model of the atmosphere in the altitude range 55 to 100 km dependent on local time. This model is presented in our paper in tabulated form.     

Satellite mobile communications spread-spectrum receiver

Since 1999, ESA has conducted a number of system studies and technological developments to support the European and Canadian industry in the definition of a Satellite UMTS (S-UMTS) component development strategy, identifying critical technological areas and promoting S-UMTS demonstrations. In particular, the MUSIC project has successfully demonstrated advanced digital signal processing techniques to mitigate CDMA interference in spread-spectrum receivers, thus increasing the capacity and/or quality of service of a wireless communication network. The low-complexity solution for interference mitigation investigated and developed in the project is particularly suited for being implemented in mobile terminals.     

Effects of spaceflight (STS-87) on tropisms and plastid positioning in protonemata of the moss Ceratodon purpureus.

Apical cells of moss protonemata represent a single-celled system that perceives and reacts to light (positive and negative phototropism) and to gravity (negative gravitropism). Phototropism completely overrides gravitropism when apical cells are laterally irradiated with relatively high red light intensities, but below a defined light intensity threshold gravitropism competes with the phototropic reaction. A 16 day-long exposure to microgravity conditions demonstrated that gravitropism is allowed when protonemata are laterally illuminated with light intensities below 140 nmol m-2s-1. Protonemata that were grown in darkness in microgravity expressed an endogenous tendency to grow in arcs so that the overall culture morphology resembled a clockwise spiral. However this phenomenon only was observed in cultures that had reached a critical age and/or size. Organelle positioning in dark-grown apical cells was significantly altered in microgravity. Gravisensing most likely involves the sedimentation of starch-filled amyloplasts in a well-defined area of the tip cell. Amyloplasts that at 1-g are sedimented were clustered at the apical part of the sedimentation zone in microgravity. Clustering observed in microgravity or during clino-rotation significantly differs from sedimentation-induced plastid aggregations after inversion of tip cells at 1-g.     

The influence of dose, dose-rate and particle fragmentation on cataract induction by energetic iron ions.

Because activities in space necessarily involve chronic exposure to a heterogeneous charged particle radiation field it is important to assess the influence of dose-rate and the possible modulating role of heavy particle fragmentation on biological systems. Using the well-studied cataract model, mice were exposed to plateau 600 MeV/amu 56Fe ions either as acute or fractionated exposures at total doses of 5 - 504 cGy. Additional groups of mice received 20, 360 and 504 cGy behind 50 mm of polyethylene, which simulates body shielding. The reference radiation consisted of 60Co gamma radiation. The animals were examined by slit lamp biomicroscopy over their three year life spans. In accordance with our previous observations with heavy particles, the cataractogenic potential of the 600 MeV/amu 56Fe ions was greater than for low-LET radiation and increased with decreasing dose relative to gamma-rays. Fractionation of a given dose of 56Fe ions did not reduce the cataractogenicity of the radiation compared to the acute regimen. Fragmentation of the beam in the polyethylene did not alter the cataractotoxicity of the ions, either when administered singly or in fractions.     

Stellar infrared astronomy with EDISON

In this review the IR emission from circumstellar material is discussed, both of ionized gas and dust grains, and the astrophysical information that can be extracted from such observations. Some emphasis is placed on the possibilities of stellar IR astronomy using a large space-borne telescope, especially with respect to the much better spatial and spectral resolution of such a telescope compared to the current generation of ground-based and space IR telescopes.     

Lower and upper limits to comet p/halley solid material loss rate

A radiative hydrodynamic model of comet P/Halley is used to investigate quantitatively the constraints imposed onto the Comet loss rate in solids by both the in-situ data and the remote sensing data. In particular, for the first time, the in-situ data are used to fit composite spectra extending from near-IR wavelengths to the microwave region. Also, for the first time the uncertainty affecting the ejection velocity of large grains is taken into account. The results suggest that only future rendez-vous studies of the grain density in the vicinity of a comet would be able to provide definitely reliable values of the comet loss rate.     

The INFRARED SPACE OBSERVATORY (ISO)

The INFRARED SPACE OBSERVATORY (ISO), a project of the European Space Agency (ESA), will make various astronomical observations in the wavelength range of 2 to 200 μm. Two-thirds of its observing time will be available to guest observers via the traditional route of proposal submission. ISO will be launched in 1995 by an Ariane 4 from Kourou (Guyana) and be brought into a very elongated orbit with a 24hr period of which 16 hr can be used for astronomical observations. The payload module is essentially a large cryostat with a tank that will be filled with over 2000 litres of superfluid helium to keep the instruments cold (2 to 4 K) during an expected lifetime of 18 months. Inside the dewar, there is a Ritchey-Chretien telescope with a primary mirror of diameter 60cm. Four instruments, each provided by a different PI consortium, share the ISO focal plane. These instruments are : a photometer, a camera and two spectrometers — one for the wavelength range 2–45 μm and the other for 45–180 μm.     

A bioreactor system for the nitrogen loop in a Controlled Ecological Life Support System.

As space missions become longer in duration, the need to recycle waste into useful compounds rises dramatically. This problem can be addressed by the development of Controlled Ecological Life Support Systems (CELSS) (i.e., Engineered Closed/Controlled Eco-Systems (ECCES)), consisting of human and plant modules. One of the waste streams leaving the human module is urine. In addition to the reclamation of water from urine, recovery of the nitrogen is important because it is an essential nutrient for the plant module. A 3-step biological process for the recycling of nitrogenous waste (urea) is proposed. A packed-bed bioreactor system for this purpose was modeled, and the issues of reaction step segregation, reactor type and volume, support particle size, and pressure drop were addressed. Based on minimization of volume, a bioreactor system consisting of a plug flow immobilized urease reactor, a completely mixed flow immobilized cell reactor to convert ammonia to nitrite, and a plug flow immobilized cell reactor to produce nitrate from nitrite is recommended. It is apparent that this 3-step bioprocess meets the requirements for space applications.     

New instrumentation for optical measuring of oxygen in gas or dissolved in liquids.

The optical oxygen sensor is a novel device for the determination of oxygen in gases or dissolved in liquids. It is based on the measurement principle of fluorescence quenching, which is completely different from that of polarographic oxygen sensors (today the most widespread devices of oxygen detection). The new instrument offers features and advantages, which render it not only a realistic alternative, but, for specific applications, make it superior to existing electrochemical methods. The system is based on low-cost semiconductor devices (light-emitting diodes, photodiodes, low-cost analogue and digital components) and new LED-compatible oxygen-sensitive membranes. The flow cell of the instrument may be thermostatted and the sensor can be calibrated by a simple two-point calibration procedure. The optical oxygen sensor is particularly suitable for measuring dissolved oxygen in respirometry, since no oxygen is consumed by the device and the signal is independent of sample flowrate or stirring speed. Typical fields of application are monitoring of oxygen in ground and drinking water, in process control in bioreactors and in breath gas and blood gas analysis.     

Nanotechnology-based molecular test equipment (MTE)

This paper describes original research efforts in the design, simulation, and development of nanotechnology-based molecular test equipment (MTE). This is a research effort for testing printed circuit boards independent of traditional automatic test equipment (ATE) through the fabrication of MTE within integrated circuits (ICs). The MTE is embedded within the IC substrate and encapsulated within nanoprobes that connect between the surface and the substrate of the IC at various functional areas. A process is followed whereby IC device simulation is performed to assess the electrical, chemical, and structural properties of integrated and adjacent substrate devices. Through this approach the nominal and failed device performance parameters of interest to substrate-based MTE are found. Discussion of the development and application of MTE within IC architectures is provided, including such topics as the effect of substrate composition on the design and realization of MTE, interfaces between MTE and IC devices, and reporting of MTE results to the IC surface and technician. Potential application areas within different device functions will also be identified. A chemical structure diagram is also provided to illustrate the implementation of MTE using discrete device configurations with MTE-augmented logic